JOLIN NEXUM Smart Cable Tester User Guide
- June 12, 2024
- JOLIN
Table of Contents
JOLIN NEXUM Smart Cable Tester User Guide
Hi fellow!
Just a quick intro before starting,
what to have on hand
- Soldering Iron – better with temperature control
- . Solder wire
- . Multimeter
- . Solder sucker / wick (optional)
- Silicone soldering mat (optional)
- . Helping hands (optional)
- Flux (optional)
If you want to refresh yourself a bit about soldering stuff you can watch this
video1 by GreatScott!
A tool that can help you placing the components on the boards is the
interactive bill of materials.
Download the .html ibom file and open it with a browser. You can use it to
check where a component is located on the board.
Once downloaded it works fine also offline.
Here are listed all the NEXUM components, most of them are already pre-
soldered on the board.
We just need to solder the through hole ones (THT).
BE CAREFULL NOT TO TOUCH THE SMD COMPONENTS WHILE SOLDERING THE THT ONES.
It’s really easy to lose a tiny resistor or capacitor. Be careful when
soldering parts that are close to others already in place
power 2×5 pin header
Place the socket matching the drawing on the PCB. tip: solder one pin and check. If the socked is aligned with the PCB solder all the other pins
1 | J7 | EURORACK_HEADER |
---|
ok, now flip the board.
**jack sockets**
Place the socket matching the drawing on the PCB.
2 | J14, J16 | Mono_PJ301BM |
---|---|---|
2 | J15, J17 | Stereo_PJ366ST |
check if everything is in place and properly soldered
done! enjoy your new
NEXUM
find us: web Þ www.jolin.tech
e-mail Þ info@jolin.tech build group Þ JolinLab
– STUFF Instagram Þ
@jolinlab
Youtube Þ ?
Read More About This Manual & Download PDF:
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>