Current Albeo ABV Series Modular High and Low Bay Lighting LED Luminaire Installation Guide
- June 12, 2024
- current
Table of Contents
Albeo® LED Luminaire
Modular High & Low Bay Lighting
(ABV-Series)
Installation Guide
ALB062
Features
- 5 year warranty
- Damp location rated
BEFORE YOU BEGIN
Read these instructions completely and carefully.
WARNING
RISK OF ELECTRIC SHOCK
- Turn power off before inspection, installation or removal.
- Properly ground electrical enclosure.
RISK OF FIRE
- Follow all NEC and local codes.
- Use only UL or IEC approved wire for input/output connections. Minimum size 18 AWG.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. CAN ICES-005 (A) /
NMB-005 (A).
This equipment has been tested and found to comply with the limits for a Class
A digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference when
the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own expense.
Save These Instructions
Use only in the manner intended by the manufacturer. If you have any
questions, contact the manufacturer.
NOTE: Contact the manufacturer for details and limitations when seeking
to incorporate this product with an emergency system other than Battery
Backup.
NOTE: CONTACT FACTORY for details and limitations when seeking to
incorporate this product with an emergency system other than Battery Backup.
Prepare Electrical Wiring
Electrical Requirements
The LED driver must be supplied with 120-480 VAC, 50/60 Hz per product label
and connected to an individual properly grounded branch circuit, protected by
a 15 or 20 ampere circuit breaker.
Grounding Instructions
The grounding and bonding of the overall system shall be done in accordance
with National Electric Code (NEC) Article 600 and local codes.
For 347/480v
only see below steps in opening box.
For 120/277V follow same steps in accessing Knock Out plate for
wiring.
| N | White 2 |
|---|---|
| **** | Green 3 |
| +DIM | Violet/White Stripe |
| -DIM | Pink |
| L (unswitch) | Black |
| L (switch) | Red |
| White | Black |
| --- | --- |
Troubleshooting
| Symptom | Solution |
|---|---|
| Luminaire will not turn on | • Check that the color of the supply side wires |
match the color of the wires they are connected to.
• Check that all wire connectors are properly connected.
• Verify that your input voltage is within specs.
• If you are using any additional controls (i.e. wireless controls/motion
sensors), please also verify that those are working properly and that the unit
is setup to interface with the controllers.
LED.com
© 2023 Current Lighting Solutions, LLC. All rights reserved. Information and
specifications subject to
change without notice. All values are design or typical values when measured
under laboratory conditions.
(Rev 05/04/23)
ALB062-Albeo-ABV-Series-Installation-Guide
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>