23ZERO Saber Hardtop Rooftop Tent Installation Guide
- June 12, 2024
- 23ZERO
Table of Contents
Saber Hardtop Rooftop Tent
Saber Hardtop Rooftop Tent
TOOLS REQUIRED :
- Tape Measure or Ruler
- Marker
- Centre Punch
- Power Drill
- 5mm Drill Bit
- Suited Rivet Gun
- Eye Protection
SABER ROPE TRACK INSTALLATION
-
Using a tape measure / ruler mark and centre punch the sections 15mm from either side.
-
Mark and centre punch centre of section at 200 mm.
( Tip: the section face will have three distinctive grooves along the pro le – to assist in aligning holes to be drilled mark on the centre groove )
-
Secure the section adequately.
-
Ensure you are wearing eye protection .
-
Using a 5 mm drill bit carefully drill all three marks on both sections.
-
Carefully drill all three marked holes .
( Ensure drill bit does not protrude further than 30 mm )
-
Your bracket should look like this with three drilled holes marked at 15mm each side and central at 200mm.
-
At the main rear entry of tent align the edge of the section where corner of tent pro le meets aluminium base pro le ( see pic )
-
Measure approx 12 mm down on the front edge of the tent pro le seam ( see pic )
-
Mark transfer and centre punch all three holes to tent to prole.
-
Using rivet gun insert and x provided rivets
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>