Claber Aquauno Eco Logic User Manual
- June 12, 2024
- claber
Table of Contents
Claber Aquauno Eco Logic
TECHNICAL DATA
- Power supply
- 1x 6RL61
- 9 VOLT
- alkaline
- The average life of the battery
- 1-Year
- Operating temp.
- 3 – 50 °C
- Operating pressure Press.
- MIN: 0,5 bar
- MAX: 10 bar
- Plastic materials
-
ABS< – >PC<
-
POM< – >TPE<
-
- Water pressure table
- Bar
- 0,5
- 1
- 2
- 2,5
- 3
- 4
- 5
- l/min
- 14
- 19
- 27
- 30
- 33
- 38
- 42
GENERAL INFORMATION
Always keep the cover closed
Use water from the mains tap or filter the water before using it
DESCRIPTION
- Inspectable and washable filter
- 3/4” F tap connector
- Ring nut
- Control rotary knob
- Control rotary knob
- 1/2″ threaded male connector
- Quick-Click male connector
BATTERY REPLACEMENT
Turn the control rotary knob to “OFF”, replace the battery and reprogramme the timer. Only use new 9 V Alkaline 6LR61 batteries, with an expiry date exceeding one year and that have never been used. Replace the battery at the beginning of each season. When the battery is completely flat, the water timer automatically stops its functions and closes the valve. Never replace the battery during irrigation, otherwise the water will continue to flow at the end of the cycle.
INSTALLATION
Do not install the water timer inside valve boxes, below ground level or indoors. Do not use the water timer with operating pressures lower than 0.5 bar (7.2 psi) or higher than 10 bar (145 psi).
MAINTENANCE
WARNING – RECOMMANDATIONS
- Read this instruction manual carefully and keep it handy for future reference. This device has been designed and manufactured exclusively for the setting of watering time by adults with experience and knowledge.
- Any use other than that described in this manual is considered improper: the manufacturer acknowledges no liability for damages arising from improper use, which will also void the warranty.
- Do not power the water timer with sources other than those specified.
- It is good policy – when the water timer is used for the first time – to make certain that the programmes run correctly.
- Do not use the water timer with chemicals or liquids other than water.
DISPOSAL
The symbol in question applied to the product or the packaging indicates
that the product must not be considered as normal domestic waste, but must be
taken to a special centre for the collection and recycling of waste electrical
and electronic equipment. Take care to dispose of this product in the proper
way; this will help to avoid the negative consequences that could arise from
unsorted collection or dumping. For more detailed information on the recycling
of this product, contact the municipal authority, the local refuse collection
service or the dealer from whom the item was purchased.
USE
CHOOSING A PROGRAMME
- 1 2 min every 6h
- 2 5 min every 6h
- 3 2 min every 12h
- 4 5 min every 12h
- 5 10 min every 12h
- 6 5 min every 24h
- 7 15 min every 24h
- 8 30 min every 24h
- 9 60 min every 24h
- 10 90 min every 24h
- 11 30 min every 48h
- 12 60 min every 48h
- 13 60 min every 72h
- 14 90 min every 72h
- 15 120 min every week
- 0 stand-by
The water timer manages automatic watering by selecting one of the 15 pre-set programmes. Each programme features a preset duration of watering (how long) and frequency (how often): both parameters are already set and CAN NOT be changed. To select and start a programme, turn the knob to one of the numbers from 1 to 15 corresponding to the programme selected. Watering will start after 10 seconds. Please do this at the time you want the first irrigation cycle to start. Following irrigation cycles will start according to the irrigation frequency set for the selected programme.
MODIFYING A PROGRAMME
To modify the irrigation programme, set the timer to OFF. Then, at the time
you want the irrigation cycle to start, turn the selector to the new
programme, from 1 to 15. The irrigation cycle will start and will be repeated
according to the irrigation frequency set for the programme.
STOPPING WATERING IN ADVANCE WHEN
- To stop an irrigation cycle in progress, turn the selector to OFF. Previous programming will be cancelled.
CONDITIONS OF GUARANTEE
This device is guaranteed for 3 years from the date of purchase as indicated by the invoice, bill or till receipt issued at the time of the transaction, which must be kept. Claber guarantees that the product is free of material or manufacturing defects. Within two years from the date of delivery to the consumer, Claber shall repair or replace any parts of this product found to be defective.
The warranty is void in the event of:
- Lack of proof of purchase (invoice, receipt or cash register receipt);
- Use or maintenance different from what is specified;
- Disassembly or tampering by unauthorised personnel;
- Faulty installation of the product;
- Damages from atmospheric agents or contact with chemical agents;
Claber accepts no liability for products that it has not manufactured, even if used in combination with its own products. The costs and the risks associated with shipment are met entirely by the owner. Assistance is provided by Claber authorized service centres.
Declaration of Conformity
Assuming full responsibility, we declare that the product
8932 – Eco-Logic
Complies with the applicable European and British directives, as per the
Declarations of Conformity accessible via the following link:
www.claber.com/conformity/.
Fiume Veneto, 11/2022
Il Presidente Claber S.P.A.
Ing. Gian Luigi Spadotto
Follow us on
Represented by:
Authorised Rep Compliance Ltd., ARC House, Thurnham, Lancaster, LA2 0DT, UK.
Tutorial at:
CLABER SPA – Via Pontebbana, 22 – 33080 Fiume Veneto PN – Italy
Tel. +39 0434 958836 – Fax +39 0434 957193
info@claber.com –
www.claber.com.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>