adro V3 Carbon Fiber Trunk Spoiler Instruction Manual
- June 12, 2024
- adro
Table of Contents
adro V3 Carbon Fiber Trunk Spoiler
INCLUDES
-
Carbon Fiber Rear Spoiler
-
End Plates
-
Bolts
-
Washers
-
Hex Bolts
Prep
Apply masking tape to protect the rear glass and remove the trunk cover, as
well as the nuts and other elements.
Position the carbon fiber rear spoiler over the trunk cover and check the
alignment.
Mark the position with masking tape.
Drill
Drill through the trunk cover using a power tool to match the holes located on
the spoiler’s mounting surface (total 6 places).
Using either a grinder or a hole saw, cut through the bottom of the trunk
cover in the areas shown below to create space for the hex bolts (total 6
places).
Install
Remove the masking tape and position the spoiler over the trunk cover so that
the holes line up.
Secure the spoiler to the trunk cover using the provided [bolts] and [washers]
with appropriate torque.
Reattach the trunk cover with the installed spoiler to the vehicle.
Remove the masking tape and secure the [end plates] in the correct position
using the provided [hex bolts].
Note, that excessive torque can cause deformation and damage.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>