KOHLER K-1947-GHRA 60 x 30 Inch Alcove Heated BubbleMassage Air Bath Instruction Manual
- June 12, 2024
- Kohler
Table of Contents
KOHLER K-1947-GHRA 60 x 30 Inch Alcove Heated BubbleMassage Air Bath
Features
- 120 airjets release thousands of heated bubbles that surround and support the body in a warm massage
- Automatic and manual purge cycles remove residual water from air channels after use
- Variable-speed blower lets you adjust massage intensity to 18 levels
- Comfort Depth™ design offers a convenient 19″ step-over height while retaining the same depth as a standard 21″ bath
- Integral lumbar support
- Slotted overflow allows for deep soaking
- Integral apron
- Integral flange helps prevent water from seeping behind wall and simplifies alcove installation
- Textured bottom surface
- Coordinates with other products in the Archer collection
- Built-in 600W BubbleMassage™ heater warms humidified air before it enters the bath
- Automatic and manual purge cycles remove residual water from air channels after use
Material
- Acrylic
Technology
- Auto-shutoff timer on blower allows users to enjoy Heated BubbleMassage™ experience for 60 minutes before turning off
- User interface: electronic keypad control
Installation
- Right drain
- Alcove
Required Products/Accessories
-
K-7271 Brass Slotted Overflow Bath Drain
or -
K-7272 PVC Slotted Overflow Bath Drain
Recommended Products/Accessories
- K-23726 Drain treatment
- K-31797 Slotted overflow bath drain kit
- K-31795 Slotted overflow above-the-floor bath drain kit
Codes/Standards
- ASME A112.19.7/CSA B45.10
- CSA B45.5/IAPMO Z124
- ASTM E162
- ASTM E662
- UL 1795
- CSA C22.2 No. 218.2
- ADA
- ICC/ANSI A117.1
Warranty
- KOHLER® Plastic Baths and Shower Bases Lifetime Limited WarrantyKOHLER® Hydrotherapy Components Five-Year Limited Warranty
- See website for detailed warranty information.
Available Colors/Finishes
- Color tiles intended for reference only.
Color Code Description
0 White
96 Biscuit
NY Dune
95 Ice™ Grey
58 Thunder™ Grey
7 Black Black™
DIMENSIONS
- No change in measurements if connected with drain illustrated. (K-7272)
Required Electrical Service
- Two dedicated circuits required, protected with Class A Ground-
- Fault Circuit-Interrupter (GFCI). Outside North America, this
- device may be known as a Residual Current Device (RCD).
- Blower: 120 V, 15 A, 60 Hz
- Heater: 120 V, 15 A, 60 Hz
Technical Information
All product dimensions are nominal.
- Installation: Three-wall alcove
- Drain location: Right
- Weight: 113 lbs (51.3 kg)
- Minimum floor load: 48.2 lbs/ft² (235.3 kg/m²)
- Water depth: 15-1/8″ (384 mm)
- Water capacity: 57 gal (215.8 L)
- Electrical component rating:
- Blower: 120 V, 10 A, 60 Hz
- Heater: 120 V, 5 A, 60 Hz
Notes
- Measure your actual product for rough-in details.
- Install this product according to the installation instructions.
- The hot water supply should be 70% of the capacity of the bath or greater. Installations will vary.
- Remote blower installation kit is available for relocating the blower. Provide access for servicing the blower.
- Do not relocate or alter the PVC tee or coiled flexible tubing connected to the blower. Follow the blower relocation instructions exactly.
- ADA compliant when installed to the specific requirements of these regulations.
CONTACT
- 1-800-4KOHLER (1-800-456-4537)
- Kohler Co. reserves the right to make revisions without notice to product specifications. For the most current Specification Sheet, go to www.kohler.com. 5-7-2023 22:58 – US/CA
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>