RCA TV Wall Mount Support Mural TV Installation Guide

TV WALL MOUNT
PRO SELECT
S E R I E S Full Motion
37″ 90″ TV (94-228cm)
EXTENDS AND PIVOTS
Installation Manual

TV Wall Mount Support Mural TV

Questions?
Please call us at 1-800-645-7750 or visit RCAAudioVideo.com
DISCLAIMER

Voxx Accessories Corp. has extended every effort to ensure to accuracy and completeness of this manual. However, Voxx Accessories Corp. does not claim that the information covers all installation or operational variables. The information contained in this document is subject to change without notice or obligation of any kind. Regarding the information contained herein, Voxx Accessories Corp. makes no representation of warranty, expressed or implied, and  assumes no responsibility for accuracy, sufficiency, or completeness of the information contained in this document.

WARNING INFORMATION

WARNING: FAILURE TO READ, THOROUGHLY UNDERSTAND, AND FOLLOW ALL INSTRUCTIONS CAN RESULT IN SERIOUS PERSONAL INJURY, DAMAGE TO PERSONAL PROPERTY, OR VOIDING OF FACTORY WARRANTY!
It is the responsibility of the installer to ensure all components are properly assembled and installed using the instructions provided. If you do not understand these instructions or have any questions or concerns, please contact customer service at 1-800-645-7750.
Do not attempt to install or assemble this product if the product or hardware is damaged or missing. In the event that replacement parts or hardware are needed, please contact Customer Service at 1-800-645-7750. International customers needing assistance should contact the Dealer from which they purchased the product.
The included hardware is designed for use on vertical walls constructed of wood studs or solid concrete. A wood stud wall is defined as consisting of a minimum of 2×4 wooden studs (2” wide by 4” deep) with a maximum of 5/8” drywall.  The included hardware is not designed for use with metal studs or cinderblock walls. If you’re uncertain about the construction of your wall, then please consult a qualified contractor or installer for assistance. For a safe installation, the wall you are mounting to must support 4 times the weight of the total load. If not, then the surface must be reinforced to  meet this standard. The installer is responsible for verifying that the wall structure and hardware used in any  installation method will safely support the total load.

WEIGHT CAPACITY

USE WITH FLAT PANELS EXCEEDING THE MAXIMUM WEIGHT CAPACITY OF THIS PRODUCT MAY RESULT IN PRODUCT FAILURE CAUSING POSSIBLE INJURY AND OR PROPERTY DAMAGE.

Tools Required (Not Included)

For drywall installation

For solid wall installation

Package Contents

Mounting Hardware Bags

Attach the mount arms to your TV

IMPORTANT! Use extra care during this part of the installation. If possible, avoid placing your display facedown as it may damage the viewing surface.
NOTE: This mount comes with a selection of different bolt diameters and lengths to accommodate a wide variety of display models. Not all of the hardware in the kit will be used. If you cannot find the appropriate bolt size in the kit provided, consult the manufacturer of your display for more information.

1. Determine the correct length of bolt (M-A/M-B, M-C/M-D, or M-E) to use.
   A. If the back of your display is flat and the mounting holes are flush with the surface, use the shorter bolts from the hardware kit.
   B. If the back of your display is curved, has a protrusion, or if the mounting holes are recessed, use the longer bolts. You may also need to use the big spacers.

2. Determine the correct diameter of bolt to use by carefully trying one of each size (M-A, M-B/M-C, or M-D/M-E) from the hardware kit. Do not force any of the bolts – if you feel resistance stop immediately and try a smaller diameter bolt.

3. Attach the mount arms to the back of your display using the bolts identified in Steps 1 and 2 and the adapter (M-F) as shown below:
   A. No spacers are needed with the bolts M-A or M-B.
   B. Use the spacers as needed (M-G or M-H) with the bolts M-C, M-D, or M-E.

Installation on wood stud

1. Use a stud finder to locate two wood studs where you wish to install your mount. Mark both edges of each stud to help identify the exact center.
   NOTE: You must use the center of each stud to avoid cracking or splitting the wood during installation.

2. Place the mounting guide (C) against the wall over the marked studs. Make sure the arrow is pointing up. Then use the included bubble level (F) to make sure the base is level and mark where the four mounting screws will go.

3. Drill 6 mm (1/4”) pilot holes in the wall 3.5” deep.

4. Use a ratchet (not included) to insert the top two mounting screws (W-A) where you marked. Do not insert them all the way—leave a 5mm space between the screw head and the wall.

5. Place the wall mount on the top screws as shown.

6. Tighten the top mounting screws. Then insert the two bottom mounting screws (W-A) and mounting washers (W-C) provided. Do not over-tighten these screws and do not release the wall plate until all screws are in place.
   Ensure that the wall mount base remains level after all screws are secured.

Installation on concrete

IMPORTANT! For safety reasons, the concrete wall must be capable of supporting the combined weight of the mount and the display. The manufacturer takes no responsibility for failure caused by walls of insufficient strength.

1. Place the mounting guide (C) against the wall where you want to install the mount. Make sure the arrow is pointing up. Then use the included bubble level (F) to make sure the guide is level and mark where the six mounting screws  will go (see the mounting screw placement diagram below). Mounting screw placement

2. Drill six 12 mm (1/2”) holes in the wall where you marked, 3.7” deep. Remove any excess dust from the hole.

3. Insert a concrete anchor (W-B) into each hole so that it is flush with the concrete surface. A hammer can be used to lightly tap the anchors into place if necessary.
   NOTE: If the concrete wall is covered by a layer of plaster or drywall, the concrete anchor must pass completely through the layer to rest flush with the concrete surface.

4. Use a ratchet (not included) to insert the two mounting screws (W-A) on the top outside, where you marked. Do not insert them all the way—leave a 5mm space between the screw head and the wall.

5. Place the wall mount on the top screws as shown.

6. Tighten the top mounting screws. Then insert the rest of the mounting screws (W-A) and mounting washers (W-C) provided. Do not over-tighten these screws and do not release the wall plate until all screws are in place. Ensure that the wall mount base remains level after all screws are secured.

Place your TV on the mount

1. With the help of another person, carefully lift your TV with mounting arms attached and place it on the wall plate. Do not release the display until the mounting arms have securely hooked onto the wall plate.
2. Pull up the locking latch on each mounting arm as shown. Then insert a locking bolt (D) in each slot as shown.

Run your TV’s cables through the cable covers

Adjust the tilt, pan, and level

To adjust the level of your TV: Use the included wrench (E) to slightly loosen the level adjustment bolts in the middle of the mount. Level your TV. Then tighten the bolts. To adjust the tilt of your TV: Move the tilt lever to the unlocked position (up) and move your TV to the desired tilt angle. Then move the tilt lever to the locked position (down).

Note: For heavier TVs, you might also need to tighten the bolt on the opposite side of the tilt lever to hold the TV in position.

To adjust the pan of your TV: Move your TV to the desired pan angle.

To remove your TV from the wall mount: Remove the locking bolt (D) from the slot on each mount arm. Push each locking latch down (see page 15 for more info). Gently pull the bottom of the TV out from the mount base. Then with the help of another person, carefully lift your TV off the mount base.

5-Year Limited Warranty
Voxx Accessories Corporation (the “Company”) warrants to the original retail purchaser of this product that should this product or any part thereof, under normal use and conditions, be proven defective in material or workmanship within 5 years from the date of original purchase, such defect(s) will be repaired or replaced with new or reconditioned product (at the Company’s option) without charge for parts and repair labor. To obtain repair or replacement within  the terms of the warranty, the product is to be delivered with proof of warranty coverage (e.g. dated bill of sale), specification of defect(s), transportation prepaid, to an approved warranty station. For the location of the nearest warranty  station to you, call toll-free to our control office: 1-800-645-4994.
This Warranty is not transferable and does not cover product purchased, serviced or used outside the United States or Canada. The Warranty does not extend to the elimination of externally generated static or noise. This Warranty does  not apply to costs incurred for installation, removal or reinstallation of the product, or, if in the Company’s opinion, the product has been damaged through acts of nature, alteration, improper installation, mishandling, misuse, neglect,  accident, or the simultaneous use of different battery types (e.g. alkaline, standard or rechargeable). This Warranty does not cover damage caused by an AC adapter not provided with the product.
THE EXTENT OF THE COMPANY’S LIABILITY UNDER THIS WARRANTY IS LIMITED TO THE REPAIR OR REPLACEMENT PROVIDED ABOVE AND, IN NO EVENT, SHALL THE COMPANY’S LIABILITY EXCEED THE  PURCHASE PRICE PAID BY PURCHASER FOR THE PRODUCT. This Warranty is in lieu of all other express warranties or liabilities. ANY IMPLIED WARRANTIES, INCLUDING ANY IMPLIED WARRANTY OF MERCHANTABILITY  OR FITNESS FOR A PARTICULAR PURPOSE, SHALL BE LIMITED TO DURATION OF THIS WARRANTY. ANY ACTION FOR BREACH OF ANY WARRANTY HEREUNDER, INCLUDING ANY IMPLIED WARRANTY, MUST BE  BROUGHT WITHIN A PERIOD OF 24 MONTHS FROM THE DATE OF ORIGINAL PURCHASE. IN NO CASE SHALL THE COMPANY BE LIABLE FOR ANY CONSEQUENTIAL OR INCIDENTAL DAMAGES WHATSOEVER. No  person or representative is authorized to assume for the Company any liability other than expressed herein in connection with the sale of this product.
Some states/provinces do not allow limitations on how long an implied warranty lasts  or the exclusion or limitation of incidental or consequential damage so the above limitations or exclusions may not apply to you. This Warranty gives you specific legal rights and you may also have other rights which vary from state/province to state/province.

| 200×200 / 300×300 400×200 / 400×400 600×400| MD3790FM
---|---|---

MD3790FM IB 00

Documents / Resources

| RCA TV Wall Mount Support Mural TV [pdf] Installation Guide
MD3790FM, TV Wall Mount Support Mural TV, TV Wall Mount, Support Mural TV Mount, TV Wall Mural TV Mount, Mural TV Mount, TV Wall TV Mount, Mount
---|---

References

• RCAAudioVideo.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>