Vibe DG-985BT Stereo Wireless Headphones User Guide
- June 12, 2024
- Vibe
Table of Contents
Vibe DG-985BT Stereo Wireless Headphones
STEREO WIRELESS HEADPHONES
CHARGING THE HEADPHONE
-
Charge the headphone before using it for the first time.
-
Plug in the cable ta the micro USB port and charge for at least 2.5 hours.
-
Connect the charging cable to charging port.
-
Make sure the headphone is turned off before attempting to pair it with a smart phone or tablet. Press and hold the “Play/Pause” button to turn on the headphone.
-
Press and hold the button until you see the light flash red and blue. This indicates that your headphone is ready to pair.
-
From your smart phone or tablet, find a list of nearby devices and choose “DG-985BT”. Enter “0000” if asked. The headphone will “beep” when pairing is complete!
CONNECTION LOST?
- If pairing the headphone does not work, turn off the headphone and repeat the steps again in “Pairing your Headphone.”
- Make sure your headphone is within range of your smart device.
- If you hear a long beep, you need to recharge your headphone.
- Connection may be lost due to low battery.
- When charging your headphones, only use the enclosed USB cable.
MEDIA KEY FUNCTIONS
SPECIFICATIONS
- Bluetooth Version: 5.0
- Wireless Distance: Up to 33ft (10m)
- Play Time: Up to 5-7 hours
- Talk Time: Up to 5-7 Hours
- Standby Time: Up to 100 Hours
- Battery Capacity: 250 mAh
- Charging Time: Up to 2.5 Hours
- FCC ID: 2AANZ985BTL
- BT ID: D044460
WARRANTY
This product is covered by a 3 month limited manufacturers warranty. Contact us if you have any problems at support@dglusa.com.
WARNING
- Keep away from water and moisture.
- Keep away from heat sources.
- Do not disassemble.
FCC STATEMENT
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions
- This device may not cause harmful interference
- this device must accept any interference received, including interference that may cause undesired operation.
Please note that changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment.
FCC INSTRUCTIONS FOR A CLASS B DIGITAL DEVICE OR PERIPHERAL
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules.
- These limits are designed to provide reasonable protection against harmful interference in a residential installation.
- This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
- If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Company name: DGL Group, Ltd.
Distributed by DGL Group, LTD. 2045 Lincoln Highway, Edison, NJ 08817, USA.