AUDIO SYSTEM 165 EM EVO Wege Easy Mounting Compo System Speaker Instruction Manual
- June 4, 2024
- AUDIO SYSTEM
Table of Contents
AUDIO SYSTEM 165 EM EVO Wege Easy Mounting Compo System Speaker
Congratulations on purchasing a high-quality AUDIO SYSTEM product incl. GERMAN SOUND.
Important:
Completely read this operating instruction before installation and use of the
device.
Attention:
Pay attention to advise and instructions of the car manufacturer. Check the
polarity when connecting the speakers.
Important:
You will need your purchase receipt as proof of purchase for any and all
warranty repairs and for insurance purposes. Keep your receipt, owner´s
manual, and packing materials in a safe location for possible future use.
Attention:
The use of sound components can impair your ability to hear necessary traffic
sounds and may constitute a hazard while driving your automobile. AUDIO SYSTEM
GERMANY accepts no liability for hearing loss, bodily injury or property
damage as a result of use or misuse of our products. We recommend installing
the equipment by an authorized service center or dealer. A professional
fitting and connection is the requirement for further warranty and perfect
sound.
WHAT’S IN THE BOX
Mechanical Installation Tip
Warning:
First, disconnect the negative pole of your car battery. Check-polarity,
changing polarity may cause serious damage to your car electric. Best speaker
positions are the original build-in positions. Easy installation and original
look are the reasons. Please note that the speakers are installed flat and
stable. The quality of the installation decides very much the sound,
therefore, attention should be paid to insulation and care during
installation. Please note that the speakers are protected from heat, sunlight,
mechanical influences, moisture, and wetness by accessories from the AUDIO
SYSTEM.
Attention:
Install all cables as straight as possible without squashing or laying them
over sharp edges. Otherwise, this can cause a short circuit or damage to your
whole installation.
Attention:
Be careful removing original plastic parts of your car. The fitting parts
could be damaged and have to be replaced.
Important:
The right polarity of all speakers is extremely important for the sound of
your car audio system. We recommend changing the polarity of the tweeter to
find out the best possible sound. The best is to listen and/or to measure it.
Install Tweeter Mounting
Important:
The enclosed mounting bracket is needed to install the tweeter in certain
vehicles / mounting positions. For this, the tweeter must be fixed in the
tweeter, this is from both sides possible.
Tweeter
Crossover FWK TW EVO
: The speaker system can be adapted to the particular acoustics of the vehicle, the genre of music, and to personal taste via the crossover. Depending on the position of the speakers, the switch can be adjusted so that the frequency response is optimized with these geometric conditions. Depending on the installation location of the tweeter, it is necessary to adjust the frequency response tonal and volume technology, e.g. when mounting the tweeter in the A-pillar, in the mirror triangle or in the door trim.
Attention:
Free cable ends must be isolated.
Non-compliance can lead to a short circuit!
Sound
Please connect the crossover FWK MW with CONNECTOR 017. It is a non- configurable fixed crossover
Rain Protection MBR165
Please attach the rain protection MBR165 between speaker adapter LSR OPEL1 and speaker AS 165 EM EVO. The water cap must be upward of the magnet. In some cases, the rain protection has to be cut for proper fitting with a suitable tool (scissor, cutter, etc).
Optional Mounting Accessories
- ALUBUTYL 1500, 2000 EVO and 3000 EVO, ALU 250 EVO Self Adhesive Damping Material
- Damping: Doorkit 1.0 and Doorkit 2.0
- Z-(T)SC 0.75, 1.5, 2.5, 4.0 Oxygen-Free Speaker Cable
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>