Intenso 2.5 Inch Memory Board User Manual
- June 12, 2024
- Intenso
Table of Contents
- Intenso 2.5 Inch Memory Board User Manual
- OVERVIEW
- Delivery scope
- Declaration of conformity
- GENERAL
- Intended use
- System requirements
- Notes :
- Removing the hard drive
- SAFETY INSTRUCTIONS
- Dangers for children and persons with restricted physical, sensory or
- General
- ASSISTANCE WITH PROBLEMS
- Status LED is not illuminated
- Hard Drive is not recognized
- TECHNICAL DATA
- DISPOSAL
- EXCLUSION OF LIABILITY
- GUARANTEE CONDITIONS AND COMPLAINTS PROCEDURE
- Guarantee conditions:
- Complaints procedure:
- Contact:
- Read More About This Manual & Download PDF:
- References
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
Intenso 2.5 Inch Memory Board User Manual
OVERVIEW
Delivery scope
- Intenso Super Speed USB 3.0 hard drive (downwards compatible)
- Operating instuctions
- USB 3.0 cable
Declaration of conformity
The CE marking says that this product meets the requirements of all EU Directives applicable for this product.
GENERAL
About these instructions
Read these instructions carefully and please observe and heed all references made in these instructions to guarantee a long life and reliable use of the device. Please keep these instructions ready to hand and pass them on to other users of the device.
Intended use
The primary purpose of this external hard drive is the storage of data from
PCs, Notebooks, Ultrabooks or MAC computers. This product is not intended for
commercial use or for medical and special applications, where the failure of
the product can cause injuries, mortalities or considerable material damages.
In the case of use which does not correspond to the intended use, the
liability expires. TThe opening, as well as conversion of the device and the
use of additional devices and accessories, which are not approved by us, must
be refrained from.
Do not use the device under extreme ambient conditions and observe the safety
instructions. Non−observance of the information and safety instructions in
these Instructions is deemed as non−observance of the intended use and leads
to expiry of the liability and can lead to personal or material damage.
System requirements
This hard drive is compatible with the operating systems MS Windows 7 / 8 /
8.1 / 10 and Mac OS 10.x. A free USB interface is required to operate it.
_Trademarks: Windows 7 / 8 / 8.1 / 10 are registered trademarks of the
Microsoft Corporation. Macintosh and MAC are registered trademarks of Apple
Computer. All brands and third party names are the property of the respective
user._
Notes :
A USB 3.0 interface card is necessary for the USB 3.0 operation The hard drive
is downward compatible to previous USB standards. The hardware configuration
of your PC and the used operating system can influence the compatibility of
the hard drive.
Power supply under USB 2.0: In the case that your USB 3.0 hard drive is not
recognised on a computer with a USB 2.0 port, the power supply could be a
possible cause. Please connect a USB hub with external power supply in this
case.
To connect the external hard drive to your computer, please use only the
supplied USB cable. Connect the USB 3.0 plug with the Intenso hard drive and
the plug of the USB cable end with your computer.
The computer recognizes the “new hardware” and installs the driver
automatically. Wait until the driver installation is completed. In the
“workplace” there is now another drive with the designation “Intenso”
available.
As soon as the external drive is connected with the computer, the LED lights
up The LED flashes when a write or read operation is carried out.
Removing the hard drive
Depending on the used operating system, the hard drive must be logged off before the connection to the computer is interrupted. For further details please refer to the Help Section of your operating system provider. The device may not be removed when it is still being accessed (flashing LED). This can lead to damages and/or data loss. Please close all the files located on the hard drive (photos, documents, etc.) before removing the hard drive.
SAFETY INSTRUCTIONS
Dangers for children and persons with restricted physical, sensory or
mental abilities:
Children often underestimate dangers or do not recognise them at all. This
device is not intended to be used by persons (including children) with
restricted sensory, physical or mental abilities
or lack of experience and/or knowledge, unless they are supervised by a person
responsible for their safety or received instructions from the person on how
to use the device and they have understood the resultant dangers. Unsupervised
children should not have access to the device. Make sure that children do not
play with the device.
General
The device may not be exposed to spray or dripping water.
Vessels filled with liquid (vases, glasses or similar) may not be placed on
the device. There is danger that the vessel tips over and the liquid impairs
the electrical safety.
Do not operate this device with wet hands.
Do not insert any items, which are not intended for its use, into the openings
of the device. This could lead to an electrical short−circuit and a resultant
fire.
Do not block or cover the openings of the product.
Under no circumstances use the device in the case of visible damages on it or
the USB cable.
When positioning the device, pay attention that no one can tread on the cable
or trip over it. Do not place any objects onto the cable.
Do not drop the device or subject it to vibrations or impacts, this applies in
particular to the transport. Do not move the device when it is in operation.
Hard drives are extremely vulnerable and the data located on them can be
destroyed irretrievably through this. Such damages are not contained in the
guarantees.
Carry out data backups frequently to avoid a possible data loss.
Data recovery is not part of the guarantees and cannot be conducted by our
Service Centre! Keep the device away from any type of moisture and avoid dust,
heat and direct sunlight.
Do not open the housing of the device and do not disassemble it into its
component parts. Do not try to repair it yourself. The guarantee expires in
this case.
Avoid using the device in strongly magnetized areas such as, for example, in
the direct proximity of TV sets, loudspeakers, etc. to avoid data loss or
other malfunctions.
During operation pay attention to a vibration−free base to avoid damages.
ASSISTANCE WITH PROBLEMS
Status LED is not illuminated
Check the external hard drive and the USB cable for visible damages. Should there be damage please contact our Support to exchange it. Under no circumstances use the defective device or cable. Check that the cable connection is plugged correctly.
Hard Drive is not recognized
Check the points under “Status LED is not illuminated” first.
Please check all further USB ports of your device (in particular on the rear
side of PCs), it is possible that the hard drive does not get enough power at
the used USB port. Please use only the supplied cable and, in particular, no
extension.
If you use a USB hub between hard drive and computer, this should have an own
power supply.
If the hard drive is not recognized at any USB port of your device, please try
if it works on another device to exclude a possible defect.
Check the Disk Management, it is possible that only a drive letter has to be
assigned (please see the Help file of your Windows version).
If you have used the hard drive previously, for example on a TV set, it could
be that you have to format the hard drive first so that you can use it on a
computer again (please refer to the ope- rating instructions of the previously
used device and/or the Help file of your operating system provider for
details).
TECHNICAL DATA
EXTERNAL USB 3.0 HARD DRIVE 2.5“ (6.35CM)
D i m e n s i o n s ( 2 . 5 “ h| o 15 u x 7 s 5 i
x n 1 g 15 ) m : m
T r a n s f e r r a t e :| max. 5 GBit/sec (USB 3.0)
Capacity calculation:| 1 MB = 1,000,000 bytes/
1 GB = 1,000,000,000 bytes
DISPOSAL
****| D i s p o s a l o f o l d e l e c t r o n i c e q u i p m e n t
: The devices marked with this symbol are subject to the European Directive
2012/19/EC. All electrical appliances and old electrical appliances must be
disposed of separate from the municipal waste stream via designated collec-
tion facilities appointed by the government or the local authorities.You avoid
environmental damage with the proper disposal of old electrical equipment.
---|---
| P a c k a g i n g :
Packaging is raw material. The packaging material of this product is suitable for recycling and can be re−used. Please pay attention to the local recycling provisions when disposing of any materials.
EXCLUSION OF LIABILITY
The firmware and/or hardware may be changed at any time without prior notice. For this reason it is possible that parts of these instructions, technical data and images in this documentation differ slightly from the product in your possession. All points described in these instructions only serve the purpose of clarification and must not inevitably correspond to a certain situation. Legal claims cannot be made on the basis of these instructions.
GUARANTEE CONDITIONS AND COMPLAINTS PROCEDURE
Guarantee conditions:
Intenso International GmbH grants a two−year guarantee for this product in
addition to the statutory warranty. The guarantee applies only to material and
production errors. Intenso International GmbH is not liable for the loss of
data. The free−of−charge guarantee relates to the repair or exchange of faulty
parts. You are responsible for the safe elimination of your data which is not
carried out by us. The sales receipt must be retained for the determination of
the guarantee period. Please understand that we cannot provide a guarantee
service in the case of, e.g.:
Non−observance of the Operating Instructions Abusive or improper treatment,
installation or use Damages, scratches or wear
Arbitrary modifications, opening the housing, interventions or repairs Damage
through other devices, force majeur or transport
Complaints procedure:
In the case of a complaint, please proceed as follows:
- Only returns with sales receipt and full accessories will be
- Furthermore, an RMA number is absolute precondition for You can request this RMA number via the homepage, by email or via the service hotline. It must be attached clearly visible on the parcel.
- Please pack the product including the sales receipt and complete accessories in a transport−proof The parcel must have sufficient postage.
Please send the parcel to the following address:
INTENSO INTERNATIONAL GMBH
Service Center (your RMA−No.) Kopernikusstraße 12−14 D−49377 Vechta
Contact:
Email (technical support):
support@intenso−international.de
Email (RMA−number):
rma@intenso−international.de
Internet:
www.intenso−international.de
Service Hotline: +49 (0)
900 –1 50 40 30 (0,39 € / min. from the German fixed network mobile phone
prices may vary.)
Read More About This Manual & Download PDF:
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>