Vibe SBSS LED Flame Party Speaker User Guide
- June 12, 2024
- Vibe
Table of Contents
SBSS LED Flame Party Speaker
QUICK START GUIDE
CHARGING THE SPEAKER
Charge the specked before using i or the first-time.
Plugin the cable to the micro USB port and charge for 2 hours.
Connect the charging cable to charging port.
MEDIA KEY FUNCTIONS
- ON/OFF
- Charge Jack
- Tf Card Port
- U Disk Port
Press once – play/ previous song / Press & hold -decrease volume
Press once – play/pause music / Press twice – TWS mode
Press once – play next song / Press & hold – increase volume
Switch between TF card, u disk or FM.
Light modes switch
SPECIFICATIONS
Speaker: 3 inch
Output Power: 3W
Frequency Response: 2402-2480MHz
Sensitivity: 50dB
Battery Capacity: 400 mAh
Voltage: DC 5V
Charging Time: 2 hours
Play Time: up to 3 hours
Product Size: 6.1″x2.6″x3.7″
Bluetooth Version: V5.0
Bluetooth Distance: 10m
Impedance: 4Q
PAIRING YOUR SPEAKER
Your speaker will work best if it is within 33 ft. of your smart device. You may experience sound briefly cutting off if you are out of range or if your wireless connection is weak. Make sure Bluetooth is enabled on your smart phone or tablet before starting the pairing process.
Press the power button to turn on the speaker and the speaker will “beep” when it is ready to pair. From your smart phone or tablet, find a list of nearby devices and choose “DG-SBSS”. Enter “0000” if asked. The speaker will “beep” again when pairing is complete!
FCC STATEMENT
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Please note that changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
FCC INSTRUCTIONS FOR A CLASS B DIGITAL DEVICE OR PERIPHERAL
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
WARNING
Keep away from water and moisture.
Keep away from heat sources.
Do not disassemble.
Distributed DGL Group, Ltd. 2045 Lincoln Hwy,
Edison, NJ, 08817, USA.
BT ID: D044460 FCC ID: 2AANZSBSS
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>