MECPOW FC1 Laser Engraver Enclosure User Manual
- June 12, 2024
- MECPOW
Table of Contents
MECPOW FC1 Laser Engraver Enclosure
INSTALLATION
-
Step 1
Connect the corresponding tubes with 2-way connectors.
-
step 2
Connect all the tubes as shown in the picture. -
Step 3
Attach the protective cover directly to the frame. The transparent window should be facing the side with the slope. After placing the protective cover, close the velcro to fix the cover onto the frame. The velcro is attached to the protective cover near the tube connector.
-
Step 4
To assemble the fan, thread out the screws from the inside of the protective cover. Then, slide the screws into the fan, air guide, and nuts in the correct sequence. Tighten the nuts securely. Next, place the exhaust pipe onto the throat hoop and attach the air guide. Finally, tighten the cross screw on the throat hoop to complete the assembly.
Package List
CONTACT
- CET PRODUCT SERVICE LTD.
- Osterholzallee 144, 71636 Ludwigsburg Germany
- E-mail: info@cetproduct.com.
- Tel: +4971416432236
- CHENGDU XINHONGJIN TECHNOLOGY CO., LTD.
- No. 26, 1/F, Building 3, No. 68, Haichang Road, Huayang Street,
- Tianfu New District, Chengdu City, Sichuan, China
- www.mecpow.com.
- support@mecpow.com.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>