Thermador PARKB3XIHB Pro Harmony Induction Knob Kit Instruction Manual

: June 13, 2024
: Thermador

Table of Contents

Thermador PARKB3XIHB Pro Harmony Induction Knob Kit
Product Information
Product Usage Instructions
Knob replacement
Knob identification
Proposition 65 Warning
Knob
Knob Locations
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Thermador PARKB3XIHB Pro Harmony Induction Knob Kit

Product Information

The Pro Harmony Induction Knob Kit is a set of replacement knobs for your Thermador appliance. The kit includes two types of knobs: Mode knob and Temperature knob. These knobs are designed to fit specific range models, such as PRI30LBHU, PRI30LBHC, PRI36LBHU, and PRI36LBHC. It is important to note that the installation and operation of the knobs should be done correctly to ensure personal safety and prevent damage to the appliance. The knobs should not be forced onto the control shafts. The product packaging may bear a Proposition 65 Warning label, as required by the State of California. This label indicates that the product may contain a chemical known to cause cancer or reproductive harm.

Product Usage Instructions

Before replacing any knobs, ensure that the appliance is turned off.
To exchange a knob, locate the OFF marking on the knob and make sure it is facing up.
Gently push the knob onto the control’s shaft or pull the knob off the shaft, depending on whether you are replacing or removing a knob.
Each knob should install easily. If a replacement knob does not fit properly, double-check if you have chosen the correct position.
After installation, verify that each knob turns freely and that the markings on each knob align with the graphics or indicators on the control panel.

Refer to the included diagram to identify the position of each knob type on your appliance’s control panel. Some knobs may be used in multiple locations, while others may not be used at all, depending on your range model.

If you have any questions or concerns about installing or using the Pro Harmony Induction Knob Kit, please contact Thermador customer support at 800-735-4328 or visit their website at www.thermador.com.

Knob replacement

CAUTION
DO NOT force knobs onto control shafts. Failure to install and operate knobs properly may result in personal injury and damage to the appliance.

To exchange knobs, make sure that the OFF marking on the knob is facing up, while gently pushing the knob on or pulling the knob off the control’s shaft. Each knob should install easily. If a replacement knob is not fitting properly, it is likely that an incorrect position has been chosen. After installation, verify that each knob turns freely, and that the markings on each knob correspond to the graphics or indicators on the control panel.

Knob identification

The following illustrations identify each knob type contained within this kit. Locate the position of each knob type by its corresponding number on the diagram that matches the control panel on your appliance. Some knobs will be used in more than one location and other knobs may not be used at all; this depends upon your range model.

Proposition 65 Warning

This product may contain a chemical known to the State of California, which can cause cancer or reproductive harm. Therefore, the packaging of your product may bear the following label as required by California:

State of California Proposition 65 Warning:

WARNING
Cancer and Reproductive Harm – www.P65Warnings.ca.gov