STEP2 COOKING TIME KITCHEN User Guide
- June 13, 2024
- Step2
Table of Contents
STEP2 COOKING TIME KITCHEN
Product Information
The Cooking Time KitchenTM is a product manufactured by The Step2 Company, LLC. It is intended for use by children aged 2 years and up. The product is designed to provide a safe and enjoyable cooking experience for children.
The product is equipped with various components, including screws, decals, and plastic parts. It is important to follow the assembly instructions carefully to ensure proper usage and safety.
The Cooking Time KitchenTM complies with Part 15 of the FCC rules and Canadian ICES-003 regulations. It is designed to operate without causing harmful interference and must accept any interference received.
Please note that the product does not come with pre-drilled holes. Screws are self-threading and should be driven into the plastic before putting them into place.
Product Usage Instructions
- Before using the Cooking Time KitchenTM, carefully inspect the product for any damages or worn components. Tightly secure connections and replace any damaged or worn parts. Contact The Step2 Company for replacement parts if needed.
- Assemble the product according to the provided assembly instructions. Adult assembly is required.
- Ensure that the product is placed on a stable surface, away from any potential hazards.
- When applying decals, clean and dry the area thoroughly. Center the decal in the desired area and apply pressure from the center to the outer edge.
- For disposal of the product, please recycle it in compliance with government regulations.
- For cleaning, use water before use to ensure proper hygiene.
For additional tips and installation instructions, you can visit the Step2 website at www.step2.com/video-tips.
Intended for use by children from ages 2 years and up.
OBSERVE ALL STATEMENTS AND WARNINGS TO REDUCE THE LIKELIHOOD OF SERIOUS OR
FATAL INJURY.
SAVE THIS SHEET FOR FUTURE REFERENCE.
WARNING:
CHOKING HAZARD
Small parts & sharp points present before assembly. Adult assembly required.
SAFETY INFORMATION
- Provide continuous adult supervision at all times.
- Instruct children not to use product until properly assembled
- DO NOT remove any screws once installed. For disassembly, only remove parts not secured by screws.
- DO NOT over-tighten screws or they will not hold parts together appropriately.
- Take notice that screws are designed to pierce the plastic and form their own threads.
CLEANING INSTRUCTIONS
Electronic Components
- Do not submerge in water or spray liquid directly on unit.
- Wipe with damp cloth.
General Cleaning:
- Use a 50/50 mixture of white vinegar and water.
- Parents should thoroughly wash accessories with mild soapy water before use.
DECAL APPLICATION
Clean and dry area thoroughly. Center decal in area. Apply pressure from center to outer edge.
DISPOSAL INSTRUCTIONS
Please recycle when possible. Disposal must be in compliance with government regulations.
IMPORTANT:
- Do not mix old and new batteries.
- Do not mix different types of batteries.
- Insert batteries with correct polarity.
- Remove exhausted batteries from the toy.
- Follow battery manufacturer’s warnings and recommendations.
- Do not recharge non-rechargeable batteries.
- Rechargeable batteries are to be removed from the toy before recharging.
- Rechargeable batteries are to be charged only under adult supervision.
- The supply terminals are not to be short circuited.
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION .
THIS CLASS B DIGITAL APPARATUS COMPLIES WITH CANADIAN ICES-003.
WARNING: CHANGES OR MODIFICATIONS TO THIS UNIT
NOT EXPRESSLY APPROVED BY THE PARTY RESPONSIBLE FOR COMPLIANCE COULD VOID THE
USER’S AUTHORITY TO OPERATE THE EQUIPMENT.
NOTE: THIS EQUIPMENT HAS BEEN TESTED AND FOUND TO COMPLY WITH THE LIMITS FOR A CLASS B DIGITAL DEVICE, PURSUANT TO PART 15 OF THE FCC RULES. THESE LIMITS ARE DESIGNED TO PROVIDE REASONABLE PROTECTION AGAINST HARMFUL INTERFERENCE IN A RESIDENTIAL INSTALLATION. THIS EQUIPMENT GENERATES, USES, AND CAN RADIATE RADIO FREQUENCY ENERGY AND, IF NOT INSTALLED AND USED IN ACCORDANCE WITH THE INSTRUCTIONS, MAY CAUSE HARMFUL INTERFERENCE TO RADIO COMMUNICATIONS. HOWEVER, THERE IS NO GUARANTEE THAT INTERFERENCE WILL NOT OCCUR IN A PARTICULAR INSTALLATION. IF THIS EQUIPMENT DOES CAUSE HARMFUL INTERFERENCE TO RADIO OR TELEVISION RECEPTION, WHICH CAN BE DETERMINED BY TURNING THE EQUIPMENT OFF AND ON, THE USER IS ENCOURAGED TO TRY TO CORRECT THE INTERFERENCE BY ONE OR MORE OF THE FOLLOWING MEASURES:
- REORIENT OR RELOCATE THE RECEIVING ANTENNA.
- INCREASE THE SEPARATION BETWEEN THE EQUIPMENT AND RECEIVER.
- CONNECT TH E EQUIPMENT INTO AN OUTLET ON A CIRCUIT DIFFERENT FROM THAT TO WHICH THE RECEIVER IS CONNECTED.
- CONSULT THE DEALER OR AN EXPERIENCED RADIO/ TV TECHNI-CIAN FOR HELP.
INSPECT THIS PRODUCT BEFORE EACH USE. TIGHTLY SECURE CONNECTIONS AND REPLACE DAMAGED OR WORN COMPONENTS. CONTACT THE STEP2 COMPANY FOR REPLACEMENT PARTS.
PARTS AND TOOLS
PLEASE NOTE: Product has no holes. Screws form their own. Apply pressure. Scan QR code for screw installation tips.
Decal Application
When you see light bulb icon, drive screws 1/4 inch (6.35mm) into plastic before putting into place.
INSTALLATION
The Step2 Company, LLC.
10010 Aurora-Hudson Rd. Streetsboro, OH 44241 USA
1-800-347-8372 USA & Canada Only
(330)656-0440
www.step2.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>