SIRIUS SLTC928 Built In Under Cabinet Hoods Instruction Manual

: June 13, 2024
: Sirius

Table of Contents

SIRIUS SLTC928 Built In Under Cabinet Hoods
Product Information
Product Usage Instructions
WHAT’S IN THE BOX
TECHNICAL DRAWING
MEASUREMENTS FOR INSTALLATION
INSTALLATION
USES
INSTALLATION
WORKING
MAINTENANCE
ABOUT COMPANY
Read User Manual Online (PDF format)
Download This Manual (PDF format)

SIRIUS SLTC928 Built In Under Cabinet Hoods

Product Information

The product is a SLTC928 model. It is equipped with a motor and is designed for both filtering and suction performances. The appliance can be used by children aged 8 years and above, as well as persons with reduced physical, sensory, or mental capabilities. It is built in class I and must be earthed for safety.
In its sucking version, fumes are directly conveyed outside through an evacuation duct connected to the superior part of the wall or ceiling. In this case, neither a coal filter nor an air deflector is necessary. In its filtering version, the appliance purifies the air and fumes using a grease filter and an active coal filter. The purified air is then circulated back through a hole on the top of the cabinet.
The product features various control functions, including a light switch On/Off, speed reduction/Off motor, luminous telltale, ON motor/increase speed, and a 10-minute timer. The touch control key allows users to select the desired function by touching the relative key. If the power supply to the product is cut, self-diagnostics are performed for 15 seconds after the functions are restored.
The product is equipped with dimmable lights function, allowing users to adjust the brightness from 20% to 100% by continuously pressing the light key on the remote control. The product also has a color temperature setting feature, which can be adjusted by holding down the TIMER key and using the Light key to change the color temperature.
Maintenance of the product is essential for good functioning and long-lasting performance. In its filtering version, the active coal filter needs to be periodically replaced. The coal filter can be removed by first removing the grease filter and pulling its special plastic tongue until it is unfastened from its slot. The coal filter should be replaced every six months or depending on use.

Product Usage Instructions

Ensure that the appliance is properly earthed before use.
Choose the desired mode of operation: sucking or filtering.
In the sucking mode, connect the evacuation duct to the superior part of the wall or ceiling for fume extraction.
In the filtering mode, ensure that the grease filter and active coal filter are properly installed.
Use the light switch On/Off to control the hood light.
Use the speed reduction/Off motor button to adjust the motor speed or turn it off.
Observe the luminous telltale for status indications.
Use the ON motor/increase speed button to adjust the motor speed or turn it on.
Set the desired duration using the 10-minute timer.
For dimmable lights function, use the light key on the remote control to adjust brightness levels from 20% to 100%. Short press to turn the light on at 100% or off. Continuously press to reduce brightness. Release during adjustment to maintain the selected brightness level.
For color temperature setting, ensure that the lights and fan are off. Hold down the TIMER key to turn on the light at the previously set color temperature. Press and hold the Light key to change the color temperature from warm to cold. Release the Light key to select the desired color temperature. Exit the color temperature selection function by pressing the ON/OFF key.
Regularly maintain and clean the appliance. Replace the active coal filter every six months or as needed, depending on use. Remove the filter by first removing the grease filter and pulling its special plastic tongue. Re-insert the coal filter in the opposite way.

WHAT’S IN THE BOX

SIRIUS-SLTC928-Built-In-Under-Cabinet-Hoods-fig-2

TECHNICAL DRAWING

SIRIUS-SLTC928-Built-In-Under-Cabinet-Hoods-fig-3

MEASUREMENTS FOR INSTALLATION

SIRIUS-SLTC928-Built-In-Under-Cabinet-Hoods-fig-4

INSTALLATION

SIRIUS-SLTC928-Built-In-Under-Cabinet-Hoods-fig-5

WARNINGS

The air outlet of the appliance must not be connected to a flue which is used for exhausting other fumes from appliances, such as a central heating, boilers etc..
For the external exhausting of the fumes, comply with the regulations in force.
The motor of the peripheral exhausting group is powered by the cooker hood placed in the kitchen.
Before connecting the cooker hood to the mains supply, make sure that the voltage indicated in the rating plate cor-responds to the mains voltage in the home.
Before carrying out any sort of maintenance or cleaning operation, make sure that the ap-pliance is disconnected from the electrical mains.
An appropriate maintenance ensures a good working and a good per formance in the long run.
All models are built in class I, therefore they must be earthed.
This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervi-sion or instruction concerning use of the appliance in a safe way and under stand the hazards involved.
Children shall not play with the appliance.
Cleaning and user maintenance shall not be made by children without supervision.
If the power cable is dama-ged, it must be replaced by a cable or a special assembly, available from the manufacturer or its service de partment technique.
The room must have adequa-te ventilation when using the kitchen hood simultaneously with other appliances that use gas or other fuels (not yes ap-plies to appliances that simply release the air back into the room);
There is the possibility of fire if the cleaning operations are not carried out as indicated in the instructions;
Do not prepare flambéed food under the kitchen hood.
ATTENTION: The accessible parts can burn if used in con-junction with the cooking ap-pliances.

USES

The appliance is already arranged both for filte-ring and for suction performances.
In its filtering version, the air and fu mes con-veyed by the appliance are depured both by a grease filter and by an active coal filter, and put again into circulation through the hole made on the top of the cabinet.
In its sucking version, fumes are di rectly con-veyed outside, through an evacuation duct con-nected with the superior part of the wall or the ceiling. Both coal filter and air deflector are not necessary in this case.

INSTALLATION

Before installing the appliance, make sure that none of the parts is damaged in any way.
In case of damaged parts, contact your retailer and do not proceed with installation.
Read all of the following instructions fully care be-fore installing the appliance.
- Use an air outlet pipe of the shortest possible length.
- Limit the number of pipe bends.
- Use a material approved by standards and re-gulations.
- Avoid any sudden changes in pipe section (re-commended constant diameter: 150 mm or equal surface area).
- The manufacturer shall not respond for air ca-pacity or noise problems due to non- compliance with above mentioned instructions, and no war-ranty shall be given.

WORKING

Mod. SL TC – Glass (dis. 17)

A: Light switch On/Off
B: Reduce speed / OFF motor
C: Luminous telltale
D: ON motor/incrase speed
E: 10 – minute timer
The touch control key allows the function desired by touching the relative key.
If the electrical power supply to the product SLTC is cut, 15 seconds are needed for selfdiagnostics after the functions are restored.
In the meanwhile, its operation may be incorrect. The products are endowed with an electronic devi ce which allows the automatic switching off after 4 hours working from the last operation.

DIMMABLE LIGHTS FUNCTION

THIS FUNCTION PROVIDES FOR LIGHTS DIM-MABILITY, RANGING FROM 20% TO 100% , BY CONTINUOUSLY PRESSING THE LIGHT KEY ON THE REMOTE CONTROL.
FUNCTIONS ARE THE FOLLOWING:
- HOOD LIGHT OFF – SHORTLY PRESS THE KEY – LIGHT ON AT 100%.
- LIGHT ON AT 100% – SHORTLY PRESS THE KEY – LIGHT OFF.
- LIGHT ON AT 100% – CONTINOUSLY PRESS THE KEY – BRIGHTNESS REDUCTION.
- RELEASING THE KEY DURING REDUCTION OR INCREASE – LIGHT KEEPS THE LUMINOUS INTENSITY REACHED.
- LIGHT ON – DIMMED – CONTINOUSLY PRESS THE KEY – BRIGHTNESS IS INVERTED IF COM-PARED TO THE PREVIOUS FUNCTION.

COLOUR TEMPERATURE SETTING

Make sure that the lights and the fan are off. Holding down the TIMER key will turn on the light at the previously set colour temperature.
Press and hold the Light key to change the colour temperature.
As long as the key is kept pressed, the colour temperature is changed from warm to cold, just leave the Light key to select the desired colour. Exit the colour temperature selection function by pressing the ON/OFF key.

TIMING

As a result of the new EU65 “Energy label” and EU66 “ Ecodesign” regulations issued by the Eu-ropean Commission, which came into force as from January 1st, 2015 , our products have been adapted to comply with these new requirements. All of the models complying with the energy label requirements, are equipped with new electronics including a timer device for suction speeds con-trol, when the air capacity exceeds 650m³/h. Internal motor models, with maximum air capacity higher than 650m³/h, are equipped with a timer de vice that automatically switches the suction speed from 4th to 3rd speed, after 6 minutes ope-ration.
The energy consumption of the appliance in stand – by mode is lower than 0.5W.

MAINTENANCE

An accurate maintenance guarantees good fun-ctioning and long-lasting performance.
An accurate maintenance guarantees good fun-ctioning and long-lasting performance.
Particular care is due to the grease filter panel. It can be removed by pushing its special handle toward the back-side of the cooker hood and tur-ning the filter downwards so to unfasten it from its slot.
To insert the filter just perform the opposite ope-ration.
After 30 hours working (model), the push button control panel will signal the saturation of the grea-se filter by lighting all the buttons. Press the timer button to reset .
The grease filter needs cleaning by regular hand-washing or in dishwashers every two months at least or depending on its use.
In case the appliance is used in its filtering ver-sion, the active coal filter (Fig. B) needs to be periodically replaced. The coal filter can be re-moved by removing the grease filter first (Fig. A), and by pulling its special plastic tongue until it is unfastened from its slot. Re-insert the coal filter by operating in the opposite way. The coal filter needs replacing depending on the use, but howe-ver every six months at least.
To clean the appliance itself tepid water and neutral detergent are recommended, while abra-sive products should be avoided. For steel ap-pliances specialized detergents are recommen-ded (please follow the instructions indicated o the product itself to obtain the desired results).

LED BAR REPLACEMENT
Remove the grease filter and put pressure on the led bar placed in the internal part of the built-in hood until you can unhook the springs, then di sconnect the connector and replace the bar with a similar one.
If the supply cord is damaged, it must be replaced by the manufacturer or its sevice agent or a similarly qualified person in order to avoid a hazard.