iFlight BLITZ WHOOP 1.6W VTX Whoop Adjustable Video Transmitter Instructions
- June 13, 2024
- IFLIGHT
Table of Contents
B013728 -BLITZ WHOOP 1.6W VTX Instructions
LED Indicator and Function Button
Frequency Table
Note: Antennas must be installed BEFORE powering on.
The VTX can be damaged when using without proper cooling.
| BAND | CH |
|---|---|
| CH1 | CH2 |
| A | 5865MHz |
| B | 5733MHz |
| E | 5705MHz |
| F | 5740MHz |
| R | 5658MHz |
1.Specs：
Power Levels：25mW/400mW/800mW/1600mW
Mounting Pattern：25*25mm/Φ2mm
Antenna Interface: IPEX
Input Interface：SH1.0 8P With Lock Catch
VTX Telemetry: IRC Tramp
Weight：16.5g (±1g)
2.Ports：
Camera in: Camera video Input
GND: Negative
5v out:5v Voltage Output
Camera out: Camera video output
Video in: Video Signal Input
IRC：IRC Tramp Signal Input
GND: Negative
VBAT：2-8S，7-34V DC Positive Input
3.Attention：
- Please read the instructions for proper wiring before use.
- It is recommended that before switching on the power, make sure that the antenna has been installed, it can extend the life of the module.
- It is recommended to ensure the correct voltage range and the correct positive and negative polarity before switching on the power to avoid burning the components.
- Please keep enough space when you install the VTX to ensure air convection around the module for heat dissipation. Otherwise, the module will enable overheat protection and the power transmission will be reduced or even switched off.
Connect VTX to FC(Camera to VTX)
Connect VTX to FC(Camera to FC)
Enable the corresponding VTX IRC Tramp on UART port
Camera to VTX without FC
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>