Dongguan LS-03 Portable Watch Charger User Manual

Dongguan LS-03 Portable Watch Charger

Introduction

This product, a small portable smart watch charger, specially charging for Apple watch, is suitable for home, outdoor, travel, office and so on. It uses safe and efficient polymer cells, and the original light ring. displaying the battery level of the charger, will bring you extremely individuality and new fashionable experience.

Appearance

Compatible Devices

Apple iWatch Series 1,2,3,4,5,6,SE.

Operation Steps

Charge for your watch

Press the switch key, the light ring will be on in blue for a while. During the while put your watch in, charging will start, and the light ring keeps on in blue. During the power consumption, the light ring will be off grid by grid; When you stop charging, just remove your watch or press the switch key twice, and the light ring will be off in whole.

Charge for the watch charger

Plug a adapter into the charger through a Micro-USB cable, the light ring will run around grid by grid for a lap and then keeps on. During the power increasing, the ring will be adding grid by grid, and its last one grid will flash. When 75%~ 100% charged, the ring will display as a full circle.

The 4 arc lights

Display 4 levels of the charger’s battery:

Packaging List

1. Watch Charger*l
2. User Manual*l
3. Micro-USB cable*l

Specification

Input : 5V/1A
Output : 5V/0.4A
Output Power : 2W
Transmission Distance : ≤1.1mm
Battery Capacity : 1000mAh
Working Environment Temperature : -10°C~60°C
Product Size : 71X42Xl5.8mm

Cautions

1. This charger has a built-in battery, do not disassemble it;
2. Protect the charger from water, moisture and falling;
3. Do not charge a thigh temperature;
4. Do not use the product in water or fire;
5. If the battery is bloated, leaking or smelly, please stop using it immediately;
6. If you do not use this product for a long time, please charge it at least once every 3 months;
7. Prevent from polluting environment and accidents. When you discard, you must take it to a professional recycling place.

FCC Warning Statement

Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and use din accordance with the instructions, may cause harmful interference to radiocommunications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC Radiation Exposure Statement
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>