Shark Vertex DuoClean PowerFins Cordless Vacuum with Self-Cleaning Brushroll User Guide

June 13, 2024
Shark

Shark Vertex DuoClean PowerFins Cordless Vacuum with Self-Cleaning

Brushroll

Shark-Vertex-DuoClean-PowerFins-Cordless-Vacuum-with-Self-Cleaning-
Brushroll-FIG-1

Product Information:

The product is a handheld vacuum cleaner with a MultiFLEX feature that allows it to reach and store in various positions. It is equipped with Powerfins for effective cleaning and has different power settings for different surfaces. The vacuum is powered by a Lithium-Ion Power Pack that provides a long-lasting charge.

Product Usage Instructions

  1. To use the vacuum, press the MultiFLEX Lock Release button and fold the handheld vacuum forward. Lift up the handheld vacuum until the wand locks in place.
  2. To empty the dust cup, first disconnect the handheld vacuum from the wand by pressing the Wand Release button and pulling up on the handheld vacuum. Position the dust cup over a trash bin and slide the lid release button forward.
  3. For quick assembly, refer to the labeled parts diagram provided. Attach the necessary parts by clicking them into place.
  4. To turn off the power, slide the switch to the top position. Slide the switch to the middle position for cleaning hard floors and low-pile area rugs. Slide the switch to the bottom position for cleaning carpets. In Boost Mode, pull the Trigger on the handheld vacuum for added power and release it to return to standard power.
  5. The Lithium-Ion Power Pack has battery indicator lights that indicate the charge level. The battery needs to be fully charged before first use. To charge, plug the charger into the charging port on the battery. A full charge takes approximately 3 hours.
  6. To put the vacuum in storage mode, press the MultiFLEX Lock Release button while folding the handheld vacuum forward until the wand clicks and locks. Plug the charger into the charging port on the battery.
  7. To remove the battery, press the Battery Release button and slide out the battery. Plug the charger into the charging port on the battery.

For any further questions or assistance, visit the website sharkclean.com.

ASSEMBLY

WHAT’S INSIDE

  • A Handheld Vacuum
  • B MultiFLEX® Wand
  • C DuoClean® PowerFins Floor Nozzle D Crevice Tool
  • E Pet Multi-Tool
  • F Anti-Allergen Brush
  • G Lithium-Ion Battery (Pre-Installed)
  • H Charger
  • I HEPA Post-Motor Filter (Pre-Installed)

POWER SETTINGS

  • OFF: Slide switch to the top to turn off power. To begin vacuuming, slide switch to the appropriate setting.

  • HARD FLOOR SETTING: Slide switch to the middle. The brushrolls spin slowly to clean hard floors and low-pile area rugs.

  • CARPET SETTING: Slide switch to the bottom. The brushrolls spin faster to pick up debris below the surface of your carpets.

  • BOOST MODE: For an added boost in power, pull the Trigger on the handheld vacuum. Release it to return to standard power.

LITHIUM-ION POWER PACK

In Use

Shark-Vertex-DuoClean-PowerFins-Cordless-Vacuum-with-Self-Cleaning-
Brushroll-FIG-7

Charging

Battery Indicator Lights
NOTE: The Lithium-Ion Power Pack battery comes partially charged. Charge fully before first use, then run the battery down until it is completely out of power. This will condition the battery so the LED indicators will work properly.

CHARGING

  • To put the vacuum in storage mode, press the MultiFLEX Lock Release button while folding the handheld vacuum forward until the wand clicks and locks. Plug the charger into the charging port on the battery.

  • To remove the battery, press the Battery Release button and slide out the battery. Plug the charger into the charging port on the battery.

REACH ANYWHERE

Press the MultiFLEX® Lock Release button to lower the angle of the wand to increase your reach.

STORE ANYWHERE

  • Press the MultiFLEX Lock Release button and fold the handheld vacuum forward.
  • To vacuum, lift up the handheld vacuum, until the wand locks in place.

Shark-Vertex-DuoClean-PowerFins-Cordless-Vacuum-with-Self-Cleaning-
Brushroll-FIG-12

EMPTYING THE DUST CUP

  1. To empty dust cup, first disconnect the handheld vacuum from the wand by pressing the Wand Release button and pulling up on the handheld vacuum.

  2. Position dust cup over a trash bin and slide the lid release button forward.

For questions, visit us online at sharkclean.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals