LASKO 4000 Air Stik Ultra Slim Oscillating Fan User Manual
- June 13, 2024
- Lasko
Table of Contents
LASKO 4000 Air Stik Ultra Slim Oscillating Fan
This Fan is for residential use only. It is not intended to be used in commercial, industrial or agricultural settings.
READ AND SAVE THESE INSTRUCTIONS
READ CAREFULLY BEFORE ATTEMPTING TO ASSEMBLE, INSTALL, OPERATE OR MAINTAIN THE
PRODUCT DESCRIBED. PROTECT YOURSELF AND OTHERS BY OBSERVING ALL SAFETY
INFORMATION. FAILURE TO COMPLY WITH INSTRUCTIONS COULD RESULT IN PERSONAL
INJURY AND/OR PROPERTY DAMAGE! KEEP INSTRUCTIONS FOR FUTURE REFERENCE.
GENERAL SAFETY INFORMATION
When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electrical shock and injury to persons, including the following: Read all instructions before using this Fan.
-
Make certain the power source conforms to the electrical requirements of the Fan.
-
Make certain that the room is equipped with a working smoke detector.
-
Use this Fan only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electrical shock, or injury to persons.
-
To reduce the risk of personal injury and electric shock, the Fan should not be played with or placed where small children can reach it.
-
Unplug power cord before installing, servicing, or moving the Fan.
WARNING
DO NOT DEPEND ON THE ON/OFF SWITCH AS THE SOLE MEANS OF DISCONNECTING POWER WHEN SERVICING OR MOVING THE FAN. ALWAYS UNPLUG THE POWER CORD. ALWAYS TURN OFF AND UNPLUG FAN BEFORE LEAVING THE AREA. NEVER LEAVE CHILDREN UNATTENDED WHEN THE FAN IS ON OR PLUGGED IN. -
This Fan must NOT be used in potentially dangerous locations such as flammable, explosive, chemical-laden or wet atmospheres where gasoline, paint or flammable liquids are used or stored.
-
DO NOT use Fan in or near a window. Rain may create an electrical hazard.
This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of electric shock, this plug is intended to fit in a polarized outlet only one way. Match wide blade of plug to wide slot. Fully insert. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. DO NOT attempt to defeat this safety feature. This plug is a safety feature, to reduce the risk of fire, electric shock and personal injury. DO NOT remove, replace, repair or tamper with the originally supplied plug. If the Fan does not function properly, it may be due to the safety device incorporated in this plug. Return to an authorized service center or call 800-233-0268, Monday – Friday, between 8:00 a.m. and 5:00 p.m. EST. If the plug warn-ing label is missing or damaged, call the toll free number for a replacement label. -
Where possible, avoid the use of extension cords because the extension cord may overheat and cause a fire. If you must use an exten-sion cord, minimize the risk of overheating by using the shortest cord possible and ensuring that it is UL listed. NEVER use a single extension cord to operate more than one Fan. DO NOT plug Fan into any other cord-connected device, such as a power strip, cord reel, surge protector, mutiple outlet adapters or outlet-type air fresheners. The use of such devices may create a fire hazard.
-
NEVER operate any Fan with a damaged cord or plug or after the Fan malfunctions, has been dropped or is damaged in any manner. There are no user serviceable parts. Return Fan to an authorized service facility for examination, electrical or mechanical adjustment or repair.
-
NEVER insert or allow fingers or foreign objects to enter any ventilation or exhaust opening as it may cause an electric shock or fire, or damage the Fan. To reduce the risk of fire, DO NOT block or tamper with the Fan in any manner while it is in operation.
-
Always place the Fan on a stable, flat, level surface when operating, to avoid the chance of the Fan overturning. Locate the Power Cord so the Fan or other objects are not resting on it. DO NOT run Power Cord under carpeting. DO NOT cover Power Cord with throw rugs, runners or the like. Arrange Power Cord away from room traffic and where it will not be tripped over.
-
This Fan is not intended for use in wet or damp locations. Never locate a Fan where it may fall into a bathtub or other water container. NEVER use Fan where flammable liquids are used or stored.
-
NEVER use Fan outdoors.
-
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.The user is cautioned that changes and modifications made to the equipment without the approval of manufacturer could void the user’s authority to operate this equipment.
-
This Fan is not suitable for use in agricultural facilities including areas where livestock, poultry or other animals are confined. Please refer to National Electric Code (NEC) Article 547-7 (2008), or applicable state or local codes or standards relating to electrical require-ments for Agricultural Buildings. THIS FAN DOES NOT MEET THE REQUIREMENTS OF NEC ARTICLE 547-7 (2008).
-
This Fan is not suitable for use in hazardous locations. Please refer to National Electric Code (NEC) Article 500 or applicable state or local codes or standards relating to electrical requirements for Hazardous locations. THIS FAN DOES NOT MEET THE REQUIRE-MENTS OF NEC ARTICLE 500 (2008).
WARNING
REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK – DO NOT USE THIS FAN WITH ANY
SOLID STATE SPEED CONTROL DEVICES.
OPERATION (Figure 1)
-
Carefully remove the Fan from the plastic bag and the carton.
-
Place the Fan on a firm and level surface.
CAUTION: Plastic or rubber tabs, like the feet on this unit, may stick to furniture surfaces and/or hardwood floors. The unit may leave a residue that could darken, stain or leave permanent blemishes on the finish of certain furniture sur-faces, including wood surfaces, and/or hardwood floors. -
Plug the cord set into a 120 volt outlet.
WARNING
Be sure that the plug fits tightly into outlet. When plugs fit loosely into receptacles, they may slip partially or completely out of the receptacle with only the slight movement of the attached cord. Receptacles in this condition may overheat and pose a serious fire hazard; if covered by a curtain or drape, the fire hazard is even greater.
-
To turn the Fan on, press the Power/Speed Button ( POWER ). The Fan will be in High Speed.
-
Pressing the Power/Speed Button ( POWER ) once more will put the Fan in Low Speed.
-
To turn the Fan off, press the Power/Speed Button ( POWER ) a third time.
-
After turning the Air Stik® Off, unplug the unit from the electrical outlet.
Oscillation Function:
This function will work in any Fan speed. Pressing the Oscillation Button ( )
will allow the Fan to circulate air more effectively by moving the Fan from
side to side in a sweeping motion. To stop the oscillation, press the
Oscillation Button ( ) once more. The Oscillation Button ( ) will light when
this function is in use.
TROUBLESHOOTING TIPS
If your Fan fails to operate, see below for a probable cause and solution:
- Be sure the power cord is plugged into a working electrical outlet. If you have a problem that can not be resolved by the steps listed above, contact Technical Assistance at 1-800-233-0268, Monday through Friday, between the hours of 8:00 a.m. and 5:00 p.m. EST.
MAINTENANCE
WARNING
To reduce the risk of electrical shock and fire please observe the
following instructions:
- Always unplug the cord before moving, servicing or cleaning.
- NEVER place the Fan in or near water.
- Clean the Fan only with a vacuum equipped with a brush attachment; the vacuum will remove the lint and dirt from inside the Fan.
- NEVER attempt to take apart the Fan.
- Clean the body of the Fan with a soft cloth only.
- NEVER use ALCOHOL or SOLVENTS such as gasoline, benzene, paint thinner, or other harsh cleaners.
SERVICING: All other servicing, with the exception of general user- maintenance, should be performed by an authorized service representative. Call 1-800-233-0268, Monday through Friday, between the hours of 8:00 a.m. and 5:00 p.m. EST for the location of your nearest service center.
STORAGE: Store the Fan with these instructions, in the original carton in a cool, dry place.
LASKO PRODUCTS, INC. LIMITED WARRANTY (NOT VALID IN MEXICO)
WHAT THIS WARRANTY COVERS: This product is warranted against defects in
workmanship and/or materials.
HOW LONG THIS WARRANTY LASTS: This warranty extends only to the original
purchaser of the product and lasts for one (1) year from the date of original
purchase or until the original purchaser of the product sells or transfers the
product, whichever first occurs.
WHAT LASKO WILL DO: During the warranty period, Lasko will, at its sole
option, repair or replace any part or parts that prove to be defective or
replace the whole product with the same or comparable model.
WHAT THIS WARRANTY DOES NOT COVER: This warranty does not apply if the
product was damaged or failed because of accident, improper handling or
operation, shipping damage, abuse, misuse, unauthorized repairs made or
attempted. This warranty does not cover shipping costs for the return of
products to Lasko for repair or replacement. Lasko will pay return shipping
charges from Lasko following warranty repairs or replacement ANY AND ALL
WARRANTIES, EXPRESSED OR IMPLIED (INCLUDING, WITHOUT LIMITATION, ANY IMPLIED
WARRANTY OF MERCHANTABILITY), LAST ONE YEAR FROM THE DATE OF ORIGINAL PURCHASE
OR UNTIL THE ORIGINAL PURCHASER OF THE PRODUCT SELLS OR TRANSFERS THE PRODUCT,
WHICHEVER FIRST OCCURS AND IN NO EVENT SHALL LASKO’S LIABILITY UNDER ANY
EXPRESS OR IMPLIED WARRANTY INCLUDE (I) INCIDENTAL OR CONSEQUENTIAL DAMAGES
FROM ANY CAUSE WHATSOEVER, OR (II) REPLACMENT OR REPAIR OF ANY HOUSE FUSES,
CIRCUIT BREAKERS OR RECEPTACLES. NOTWITHSTANDING ANYTHING TO THE CONTRARY, IN
NO EVENT SHALL LASKO’S LIABILITY UNDER ANY EXPRESS OR IMPLIED WARRANTY EXCEED
THE PURCHASE PRICE OF THE PRODUCT AND ANY SUCH LIABILITY SHALL TERMINATE UPON
THE EXPIRATION OF THE WARRANTY PERIOD. Some states and provinces do not allow
limitations on how long an implied warranty lasts, or the exclusion or
limitation of incidental or consequential damages, so these exclusions or
limitations may not apply to you. This warranty gives you specific legal
rights. You may also have other rights which vary from state to state and
province to province. Proof of purchase is required before a warranty claim
will be accepted.
CUSTOMER SERVICE:
Toll-Free 800-233-0268. Email:
producthelp@laskoproducts.com Our
Customer Service team is available to assist you with product questions,
service center locations, and replacement parts. They can be reached Monday
through Friday, 8am-5pm Eastern. Please have your model number available, as
well as the type and style (located on the underside of your product). Please
do not return product to place of purchase. Customer Service Dept., 820
Lincoln Ave., West Chester, PA 19380 (Please do not send product to this
location) www.laskoproducts.com Manual printed
in China
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>