Razor V1-4 Crazy Cart Instruction Manual
- June 13, 2024
- Razor
Table of Contents
Razor V1-4 Crazy Cart
Tools Required: (Not included)
A. 5 mm Allen wrench
B. 10 mm wrench
C. Flathead screwdriver
D. 19 mm wrench
WARNING
CAUTION: To avoid potential shock or other injury, turn power switch OFF and disconnect charger before removing or installing the charger port. Failure to follow these steps in the correct order may cause irreparable damage.
Installation Instructions
Step 1
Using a 5 mm Allen wrench, loosen the four (4) hex bolts that attach the seat
to the frame (Figure 1a) and remove seat. Remove the two (2) hex bolts on the
Drift Bar cover (Figure 1b) and remove.
Step 2
Using a 5 mm Allen wrench and a 10 mm wrench, loosen the two (2) hex bolts on
the side of the battery cover (Figure 2a) and the two (2) locknuts, located
underneath the unit (Figure 2b).
Step 3
Remove the battery cover by lifting up the right side first then slide off. Be
careful not to pull any of the wires that are attached to the cover.
Step 4
Disconnect the black wire from the charger port that is connected to the top
prong of the on/off switch (Figure 4a). Using a flathead screwdriver,
carefully remove the silicone from the back of the charger port (Figure 4b).
Step 5
Using a 19 mm wrench, loosen the locknut.
Step 6
Using a small pointed object, carefully depress the two (2) locking pins
inside the white plastic connector attached to the charger port and gently
pull them out of the connector. Remove charger port from battery cover.
Step 7
Reverse steps 1 through 6 to install replacement charger port.
ATTENTION: Charge battery 12 hours before initial use.
Customer Support
Need Help? Visit our website atwww.razor.com or call toll-free at 866-467-2967 Monday – Friday 8:00 AM – 5:00 PM PST.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>