CONNECT2 Aerpro QUADCAN Universal ISO Harness User Guide
- June 4, 2024
- Connect2
Table of Contents
CONNECT2 Aerpro QUADCAN Universal ISO Harness
APPLICATION
For Audi, BMW, Citroen, Ford, Mercedes Benz*, Seat, Skoda, Peugeot and
Volkswagen
vehicles with CAN-Bus systems and OEM Quadlock connectors
For use with non-amplified vehicles only
For vehicles with Audio20 head units and NTG2 system
FEATURES
- Provides an ISO connector for the installation of an aftermarket head unit
- Provides llumination, Accessory, Speed Pulse, Park Brake and Reverse Gear outputs
DISCLAIMER
The information provided in this document is subject to change without notice
due to manufacturer changes and/or improvements to the product/s. This
instruction manual is based on documented data and research. The manufacturer
of this product cannot be held responsible for any changes made to the vehicle
by the manufacturer or damages that may occur through the installation of this
product in accordance with the steps outlined herein.
PRIOR TO INSTALLATION
Read the manual prior to installation. Technical knowledge is necessary for installation. The place of installation must be free of moisture and away from heat sources. Please ensure that the correct tools are using during the installation to avoid damage to the vehicle or product. Connects2 can not be held responsible for the installation of this product.
WIRING KEY
AUDI/FORD/SEAT/SKODA/VOLKSWAGEN
BMW/MERCEDES
DIP SWITCH SETTINGS
In order to ensure that the interface functions correctly, before installation, set DIP switches 1 – 8 as below according to the vehicle manufacturer:
INSTALLATION GUIDE
Before installing the interface, the factory stereo must be removed and disconnected. To do this, please consult the vehicle owner’s manual/handbook or contact a fitting professional.
- Configure the Quadlock connector wiring and DIP switch settings as required for the vehicle application (see ‘Wiring Key’ and DIP Switch Settings’ – Pg. 2).
- Connect the main wiring harness to the interface box via the 14 pin molex connector.
- Connect the Quadlock connector to the OEM vehicle connector.
- Connect the ISO connector to the stereo.
- Connect any required flying wires from the main wiring harness to the vehicle to retain features (eg. speed pulse, park brake etc)
- Make sure all connections have been established and then turn on the ignition to test for correct operation.
CONNECTION DIAGRAM
Need help? Visit support.connects2.com/tickets/technical
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>