LITE-ON WPX8324 LED WiFi Router Owner’s Manual
- June 13, 2024
- LITE ON
Table of Contents
LITE-ON WPX8324 LED WiFi Router
Troubleshooting
The following table shows the status of the AP’s LED indicators.
WPX8324 LED Descriptions
LED Indicative| Color| Status| Description
Power| Green| Solid Light| Power on
Light off| Power off
2.4G| Green| Solid Light| Connect to WLAN port
Blinking| WLAN activity present
Light off| No activity or power off
5G| Green| Solid Light| Connect to WLAN port
Blinking| WLAN activity present
Light off| No activity or power off
LAN1 (PoE in)| Green| Solid Light| Device connected to LAN port at
10/100/1000Mbps
Blinking| LAN Activity present
Light off| Not Connected
LAN2| Green| Solid Light| Device connected to LAN port at
10/100/1000Mbps
Blinking| LAN/WAN Activity present
Light off| Not Connected
If the AP fails to connect to the cloud server, please check the following:
- Ensure that the Ethernet cable is plugged into the LAN 1(PoE) port, and LAN1 LED is NOT OFF.
- If the AP fails to get a valid IP address from the local DHCP server, ensure that the DHCP service is ENABLED on your router.
- Ensure there is Internet connectivity on the local LAN network to which the AP is connected.
Getting AP online
Step 1: Power up
Using PoE, plug one end of the Ethernet cable into the PoE switch or injector and plug the other end into the LAN 1 (PoE) port.
Step 2: Connect to the network
Make sure the PoE switch or injector is connected to your LAN network with Internet access.
Step 3: Check the LED status
Wait for a few minutes until the Power LED turns solid Green and LAN1 LED turns Blinking. The AP is then online for operation.
Federal Communication Commission Interference Statement
This product has been tested and found to comply with the limits for a Class A digital device pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This product generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the manufacturer’s instruction manual, may cause harmful interference with radio communications. Operation of this product in a residential area is likely to cause harmful interference, in which case you will be required to correct the interference at your own expense.
FCC Caution This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Non. modification Statement: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
FCC Radiation Exposure Statement)
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator & your body..
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>