FISHER PAYKEL ADDD24DTNX Integrated Double DishDrawer Installation Guide
- June 12, 2024
- Fisher & Paykel
Table of Contents
FISHER PAYKEL ADDD24DTNX Integrated Double DishDrawer Installation Guide
INSTALLATION GUIDE
Recessed Handle Accessory Door Panels
SAFETY & WARNINGS
⚠ WARNING!
Electric Shock Hazard
Failure to follow this advice may result in electrical shock or death.
· Read and follow the safety and warnings before operating this
appliance.
⚠ WARNING!
Cut Hazard
Failure to use caution could result in injury.
· Take care: some edges may be sharp.
- Ensure all packaging is removed and disposed of responsibly.
- Ensure the Knock-To-Pause module is oriented correctly before attaching.
- Repeat each step on both drawers.
COMPONENTS REQUIRED
DOOR PANEL INSTALLATION
1. Remove all tape and packaging.
Upper panel only:
Ensure exit duct tape is removed.
2. Remove both side pins with pliers and carefully pull the panel bracket down and out slightly.
3. Unplug knock-to-pause module from the controller and remove the earth wire from the bracket.
4. Remove the Knock-to-Pause module from the back of the bracket and refit to
the door panel.
Ensure the module is correctly oriented and is not in contact with the
brackets before securing.
5. Unclip the highlighted tabs to remove the exit duct from the top drawer of the product.
6. Open the drawer and press both locking tabs back 2″ (50mm) to allow the accessory door to be fitted.
7. Reconnect the Knock-to-Pause module to the UI 1 slot on the wash controller as shown.
8. Reconnect the earth wire to the panel bracket.
Warning: Failure to reconnect the Earth wire may result in electrical shock or
death.
9. Align the panel flat against the front of the tub before sliding it up
into place.
Ensure the pin holes on the tub and the door brackets align and that the upper
door seal is located correctly.
10. Re-insert both side pins to secure panel in place.
Pull both locking tabs forward.
For more information, visit www.fisherpaykel.com
431397A 03.23 US CA