MAXIMUM REPTILE ECO-25 Gallon PVC Enclosure Instruction Manual
- June 12, 2024
- MAXIMUM REPTILE
Table of Contents
MAXIMUM REPTILE ECO-25 Gallon PVC Enclosure
Product Information
This product is an enclosure designed for housing reptiles. It is made of PVC and comes with multiple panels that need to be assembled together. The enclosure has a bottom piece, front panel, left side panel, right side panel, top panel, and back panel. It is important to follow the assembly instructions carefully to ensure proper installation.
Product Usage Instructions
- Tools needed for assembly: Phillips head screwdriver.
- Before starting the assembly, read the entire instructions to avoid mistakes.
- Place the bottom piece of the enclosure on a table or bench, ensuring that the labels are facing down and the front arrow is facing you.
- Take the front panel and position it at a 90-degree angle to the bottom panel. Screw the parts together, making sure they are lined up correctly before adding the screws. Use a Philips head screwdriver and tighten the screws by hand to avoid over tightening. Set any drills to the lowest clutch setting.
- Locate the left side panel and screw it into place from the front and below until all the screws are in place.
- Repeat step 5 for the right side panel.
- Secure the top panel in place.
- Carefully place the enclosure facing down and screw the back panel into place.
- If you plan to add plants or a wet substrate layer, silicone around the bottom to prevent leaks when watering.
If you encounter any issues or have any questions during the assembly process or regarding any other matter, please contact our customer service team for assistance. You can reach us through our
Contact Us
For visual instructions, including full-color images, we recommend viewing the assembly guide online by clicking on the Assembly link in our FAQ section or scanning the provided QR code with your smartphone.
Tools needed are:
- Phillips head screwdriver
Please take a moment to read the entire instructions before beginning, to avoid making mistakes
Assembly Instructions
-
Place the Bottom piece of the enclosure on a table, bench or other slightly elevated surface. This is to allow space for you to screw the sides onto the Bottom panel. Important: Make sure the labels are facing down and the front arrow is facing you.
-
Now take the Front panel and position it at 90 degrees to the Bottom and screw the parts together, making sure it’s lined up with the Bottom before adding the screws.
As we pre-assemble these enclosures, please dial down any drills to the lowest clutch setting in order to not over tighten the screws. We recommend tightening by hand with only a Philips head screwdriver for best results. -
Now locate the Left Side and screw it into place from the front and from below until all the screws are in place.
-
ow do the same for the Right Side as shown.
-
The Top can now be secured in place.
-
By carefully placing the enclosure facing down, you can now screw into place the Back and your enclosure is now complete.
Like any PVC enclosure, if you are adding plants or a wet substrate layer, be sure to silicone around the bottom so that you don’t have any leaks when watering.
Should you run into any issues or have any questions regarding this assembly,
or anything else, please contact our customer service team for help.
https://customreptilehabitats.com/pages/contact-us
For full color images of these instructions, we recommend viewing online by
clicking on the Assembly link in our FAQ section, or just use the below QR
code on your Smart Phone.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>