MEE OP02 Open Bluetooth Earloop User Manual
- June 12, 2024
- MEE
Table of Contents
MEE OP02 Open Bluetooth Earloop User Manual
Product Diagram
- : Power on/off/Answer call/Hang up/Reject Volume up/Next track/Play/Pause
- :Volume down/Previous song/ SIRI voice assistant/ Game low latency
- Double-mic noise reduction
- Indicator
- Magnetic charging port
- Speaker
First Use:
- Press for 3s, the headphone will turn on and wait for connecting (flashing red and blue alternately);
- Turn on Bluetooth on the phone and search forOP02 and click it to connect;
Note: It is recommended to turn on Bluetooth on the phone before powering it on to use, which will make it easier to reconnect.
One-for-Two function
- Connect the headset to device A and turn off Bluetooth;
- Turn on Bluetooth on device Band search for OP02 to connect;
- Turn on Bluetooth on device A and then click the previous connection of OP02 to connect.
At this point, the headset has been connected to two devices at the same time.
Charge
Plug the cable into the charger and make the magnetic cord attach to the
contact pin firmly to start charging.
When charging, the red light will bean; and it will go off when charged to
full power.
Note: Please remove the charging cable from the charger when not charging.
Otherwise, it will lead to a short circuit.
Operation Instruction
Wearing Tips
Put the headset on the back of the neck, and the speakers to both ears when it is comfortable to wear.
Product Specification
Product Specification
Bluetooth Version: V5.3
Bluetooth Protocol: HSP, HFP, A2DP, AVRCP
Connection Distance:~ 12m
Battery type: 3.7V/90mAh
Music Time: 7h-8h
Calling Time: about 6h
Standby Time: about 80h
Charging time: about l hour and 20 minutes
Speaker Specification: 015.4mm±0.05
lmpedance:220
Voltage: 3.3V-4.2V
S/N:90dB
LED Indicator
Voice List
Warning
- Longtime listening to loud music may bring discomfort, please use about medium volume if possible, avoid using loud volume fora longtime.
- Regardless of the volume, the use of headphone will affect your perception of the sound of the surrounding environment, please be careful.
- Do not throw, sit on the headset or immerse it in water; headset should be away from fire, water and high-voltage facilities.
- Not suitable for kids under three.
Do not dispose it as household garbage, but to take it to local electrical and electronic equipment recycling center.
FCC Warning Statement
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment. Th is
equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna
- Increase the separation between the equipment and receiver
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
The device has been evaluated to meet general RF exposure requirement.