PSI Woodworking PKDBFBT High End Pen Kits

Product Information

The product is a C 6(D:?($>D;5D5(‘2>5D8726.

Product Usage Instructions

To use the product, please follow the steps below:

1. Step 1: Unbox the product and remove all packaging materials.
2. Step 2: Connect the product to a power source using the provided power cable.
3. Step 3: Turn on the product by pressing the power button located on the front panel.
4. Step 4: Use the control buttons or knobs to adjust the settings according to your preference.
5. Step 5: Refer to the user manual for specific instructions on how to utilize the product’s features and functions.
6. Step 6: When finished using the product, turn it off and disconnect it from the power source.
7. Step 7: Clean the product regularly using a soft cloth to remove dust and dirt.

If you encounter any issues or have further questions about the product, please refer to the user manual for troubleshooting steps or contact our customer support.

KIT FEATURES

• Antique Art Nouveau style
• Schmidt™ Iridium medium point pen nib
• Elegant, casted 3-dimensional design
• Overall length: 5-9/16″

REQUIRED ACCESSORIES

• 7mm, Pen Mandrel
• 10.5mm Drill Bit #PK105MM (lower tube)
• 0.492″ Drill Bit #PKPLI-DB (upper tube)
• 3-piece Bushing Set #PKDBBUA
• Barrel Trimmer Sleeves #PKMAIIRBTS (Use with 7mm Barrel Trimmer)
• Insta-cure (cyanoacrvlate) olue or 2-nart enovw glue

PREPARING THE BLANKS

• Cut 3/4″ or larger square blank to the length of the brass tube. Add 1/16″ to the length for squaring off.
• Using the .492″ drill bit, drill a centered hole through the upper blank. Drill a 10.5mm hole through the lower blank.
• Apply glue to each tube and insert into the proper blank with a twisting motion to spread the glue evenly inside. Center the tube in each blank.
• When glue dries, trim each tube end. Use a 7mm barrel trimmer with the proper trimmer sleeve. Trim the wood blank flush to the brass tube.

TURNING THE BLANKS

• Place spacer bushings onto the mandrel shaft. Insert the lager end bushing, large end first. Follow with the upper blank.
• Place the center bushing, large diameter in first, follow with the lower blank. Insert the smaller diameter bushing, small end first. Insert spacer bushings to close the space to the threads.
• Mount the locknut hand tight. Bring the tail stock snug to the mandrel shaft. Lock in place. Lock the knurled nut hand tight. Do not over tighten, it may bend the mandrel.
• Turn the wood down to the profile design. Sand the blanks down to match the bushings.
• Finish the barrels with your choice of PSI Polish.

ASSEMBLY – Fountain Pen

• Line up the pen parts.
• Press the cap assembly into the wide end of the upper barrel.
• Slide and press in the center band assembly into the opposite end of the barrel
• Press the couplers into both ends of the lower barrel.
• Mount either ink cartridge or pump reservoir onto the back of the fountain nib. Screw on this assembly onto the coupler assembly at the lower barrel.
• Screw on the lower cap into the opposite end of the barrel.
• Squeeze the ink into the fountain nib. The pen is ready to use.
• The cap will post over the lower barrel when in use.

BUSHINGS

PKDBBUA – BROADWELL Roller Ball/Fountain Pen Bushings

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>