SOMMER SOMlink S2 Service Interface User Manual

June 12, 2024
SOMMER

SOMMER SOMlink S2 Service Interface User Manual
Service Interface

General information

Notes on the correct use of the product
NOTE

  • Use only in dry rooms
  • Clean only with a dry cloth.
  • Dispose of the unit in accordance with local regulations

Information for the user
SOMlink S2 is only available to specialist retailers and may only be taken into operation by technical specialists.

Declarations of Conformity

Simplified Declaration of Conformity
SOMMER Antriebs- und Funktechnik GmbH hereby declares that the radio system of type SOMlink S2 complies with Directive 2014/53/EU. The full text of the EU Declaration of Conformity can be found at the following internet address:
QR Code
Declarations of Conformity

UKCA Declaration of Conformity
SOMMER Antriebs- und Funktechnik GmbH
Hans – Böckler – Straße 27 73230 Kirchheim unter Teck Germany

hereby declares that the products designated below, when used as intended, comply with the essential requirements of the Radio Equipment Regulations 2017 and that, in addition, the standards listed below have been applied.
DIN VDE 0620-1 (where applicable)
2016-01
EN 62368-1:2016-05 + AC:2015
2016-05
EN 62479:2011 2011-09
ETSI EN 300 220-2
V3.2.1 2018-06
ETSI EN 300 328
V2.2.2 2019-07
ETSI EN 301 489-1 V2.2.3
2019-11
ETSI EN 301 489-3 V2.1.1
2019-03

Information on the product

Intended use
With SOMlink S2 intelligent control technology, there are additional options for adjusting operator features and parameters with a web app using a smartphone, tablet PC or laptop. Communication between the SOMlink S2 and the operators takes place via a radio connection. Settings are made and information is read out within the user interface . The SOMlink S2 may only be used by technical specialists.

Improper use
Any use above and beyond that listed in the section “Intended use” is deemed to be improper. Opening the housing and modifications to the hardware are also deemed to be improper use.

Simplified Declaration of Conformity
SOMMER Antriebs- und Funktechnik GmbH hereby declares that the radio system of type SOMlink S2 complies with Directive 2014/53/EU. The full text of the EU Declaration of Conformity can be found at the following internet address:
QR Code
Declarations of Conformity

Useful links
SOMMER website www.sommer.eu

Installation and Operating Manuals
www.som4.me/man
SOMMERsuite
www.som4.me/sommersuite

Information on disposal
INFORMATION

  • This device is labelled in accordance with European Directive 2012/19/EU on used electrical and electronic devices (WEEE – waste electrical and electronic equipment).
  • ****This Directive provides the framework for the EU-wide return and recycling of used equipment.
  • Operator components that have been taken out of service as well as old accumulators and batteries must not be disposed of with household waste. Components which are no longer in use, old accumulators and batteries must be disposed of properly. You must observe the local and national regulations here. Contact your specialist retailer to find out more about current disposal channels.
    This device and its batteries are recyclable

Functional description
With SOMlink intelligent control technology, there are additional options for easily adjusting operator features and parameters with a web app using your smartphone, tablet PC or laptop. As all data are processed and saved in the SOMlink and the additional memory, Memo, there is no data transmission to external servers. The user logs in to the WiFi provided by the SOMlink S2 using a smartphone/tablet or PC, see “4. Initial operation” on page 8. The network name (SSID) and network key (key icon) are printed on the back of the SOMlink. The user interface can then be accessed via the browser or 10.0.0.1). Alternatively, the user interface can be accessed after establishing a connection via the Android app.

Compatibility
A list of compatible products can be viewed online at:
som4.me/somlinkservice

Technical data

Power supply input
Rated voltage 100–240 V
Rated frequency 50–60 Hz

Power supply output
Rated voltage 5 V
Rated current 1 A

SOMlink S2 input
Rated voltage DC 5 V
Rated current 1 A

Further data
Dimensions (without power supply unit) 102 x 80 x 28 mm
WiFi standard 2.4 GHz
SOMloq2 radio frequency 868.95 MHz (S13574) 868.3 MHz (S13575)

Components
Product Instruction

  1. USB A plug
  2. Power supply unit
  3. USB A cable
  4. Memo slot
  5. WiFi LED
  6. Status LED
  7. USB A socket*
  • Only for internal purposes in the factory

Flashing codes

Status LED Meaning
Lights up red No operator, radio receiver or Memo

connected
Lights up green
WiFi LED| Operator, radio receiver or Memo is
connected
Meaning
Off| SOMlink S2 starting up
Lights up green| Connected to WiFi
Blinks green| Device communicating via WiFi
Lights up red| No WiFi connection

Initial operation

Establishing operational status
TIP
So that you have the data to hand for later entry, make a note of the SSID and the WiFi password printed on the back of the device before plugging the SOMlink S2 in.
Plug Inserting

  1. Connect SOMlink S2 and power supply unit.
  2. Switch on voltage supply
    Voltage Supply

After approx. 20 seconds, both the WiFi LED and the status LED light up red

NOTE
In order to establish a connection between the SOMlink S2 and an end device, it is necessary to select one of the options described below.

Establishing a WiFi connection via Android app
QR Code

https://play.google.com/store/apps/details?id=sommer.somlinks2
App Downloading

  1. Download the SOMlink S2 app from the Google PlayStore and install it.
  2. Open the app.
  3. Follow the instructions for establishing a connection.
    Connection Instructions

The SOMlink user interface opens
✔ SOMlink S2 is ready for operation

Establishing a WiFi connection via QR code
NOTE
End devices with Android and iOS can be used to establish a connection by this method.
QR Code Scanning

  1. With the end device, scan the QR code on the back of the SOMlink S2.
    Connection

  2. Confirm that the device is to connect to the SOMlink S2.
    ⇒ Important for Android devices:
    As this is a local connection, it may be necessary at this point to confirm that the connection is to be established, although the WiFi provided by the SOMlink S2 has no internet connection.
    WiFi LED
    ⇒ WiFi LED switches from red to green
    Linking

  3. Open browser and access either
    http://somlink.lokal or IP 10.0.0.1.
    SOMlink
    ⇒ The SOMlink user interface opens
    ✔ SOMlink S2 is ready for operation

Establishing a WiFi connection via the network settings of the end device
TIP
All WiFi-enabled end devices, irrespective of their operating system, can be used to establish a connection by this method.
Network Settings

  1. Open the network settings of the end device.
    ⇒ The name of the SOMlink S2 network appears in the list of available WiFi networks. It matches the SSID printed on the type plate (SOMlink-XXXXXX)
    Select SOMlink

  2. Select the SOMlink S2 network.
    Enter Password

  3. Enter the password and confirm.
    WiFi LED
    ⇒ WiFi LED switches from red to green
    Linking

  4. Open browser and access either
    http://somlink.lokal or IP 10.0.0.1.
    SOMlink User Interface Opens
    ⇒ The SOMlink user interface opens
    ✔ SOMlink S2 is ready for operation

SOMMER Antriebs- und Funktechnik GmbH
Hans-Böckler-Straße 27
73230 Kirchheim/Teck
Germany
info@sommer.eu
www.sommer.eu
© Copyright 2022 All rights reserved.

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals