KOHLER K-4663 Toilet Seat Installation Guide
- June 12, 2024
- Kohler
Table of Contents
KOHLER K-4663 Toilet Seat
Tools Needed
Installation Instruction – Pail Flush Toilet
-
Install the toilet.
-
Install the screw set and toilet seat.
Remove this label before using the product
Install the Toilet Seat
-
Snap open the two hinged lids, or caps, that cover the seat bolt holes. Slip the metal washers on the bolts, and fit the bolts through the hinges from the top. Fit the rubber or foam gaskets on the bolts.
-
Position the seat on the toilet so the bolts fit through the toilet seat-mount holes.
CAUTION: Risk of product damage. Do not overtighten the bolts.
Hand tighten the bolts if the toilet is equipped with pre-installed metal nuts. -
If the toilet seat-mount holes do not have pre-installed metal nuts, loosely thread the nuts on the bolts.
-
Tighten the bolts from the top, holding the nuts if necessary. Center the seat as needed.
-
Snap the hinged lids, or caps, closed.
Care and Cleaning
Clean the outside surface of your toilet seat with mild soap, such as liquid dish soap and warm water. Wipe the entire surface completely dry with a clean soft cloth. Do not use any abrasive cleaners, as they will scratch and dull the surface. Avoid any detergents, disinfectants, or cleaning products in aerosol cans. Avoid contact with abrasive chemicals and cosmetics, such as fingernail polish and aftershave, as they may damage the finish of your toilet seat.
Call Center: +(6 6) 2204-6222
callcenterthailand@kohler.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>