Chill-O-Matic IN1500BKB Automatic Beverage Chiller Instruction Manual
- June 12, 2024
- Chill-O-Matic
Table of Contents
CARE & MAINTENANCE
INSTRUCTION MANUAL
Model no. IN1500BKB / IN1500WHB
BATTERY INSTALLATION
Congratulations on your purchase of the Chill-O-Matich Automatic Beverage Chiller. You’re just moments away from having ice-cold drinks anytime you want, without a cooler or refrigerator!
- Find the battery compartment on the side of the Chill-O-Matich unit.
- Slide the battery door up to reveal the battery compartment.
- Install the batteries in the direction as shown.
- Slide the battery compartment door back onto the unit. Then turn on the unit to confirm correct installation.
NOTICE
Please use 2 AA batteries. Use the polarity markings to install in the correct
orientation. Do not mix different batteries, battery types or old batteries
with new batteries.
CAUTION
If the Chill-O-Matich unit will not be used for extended periods of time,
please remove the batteries. This will help prevent leakage and/or corrosion
within the unit.
NOTE
The suction cup is designed to be easily separated from the battery housing.
This will help with easy can removal and prevent any possible jamming should
the ice level be too high. If it becomes separated, then simply plug it back
in the hole.
QUICK START GUIDE
-
Remove Lid and Spinning Motor
Make sure you have 2 AA batteries installed. -
Attach Your Drink
Attach the bottom of your drink to the suction cup.
Slide your drink and the spinning motor back in main chamber. -
Add Ice – Not Too Much!
Ice should fill the bottom and sides. You don’t need to overfill it! -
Close and Spin!
Your drink will be ice cold in 60 seconds!
For Best Results
- Firmly attach the bottom of the drink can to the suction cup.
- You do not need to place a lot of ice in the machine for it to operate.
- If the lid does not easily fit back on top, then please remove excess ice.
- The can should spin easily. If not, please remove ice that may be blocking it from doing so.
- Turn on the unit and leave on for approximately 60 seconds for an ice-cold drink.
- For an even colder drink, leave on for approximately 80-90 seconds. The temperature will be approx. 47º after 60 seconds or approximately 42º after 90 seconds.
NOTE
The Chill-O-Matic will not work with bottles. The unit will only work with 12
oz. drink cans or smaller.
For Customer Service or if you need to service your product please email:
Service@BandDGroup.com
Please note the product model number, your name and phone number in the email
message.
IN1500BKB
Automatic Beverage Cooler
Contents:
| • One Automatic Cooler unit w/ top and suction cup | Actual product may differ |
|---|---|
| • Instruction Manual | slightly from photograph. |
LIMITED 30-DAY WARRANTY
B&D Group, LLC, warrants to the original consumer that its products are free
from any electrical or mechanical defects for a period of 30 days from the
date of purchase. If any such defect is discovered within the warranty period,
B&D Group, LLC. will repair or replace the unit free of charge upon receipt of
the unit, shipping postage prepaid and insured to the factory address received
from Customer Service. The warranty covers normal consumer use and does not
cover damage that occurs in shipment or failure that results from alterations,
accident, misuse, abuse, neglect, wear and tear, inadequate maintenance,
commercial use, or unreasonable use of the unit. Removal of any panels voids
all warranties. This warranty does not cover cost of repairs made or attempted
outside the factory. Any appicable implied warranties, including warranties of
merchantability and fitness are hereby limited to 30 days from the date of
purchase. Consequential or incidental damages resulting from a breach of any
applicable express or implied warranties are hereby excluded. Some states do
not allow limitations on the duration of implied warranties and do not allow
exclusion of incidental or consequential damages, so the above limitations and
exclusions in these instances may not apply. The only authorized service
center in the United States would be expressly communicated from Customer
Service. Ship the unit carefully packed, preferably in the original carton,
and send it prepaid, and adequately insured. Include a letter detailing the
complaint or issue, along with your daytime telephone number, name and address
inside the shipping carton. If your warranty has expired and you want an
estimated fee for service, write to
Service@BandDGroup.com, specifying the model
number and the problem.
PLEASE DO NOT SEND YOUR UNIT WITHOUT RECEIVING AN ESTIMATE FOR SERVICING. WE
CANNOT STORE YOUR UNIT.
MADE IN CHINA
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>