BSJ GD02R Mobile Digital Video Recorder User Manual

BSJ GD02R Mobile Digital Video Recorder

Product Information

• WCDMA bands: B2/4/5
• LTE bands: B2/4/5/12/13/14/66/71

This device is designed to operate on the WCDMA and LTE networks. The supported WCDMA bands are B2, B4, and B5, while the supported LTE bands are B2, B4, B5, B12, B13, B14, B66, and B71. Please ensure that your network provider supports these bands for compatibility. It is important to note that any changes or modifications to this device not explicitly approved by the manufacturer may void your authority to operate this equipment. This device complies with part 15 of the FCC Rules, which ensures that it does not cause harmful interference and accepts any interference received, even if it may cause undesired operation. To comply with FCC radiation exposure limits, it is recommended to install and operate this equipment with a minimum distance of 20cm between the radiator and your body. This precaution ensures that the device operates within the specified safety limits.

Product Usage Instructions

1. Ensure that your network provider supports the WCDMA and LTE bands mentioned above.
2. Insert a compatible SIM card into the device.
3. Power on the device by pressing and holding the power button.
4. Wait for the device to establish a network connection. The network indicator should show signal strength.
5. Once connected, you can use the device for various activities such as making calls, sending messages, and accessing the internet.
6. When not in use, it is recommended to keep the device at least 20cm away from your body to comply with FCC radiation exposure limits.
7. To power off the device, press and hold the power button until the device shuts down.

Product Composition

Product Overview
The vehicle video monitoring terminal device integrates 4G communication, GNSS positioning, ADAS, and DMS, supports audio and video recording, SD card storage, driving data recording, two-way calling initiated by the monitoring platform, real-time monitoring and other functions. Support seamless integration with customer platforms. Widely used in taxis, online hailing, minivans, construction vehicles, and other industries.
Product Specification

• Product Name: Mobile Digital Video Recorders
• Product model: GD02R
• Product size: L161mmW124mmH41mm

Product Configuration List
Table 1 Standard list

Name Quantity Remark

host                       1 Set|
Power Cable!PCS| 10 PIN, including power cable and 10 detection cable
GNSS positioning antenna       1 PCS|
4G Communication Antenna!PCS|
Power Key                  ! PCS| For device opening and closing
Screw                      4PCS| fixed equipment
User manual! PCS|
Neutral Packing Box! PCS|
ADAS camera               !PCS| 720P/1080P, built-in Al

alert speaker

ADAS camera extension harness!PCS| 3M
DMScamera                 1 PCS| 720P/1080P
Note: The above is a list of the standard configuration of the complete set of products, and accessories that are out of the above range must be paid an extra fee

Optional List

Name **Remark**

V512H Plastic conch camera| AHD 720P(With infrared and audio)
Camera extension cable| 5/lOmeters
AV screen| 7 inch

RS232 wire harness

| Connect external facility, such as fuel

sensor, temperature sensor and so on.

SD card| Class 10
Intercom pick-up| For hands-free intercom
Speaker| Used for call, voice broadcast (Overspeedbroadcast, etc.)
Audio conversion wire| Connect the speaker and intercom pickup
Velcro| Fixed host
SOS Button|
Nylon cable ties| Fixed wiring harness
Note: Have to equip the intercom pickup, speaker, and audio conversion wire if want the remote intercom function which inits iated by the monitoring platform.

Machine Parameters

Technical indicators

Technical Item Technical Specifications

Operating S stem| Operating System| Linux

Hardware

| MCU| 4coresA7
ROM| 8GB
RAM| 1GB

Video

| AHD720P/ /1080P| 4 channels 720P (1230•120) or 1 080P (1920’1080 )
Output| 1 channel VGA

Audio

|

Input

Output

| 3- channel audio (Format PCM), AV3,AV4,MIC

2-wayaudio (Format:PCM), speaker and Al reminder speaker

Display| Screen display| Quad split screen display

Video Recording

| Video and audio

com ression format

| Audio g711A, video H.264
Image Resclution| 20P (12so•120) or 1osoP (1920·1oso)

Video Recording

| Real-time Video| 4 channels
---|---|---
ACC off, time-lapse video| Default300s,

Delay parameters range: 10-65535s

Playback

|

Playback Channel

| Support local 4-channel synchronous playback, single-channel playback

in monitor terminal

Network

|

3G/4G

|

WCDMA: B2/4/5

LTE:B2/4/5/12/13/14/66/71

Note: Different countries or regions need to choose different communication modules due to the differences of communication operations, please ask sales for details.

Storage|

SD

| Double SD cards(Maximum of Single Card is 256 GB)

Interface Characteristics

Interface Characteristics Interface Description

Interface

| Front USB interface| Al (ADAS and DMS) calibration, parameter setting

SIM Card

| Single card ( for GNSS data upload and video data transmission)

SD Card

| Double SD cards(single card supports up to 256 GB)
DMS| Connect to DMS camera

Interface

| ADAS

AV3-AV4

| Connect ADAS camera

Connect AHD camera

---|---|---
12VOUT| Power supply for VGA display
VGA| VGA signal output, optional external VGA display
MIC| Pickup for two-way intercom

and audio monitoring

TTS| Two•wayconversation, voice broadcast
RS232 interface| Connect to external facility:s uch as

fuel sensor,temperaturesensor and so on

Other Charact- eristics

| Working Voltage| DC 9-36V
Working Current| 300 mA@l2V; 150 mA@24V (No load)
Stand-by power

consumptio n

| 60mA@l2V; 30mA@24V
Backup Battery| It can work for 15Safter the device is powered off
Host dimension| Ll 6l mm*Wl 24mm’ H4l mm
Host weight| About600g
Working Temperature| -25°C – +SO’C
Storage Tem peratu re| -40°C – +85’C

Product Interface Definition and Wiring Instructions

Interface Definition Drawing of the Back Panel
Table 1 POWER/IO interface definition

Table 2 Definition of RS232 port

Table 3 TTS interface definition

Table 4 VGA interface definition

9

11

| NC

NC

| NC NC| 10

12

| GND

NC

| Ground NC
13| VGA HS| Horizontal sync (line)| 14| VGA VS| Vertical Sync (Vertical)
15| BOOT| Self test| I| I| I

‘

Interface definition

GD02R Connection Diagram

Definition of Indicator Light Functional operation

Online Setting

|

IP Setting

| Send instructions via SMS or text

messages on the monitoring terminal :

<SPBSJ• P: BSJGPS

• D:047.100.237.015,7788’T: 047.100.237.015,6608’A:CMNET,admin,1

23456*N:13333223344>

Note:D is IPl; Tis lp2;

---|---|---

Domain name setting

| <SPBSJ• P: BSJGPS

‘D:vdata.car900.com,7788’T:vdata.car9 DO.com’ A:CMNET,admin,123456*N:1333 3223344>

Note:D is IPl; Tis lp2

Online parameter checking|

Parameter

checking

| Send command via SMS: or

platform text message:<EXTCB>

Check the firmware version via SMS|

Check firmware version

|

Send the command via SMS:

Check

version

via platform

|

Check all

version

|

Send the command: through the platform.

Note: The IP unified format is: 219.133.034.098,7788, where the IP field, less than 3 digits, is padded with O;

The uniform format of the domain name is: data.car900.com,7788

Analysis of Common Problem and Solutions

Malfunction
The device is not online| Reason Analysis

SIM card is out of balance

| Solution

Contact the network operator to recharge

---|---|---
Online parameter setting error| Refer to the manual to reset the parameters
SIM card Defective contact| Re-installs card
Communication antenna

ls abnormal

| Re-install or replace the communication antenna
The vehicle is in an underground parking lot, or the tunnel signal is weak| Stay out of poor

signal areas

The video ca n1   t open| SIM card is out of balance| Contact the network operator to recharge
The security cover is opened| Please lock it
ACC off| Check ACC wire
The vehicle is in an underground parking lot, or the tunnel signal is weak| Stay out of poor signal areas

Unable to  locat e

| Vehicles in underground

parking lots, or the tunnel signal is weak

| Stay out of poor signal areas
---|---|---

The positioning antenna is installed too close to the host

| The antenna is more than 0.8meters away from the device
Positioning antenna is blocked| Remove obstruction

Positioning antenna open circui

| Tightenthe antenna interface or check the line

Positioning antenna failure

| Replace the

posit ioning antenna

Posit ioning antennas are

intertwined with other lines

| Positioning antenna try to route separately, away from the device by 0.8 meters

or more

Can’t Video reocrding

|

SD card failure

|

Replace new SD card

ACCoff

Lock is opened

| Connect ACC wire

Locked

 | Manually stop the video| Turn on recording with

remote commands

Unable to recognize disk|

SD card failure

| Please confirm whether

the SD card is inserted

in place

Precautions:

1. Please do not intertwine the 4G antenna, positioning antenna,  video cable, and power cable during installation. They need to be routed separately. In order to reduce interference, the position of 4G and positioning antenna and the device should be kept at 0.8 meters or more, and the antenna should not be blocked by metal objects.
2. The device will only start recording when the ACC is on and the door lock is off. You can observe the blue and yellow indicator lights (refer to the status description of the indicator lights) to confirm whether the device is recording normally. Every time the device is powered on, it will automatically detect the status of the storage medium. If the storage medium is not inserted or the storage medium is damaged, the device will give a voice prompt that the storage device is abnormal.

FCC

FCC Warning:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipmentoff and on, the user is encouraged to try to correct the interference by one or more of thefollowing measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Caution: Any changes or modifications to this device not explicitly approved by the manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator and your body.

Warranty Notice:

1. Please present it together with the purchase receipt during maintenance. If the information matches, the warranty will be valid.
2. If you find that the model and code registered on this card have been altered or the model and code of the purchased machine are different, please contact our company in time.

Warranty Card

• Product Name: Mobile Digital Video Recorders
• Product Model Number: GD02R

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>