tessa TSA8072 Automatic Foaming Soap Dispenser User Guide
- June 4, 2024
- tessa
Table of Contents
tessa TSA8072 Automatic Foaming Soap Dispenser
SAFETY INSTRUCTIONS
- Read this instruction manual carefully, even if you are familiar with the appliance. Keep the manual for future reference.
- Avoid using/storing the product it in extreme temperatures. Do not expose it to direct sunlight and sources of heat.
- Product intended for household use only.
- Do not use the product for purposes different from displayed in this operating manual.
- Keep the appliance out of the reach of children.
- Place the appliance on a dry, flat and stable surface.
- Do not drop the device or subject it to strong impacts.
- Do not place the appliance in water or any liquid; nor handle/use it with wet or moist hands.
- Do not attempt to repair this appliance yourself. Never disassemble this appliance.
- In case of damage, contact with an authorized service point for a check-up/repair
PRODUCT DESCRIPTION
- On/off switch
- Battery compartment
- LED diode
- Spout
- Motion sensor
- Soap container
BATTERY INSTALLATION
- Open the battery compartment.
- Install 3x AA batteries, according to polarity.
- Close the battery compartment.
Notes:
- Use only specified batteries.
- Do not mix different types of batteries.
- Replace all batteries at the same time.
FILLING THE CONTAINER
The foaming soap dispenser is compatible with liquid or foam soap. It is recommended to use a foam soap to achieve better results. To dilute ordinary liquid soap, the ratio of water to soap is recommended to be 3~8:1 (depending on used liquid). Avoid using liquids that are too thick. Do not use with granular or pearlescent soaps.
- Separate the container from the dispenser by pulling its bottom.
- Remove the plug.
- Pour soap (and water in case of liquid soap) inside the container. Do not overfill as this may cause dripping.
- Replace the plug.
- Replace the container.
USE
- Press the on/off switch to turn on the device. Green LED is on for a while.
- Place your hands under the spout to activate the motion sensor. For the first time use,it maybe necessary to repeat thisprocess several times until the foam soap begins to dispense. The device will automatically dispense foam soap (a green LED is on during dispensing). When the device is on, it will dispense foam soap every time it senses motion under the spout within the required distance.
- Wash your hands.
- Press the on/off switch to turn off the device. Red LED is on for a while.
CLEANING AND STORAGE
- Prior to cleaning, make sure the device is switched off.
- Gently wipe the housing of the dispenser with a soft, slightly damp cloth. Wipe the motion sensor with a soft, dry cloth.
- Clean the inside of the soap container by rinsing it under running water. Leave it to dry completely in an open air.
- Batteries should be removed from the device if it is not going to be used for a long period of time.
Disposal
It is forbidden to place equipment waste marked with the symbol of a crossed- out trash bin together with other waste. This equipment is subject to collection and recycling. The harmful substances it contains can cause environmental pollution and pose a threat to human health. Made in China for LECHPOL ELECTRONICS Sp. z o.o. Sp.k., ul. Garwolińska 1, 08-400 Miętne
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>