FACTION BATTLE SYSTEM Sentinel Turret Gel Bead Blaster User Guide
- June 12, 2024
- FACTION BATTLE SYSTEM
Table of Contents
SENTINEL TURRET
GEL BEAD BLASTER
QUICK START GUIDE
SCAN FOR
INSTRUCTIONS http://www.FactionBattle.com/support
Sentinel Turret Gel Bead Blaster
This blaster has been disabled for safety and will not fire. It will flash
yellow/red until unlocked.
FOLLOW STEPS 1 THRU 3 TO UNLOCK & RE-ENABLE YOUR BLASTER
IT’S A BLAST! – WITH OR WITHOUT THE APP
Once unlocked, the Faction Sentinel works like any other gel bead blaster. It
will not require any further connection to a phone or app to work. Just turn
it on, load it up with gel bead ammo and blast away!
Connecting with the app is highly recommended however, as it will take your
blasting game experience to a whole new level. When connected to the app,
certain blaster functions (such as Firing Mode selection, LED lights, and the
ability to fire) may be controlled by the app during gameplay. Full control
may be restored at any time by closing the app and powering your blaster on
and off.
Unfold and insert tripod into blaster. Turn lock knob to secure in place.
INITIAL SET-UP
-
CHARGING YOUR BLASTER
Plug charging cable into blaster and charging port. (Use included cable only)
-
DOWNLOAD THE FREE FACTION BATTLE SYSTEM APP
Scan or visit FactionBattle.com to download and install the FREE Faction Battle System app. Update your phone to its most current operating system for best performance.
http://www.FactionBattle.com/app -
PAIR & UNLOCK YOUR BLASTER THROUGH THE APP
Ensure your phone’s Bluetooth is on.
Launch app, then turn blaster on to initiate pairing. (If blaster is already on, but not flashing blue, quickly turn off then on again to re-initiate pairing).
Follow in-app instructions to select Faction Sentinel. Blaster will pair, automatically unlock and be ready for use. Once paired, blaster will auto-pair to your phone whenever both the app is open and blaster is turned on.
Should pairing fail, turn blaster off then on again and re-attempt connection.
NOTE: Faction blasters ONLY connect through the app. Blaster will not appear in your phone’s Bluetooth settings. It can only connect when app is open and running and it will automatically disconnect when app is closed.
You can pair a blaster to a different phone by following the same steps.
Just be sure to close app on original phone until blaster has successfully paired with new phone.
THE SENTINEL GEL BEAD BLASTER
APP SUPPORTED FUNCTIONS REQUIRE PAIRING AND CELLULAR DATA.
ADJUSTABLE TILT
Support the tripod stand to the ground with one hand, then tilt the blaster up
and down as desired.
POINT AND BLAST REMOTE CONTROL
Point and blast from up to 100 ft (30m). Turn the dial on the remote in the
direction you want to aim and Sentinel will rotate and point in the exact same
direction. Press the button on the side to fire!
PREPARING GEL BEADS
Pour dehydrated beads into water.
Too little water may prevent beads from fully expanding and cause jams, misfires and poor performance. If in doubt, add more water.
CLEARING A JAM:
Turn power off and remove ammo clip. Shake blaster sharply 3 or 4 times to
clear chamber, then fire the blaster to ensure the jam is resolved. Smack ammo
clip against your hand to free any clip jam. If still jammed, spray canned air
into upper chamber to loosen until jam drains down barrel. Never stick any
object into barrel, upper chamber or ammo clip as it may worsen jam or cause
damage.
LOADING THE AMMO CLIP
Ages 14+
ADULT SUPERVISION REQUIRED:
- EYEWEAR REQUIRED: DO NOT AIM AT EYES OR FACE. Misuse or careless use may cause serious injury, especially to the eye. Impact from gel beads may cause temporary marks on skin. Gel beads may stain. Eye protection must be worn by user and any person within range. Use only Faction brand gel bead ammo. Use only clean tap water to hydrate gel beads. Do not freeze or modify gel beads. Included eyewear intended only for use with Faction gel blasters.
- The eyewear is intended to be used only with Faction gel bead blaster. Failure to follow all these instructions or adhere, or both, to all these warnings may result in serious or permanent injury. Never remove the googles while using gel bead blasters. Wear the goggles whenever using a gel bead blaster and whenever in or near an area where gel bead blasters are being used. Check the lens before and after use and replace the goggles immediately if any cracks are observed anywhere in the lens. Do not play with gel bead blasters if the lens is subject to a direct impact and develops a crack or fracture or damage of any kind and replace the goggles immediately. Clean the goggles with tap water. The goggles are suitable for age 14+. Not for use in low light conditions.
- DO NOT BRANDISH IN PUBLIC: DO NOT BRANDISH THIS PRODUCT IN PUBLIC as it may cause confusion and may be a crime. This product may be mistaken for an actual firearm by authorities and or other law enforcement agencies. Any alteration of state or federal recommended markings, coloration, or alterations in order to make the product appear more realistic is dangerous and may be a crime.
- CHECK LOCAL LAWS: Criminal penalties may be possible under state & federal law from use of a replica firearm in a prohibited or threatening manner. Consumers should confirm the lawful use of this product with local authorities before using in public spaces as laws may vary.
REMOTE BATTERIES
Open compartment door and install new batteries.
SMART BEACON ASSEMBLY
Press and momentarily hold to turn ON. Press and hold again to turn OFF. Refer to app set-up instructions for use with app.
PLAYING TARGET PRACTICE (NO APP)
Turn beacon on. Blast the beacon when it turns BLUE, but don’t blast it when
the light turns off.
TROUBLESHOOTING
Blaster is flashing yellow and red.| Blaster is still locked. Download Faction
app and follow instructions for one-time pairing and unlocking.
---|---
Blaster is solid blue, but blaster does not fire.| – Check firing mode switch
to ensure the safety lock is not selected.
– Firing ability may be suspended by app control. Close app and turn blaster
off and on to regain full control.
– Blaster may be jammed. Follow instructions for clearing a jam.
– If still unresponsive, turn blaster off then on again.
Blaster works fine, but app is not connecting or cannot see it.| Ensure your
phone’s Bluetooth is turned on and the app has permission to use it. With the
app open and running,
turn blaster off the on again to restart the pairing process. If previously
paired, blaster should auto-pair.
Blaster is blinking red or firing slowly.| Blaster power is running low.
Follow instructions for charging.
Gel beads aren’t firing correctly or are rolling out of the blaster barrel.|
Gel beads may not be fully hydrated. Allow more hydration time and add water
if partially hydrated beads
are floating above the water level.
Remote is blinking or blaster is not responding to remote.| Blaster is not
connected to remote or has lost connection. Turn blaster and remote power off,
then turn back on to
re-establish connection.
BLASTER
THIS PRODUCT CONTAINS A LITHIUM-ION BATTERY:
Li-ion batteries have a severe risk of fire and injury if they are improperly
handled or misused.
They may explode, overheat or ignite. Do not open, crush or modify this
product. Do not incinerate or heat above 113ºF / 45ºC. Read all directions
regarding use, care and disposal.
Read all following precautions and instructions regarding the care and use of
Li-ion batteries.
- Keep away from flammable materials.
- Do not expose to direct sunlight.
- Do not place in a fire or leave in hot places.
- Do not drop or make subject to strong impact.
- Keep dry and away from water.
- The supply terminals are not to be short circuited.
- Never throw into a fire or attempt to open outer case.
- Do not stress, press or drop.
- Never charge unattended. When charging you should always remain in constant observation to monitor the charging process and react to potential problems that may occur.
- Disconnect charging cable if fully charged.
- Never store or charge inside a car in extreme temperatures, since extreme temperature could ignite fire.
- Use caution to avoid puncture. Puncture of battery may cause a fire.
Li-ion Battery Disposal: Li-ion batteries must be recycled or disposed of
properly.
They should not be disposed of with other household waste. Check your local
laws and regulations for correct recycling and/or battery disposal.
BEACON + REMOTE
AAA BATTERY WARNINGS & SPECIFICATIONS:
- Do not use rechargeable batteries.
- Non-rechargeable batteries are not to be recharged.
- Do not mix old and new batteries and Do not mix alkaline, standard (carbon-zinc) or rechargeable (ni-cad, ni-mh, etc.) batteries.
- Batteries are to be inserted using correct polarity.
- Remove exhausted batteries as soon as possible and discard properly.
- Remove all batteries from compartment if beacon is not used for a long period of time.
- The supply terminals are not to be short circuited.
- Batteries should be replaced by an adult.
- Never throw batteries in a fire or attempt to open the outer casing.
WARNING: Batteries are harmful if swallowed. Please keep away from
children.
Battery Disposal: Dispose of batteries according to the local laws and
regulations of your region. Some batteries may be recycled, and may be
accepted for disposal at your local recycling center.
If you are not able to identity the application rules in your areas, please
check the instructions of the battery manufacturer.
This device complies with PART 15 of the FCC Rules. Operation is subject to
the following two conditions.
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
CAUTION: Changes or modifications to this unit not expressly approved by
the party responsible for compliance could void theuser’s authority to operate
the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna
- Increase the separation between the equipment and receiver
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
- Consult the dealer or an experienced radio/TV technician for help.
SKYROCKET TOYS 30-DAY LIMITED WARRANTY
Skyrocket warrants to the original purchaser that this product is free of
defects in materials or workmanship for 30 days from the original purchase.
This warranty only applies to defects in material and workmanship and is not
valid if the product has been misused or not assembled and maintained per
instructions. Proof of defect or malfunction must be provided and verified,
along with original sales receipt with date. For quickest resolution,
defective product should be returned to the original point of purchase for
exchange or refund. If you have questions or difficulties, please contact
Skyrocket Toys customer service department at
support@skyrockettoys.com.
WARNING: This produces flashes that may trigger epilepsy in sensitized
individuals.
Google Play is a trademark of Google Inc. – Apple, the Apple logo, the iPhone
and the App Store are trademarks of Apple Inc., registered in the U.S. and
other countries. The App Store is a service mark of Apple inc.
©2023 Skyrocket LLC, Los Angeles, CA 90292 USA. All Rights Reserved. Faction
and the Skyrocket logo are trademarks of Skyrocket LLC.
Other trademarks and trade names are those of their respective owners, and
there is no relationship express or implied with Skyrocket LLC.
MADE IN CHINA
Item # 18588 | SENTINEL FCC ID: O531858824G |
---|---|
Item # 18588R | REMOTE FCC ID: O5318588R24G |
Item # 18586B | BEACON FCC ID: O5318586B24G |
Questions or comments?
Please emailsupport@skyrockettoys.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>