Ohuhu Y13-80400-02 Door Draft Stopper User Manual
- June 15, 2024
- Ohuhu
Table of Contents
Ohuhu Y13-80400-02 Door Draft Stopper
Installation Steps
- Measure the gap cut width, and then door the excess part.
- Clean and dry the bottom of the door.
- Peel off the adhesive tape.
- Stick the door stopper to the bottom of the door.
Friendly Reminders
- Please make sure the door surface is clean and dry before installing the door stopper.
- When sticking the door stopper, make sure its bottom slightly touches against the floor, but not too much.
- After sticking the door stopper, do not open or close the door frequently within 24 hours.
- After installation, please press hard on the door stopper to secure it tight.
- If you want to tear off the door stopper, you can use a hair dryer to heat it first, drip alcohol on the adhesive tap of the door stopper, and peel it off carefully.
Specifications
Step | Action | Illustration Description |
---|---|---|
1 | Measure and cut | An illustration showing hands measuring the gap at the |
bottom of a door and marking the door draft stopper for cutting.
2| Clean and dry| An illustration depicting hands cleaning the bottom edge of
a door with a cloth.
3| Peel off adhesive| An illustration showing hands peeling off the protective
strip from the adhesive side of the draft stopper.
4| Apply to door| An illustration presenting the application of the door draft
stopper to the bottom of a door.
FAQ
How do I measure the door gap correctly?
- Measure the gap at the bottom of the door, then cut the door draft stopper to match the width, removing any excess material.
What should I do if the door stopper is not sticking properly?
- Ensure the surface is clean and dry, press firmly on the stopper after application, and avoid opening the door frequently for the first 24 hours.
Can I remove the door stopper after installation?
- Yes, to remove the door stopper, heat it with a hair dryer, apply a few drops of alcohol to the adhesive tape, and carefully peel it off.
Installation Steps
- Measure the gap and door width, and then cut the excess part.
- Clean and dry the bottom of the door.
- Peel off the adhesive tape.
- Stick the door stopper to the bottom of the door.
Friendly Reminders
- Please make sure the door surface is clean and dry before installing the door stopper.
- When sticking the door stopper, make sure its bottom slightly touches against the floor, but not too much.
- After sticking the door stopper, do not open or close the door frequently within 24 hours.
- After installation, please press hard on the door stopper to secure it tight.
- If you want to tear off the door stopper, you can use a hair dryer to heat it first, drip alcohol on the adhesive tap of the door stopper, and peel it off carefully.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>