Voion BF002 Smart Bird Feeder with Camera User Manual

Smart Al Recognition Bird Feeder
Product manual

BIRD FEEDER STRUCTURE

BIRD FEEDER SPECIFICATION

SOLAR PANEL SPECIFICATION
IPCE| 19%
Working voltage(Vmp)| 6V±5%
Working current(Imp)| 400mA±5%
Open Circuit Voltage(VOC)| 7.2V±5%
Short-circuit current (ISC)| 480mA±5%

CAMERA STRUCTURE

1. Status LED
2. Infrared LED
3. Microphone
4. Motion sensor Speaker| 5. Light sensor
6. Lens
7. Mounting hole
8. Speaker| 9. Power ON/OFF
10. Sync/Reset
11. Charging port
12. TF card slot (Capacity expansion 128G)
---|---|---

CAMERA SPECIFICATION

STATUS LED

1. Boot up: Red light always ON.
2. Waiting for network setting: Red light fast blinking.
3. Network connecting: Green light fast blinking.
4. Network connected: Green light always ON.
5. Abnormal status : Red light slow blinking.
6. During firmware upgrade: Yellow light always ON.
7. Charging status: White light always ON during charging /Turn OFF after fully charged.

READ BEFORE INSTALLATION

1. Keep the bird feeder and all accessories out of reach of children and pets.
2. Make sure the camera has been fully charge .(DC 5V/2A)
3. Working temperature : -5°F to 120°F(-20.5°C to 48.5°C)
4. Working relative humidity: 10%~95%
5. Please do not expose the camera lens to direct sunlight.
6. The camera has an |IP65 waterproof rating, which support working properly under rains or snows. But it can not be soaked in water.

NOTE

1. The bird feeder can only works with 2.4GHz WI-FI.
2. Strong lights may interfere with the device’s ability to scan QR code.
3. Avoid placing the device behind furniture or near microwaves products.
4. Try to keep the bird feeder within range of your WI-FI signal.

HOW TO CONNECT TO WIFI NETWORK

https://a.smart321.com/combirdlover

Download or scan the QR code and install the Bird Lover App for either IOS or Android. Once downloaded, the APP will prompt you to register your device. Enter your phone number or email which one makes you feel comfortable and select the country you live in. You will receive a text with a registration code. Input the registration code, then create a password.

WIFI MODE CONFIGURATION (COMMON)

1. Enter the add device interface, click the “Add Device’ or “+” to add new device. (refer to picture 1)
2. Selecting any one “Smart Bird Feeder” icon of below image to add the device. Turn on the device first, make sure the red indicator is flashing quickly, and then please follow the instruction steps in the APP to add the device. (refer to picture 2)

APP INTERFACE INTRODUCTION

1. Sharpness adjustment: you can choose HD or SD
2. Remaining battery
3. Voice switch
4. Zoom in on the screen
5. Screen horizontal and vertical adjustment
6. Take photo
7. Bird recognition
8. Video function
9. Playback of previous clips
10. View saved photos or videos| 11. Check out the bird collection
12. Share
13. Motion detection(Click to turn on/off)
14. Device Volume
15. 0ne-Way Talk
16. Siren
17. Notification
18. Cloud storage service
19. History of bird identification
20. Personal setting
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>