Shenzhen Xinzhaoyi Technology Y53 Fast Wireless Charging Bracket Charger Instructions
- June 4, 2024
- Shenzhen Xinzhaoyi Technology
Table of Contents
Shenzhen Xinzhaoyi Technology Y53 Fast Wireless Charging Bracket Charger
Instructions
Specifications
Steps
- Connect the bracket to PD or QC Power with a cable
- Place the phone on the bracket vertically or horizontally
Notice: Try to place the phone in the middle of the bracket. Make sure the thickness of the big phone case such as iPhone max shouldn’t exceed 3mm, otherwise will lead to a low charge speed, and even stopping charging.
Warnings:
-
Make sure your phone supports wireless charging
-
Please do not place a metal/magnet/credit card on the mobile phone or phone case.it will block the wireless charge
-
Do not use a mobile phone case that is more than 0.078 inches thick, otherwise, it will not be able to charge.
-
Do not disassemble, or bump. squeeze or put the product into the fire.
-
Do not use the product under the condition of high temperature, humidity or corrosion. so as to avoid electric leakage in the circuit
-
Do not splash water or other liquids on the wirless charger. If cleaning is required, make sure the power is disconnected.
-
When charging, keep the distance between the implanted medical device(pacemaker, cochlear implant.etc) and the wireless charger at least 20cm to avoid potential
interference to the medical device -
When using the DC charger for power supply, please make sure your charger Support charge. and its max power is more than 1 BW
-
Please keep the product out of the reach of kids.
FCC WARNING
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation. NOTE: This equipment has been tested and found to
comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver. — Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
To maintain compliance with FCC’s RF Exposure guidelines, This equipment should be installed and operated with a minimum distance between 20cm between the radiator and your body: Use only the supplied antenna. FCC ID: 2AZKN-Y53
Warning:
Changes or modifications to this unit not expressly approved by the part
responsible for compliance could void the user’s authority to operate the
equipment.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>