Shenzhen Xinzhaoyi Technology Y3 15W Ultra-thin MagSafe Magnetic Wireless Charger User Manual
- June 6, 2024
- Shenzhen Xinzhaoyi Technology
Table of Contents
Shenzhen Xinzhaoyi Technology Y3 15W Ultra-thin MagSafe Magnetic Wireless
Specification
Product overview
Charging Distance: The distance between the induction coil inside the
mobile Phone and the internal induction coil of wireless charger is 6mm Please
avoid using thick phone case.
Usage Scenario description
• This magnetic wireless charger is only suitable For the following scenarios.Please check whether Your mobile phone or phone case is applicable before using
- Naked lphone12 can be magnetic fixed and wireless charged directly.
- Iphone12 serial with magnetic suction case can be magnetic fixed and wireless charged directly.
- Iphone12 serial with Non- magnetic suction case(the case thickness should be less than 2mm),can be wireless charged, but magnetic suction will be weak.
- 0ther phone( support QI wireless charge) with correct magnetic suction case, can be magnetic fixed and charged directly.
- ther phone( support QI wireless charge) without magnetic suction case, can be wireless charged only when the center of the charger face to the center of the receiver part of the phone, otherwise the phone can’t be charged.
Instructions
Note: The charged device must meet the Qi standard before use.
- Insert the USB C input interface into the charger or other charging interface and apply power.the wireless charger will be standby
- Put the wireless charger on the back of the phone, the phone will be magnetic fixed on the phone(if supported) and start wireless charging.
- When the wireless charger senses other metal foreign matter.the wireless charger will stop charging and turn to protection mode.
Warnings
- Make sure your phone supports wireless charging
- Please do not place metal/magnet/credit card on the mobilephone or phone case,it will block the wireless charge
- Do not use the mobile phone case which is more than 0.078 inch thick, otherwise it will not be able to charge.
- Do not disassemble, bump.squeeze or put the product into the fire.
- Do not use the product under the condition of the high temperature,humiity or corrosion.so as to avoid electric leakage in the circuit
- Do not splash water or other liquids on the wirless charger. If cleaning is required, make sure the power is disconnected.
- When charging, keep the distance between the implanted medical device(pacemaker, cochlear implant,etc) and the wireless charger at least 20cm to avoid potential interference to the medical device
- When using the DC charger for power supply,please make sure your charger Support PD charge.and its max power is more than 18W
- Please keep the product out of the reach of kids.
FCC Warning
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:(1) This device may not
cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.Any
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment. This
equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help. The device has been evaluated to meet general RF exposure requirement.
FCC RF exposure statement:
The equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. During the operation of device a distance of 15 cm
surrounding the device and 20 cm above the top surface of the device must be
respected.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>