ELEGOO Mars 4 Ultra 3D Printer User Manual
- June 12, 2024
- ELEGOO
Table of Contents
Mars 4 Ultra 3D Printer
Product Information:
This device is designed to comply with part 15 of the FCC rules,
ensuring that it meets the necessary requirements for safe and
reliable operation. It is important to note the following
information:
-
Compliance: This device complies with part 15 of the FCC
rules. -
Harmful Interference: The device should not cause harmful
interference to other devices. -
Interference Acceptance: The device must accept any
interference it receives, even if it causes undesired
operation. -
Modifications: Any changes or modifications made to the device
that are not expressly approved by the party responsible for
compliance may void the user’s authority to operate the
equipment. -
Radiation Exposure: The device complies with FCC radiation
exposure limits for an uncontrolled environment. It is recommended
to maintain a minimum distance of 20cm between the radiator and
your body during installation and operation.
Product Usage Instructions:
To ensure proper usage of this device, please follow these
instructions:
-
Compliance: Make sure to use the device in accordance with part
15 of the FCC rules. -
Interference Prevention: Avoid using the device in a way that
may cause harmful interference to other devices. -
Interference Acceptance: Be aware that the device may
experience undesired operation due to interference from other
devices. -
Modifications: Do not make any changes or modifications to the
device without express approval from the party responsible for
compliance. -
Radiation Exposure: During installation and operation, maintain
a minimum distance of 20cm between the radiator of the device and
your body to comply with FCC radiation exposure limits.
FCC Warning This device complies with part 15 of the FCC rules. Operation is
subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures: ·Reorient or relocate the receiving antenna.
·Increase the separation between the equipment and receiver. ·Connect the
equipment into an outlet on a circuit different from that to which the
receiver is connected. ·Consult the dealer or an experienced radio/TV
technician for help.
Radiation Exposure Statement This equipment complies with FCC radiation
exposure limits set forth for an uncontrolled environment. This equipment
should be installed and operated with minimum distance 20cm between the
radiator and your body.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>