CFE BMS Upgraded By CANbox User Guide
- June 12, 2024
- CFE
Table of Contents
CFE BMS Upgraded By CANbox
Product Information
The product is a Battery Management System (BMS) that has been upgraded using the CAN box. The BMS is used to monitor the real-time running data of the battery and can also be used to upgrade the firmware of the battery. To perform the firmware upgrade, the BMS Monitor software needs to be used, and all communication cables connected to the ‘M/S’ terminal of the battery should be disconnected. The product requires the installation of three drivers located in the ‘CAN Drivers’ folder. The PC format should be set to ‘Chinese Simplified China’ for proper operation.
Product Usage Instructions
To upgrade the firmware of the battery, please follow these steps:
1. Install the three drivers located in the ‘CAN Drivers’ folder.
2. Set the PC format to ‘Chinese Simplified China’. 3. Open the BMS_TOOL.exe
software. 4. Choose the Firmware Upgrade icon. 5. Select the address of the
battery, matching the SW3 setting on the battery. 6. Click on the Connect icon
to establish a connection with the battery. 7. Click on Select File to choose
the firmware file. 8. Click on Upgrade to start the firmware upgrade process.
9. After the firmware upgrade is completed, the battery will automatically
turn off. 10. Turn on the battery to complete the upgrade process. For
additional support, please visit the CFE Support Website Service at
cfenergygroup.com.
Operation Guidance
Operation Guidance on BMS upgraded By CANbox
Note
If battery need upgrade the firmware, please disconnect all theCommunication cables of The ‘M/S’ terminal, BMS Monitor wasused to upgrade firmware or monitor battery real time runningdata.
Driver Installation
Install the 3 drivers in ‘CAN Drivers’ Folder
Formats setting
Set the PC Format on ‘Chinese（Simplified China）
Firmware upgrade by CAN Bus Tool & BMS Monitor
- Open the “BMS_TOOL.exe”;
- Follow the steps below to do Firmware Upgrade
- Choose “Firmware Upgrade” icon
- Select “Address” of the battery (Match the SW3 on the battery)
- Click “Connect” icon to connect the battery
- Click “Select File” to select Firmware
- Click “Upgrade” to do o Upgrade the battery
- After the firmware upgraded, the battery will Turn OFF automatically
- Turn the battery on than the upgrade is done
For more support please check CFE Support Website Service (cfenergygroup.com)
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>