COSTWAY FP10092US Clothes Dryer User Manual

COSTWAY FP10092US Clothes Dryer

Prat Names

Model: A

Attention Before Use (Very important)

Electrical Appliance Safety

1. Please use 120V AC power supply and current at 20A, the earthing end of the socket must be reliably grounded, and it’s better to use a leakage protector.
2. Please keep inflammable and volatile substances (such as gasoline and alcohol) away from the running clothes dryer to avoid fire.
3. Do not install the dryer in wet places, such as bathroom or possibly wet places to avoid electric shock, leakage and other accidents.
4. It should be easy to plug and unplug when the dryer is in normal use, the plug must be pulled out while power cut, move, unused or clean up, please don’t use wet hand to plug or unplug.
5. If the supply cord is damaged, it must be replaced by the manufacturer or similarly qualified persons in order to avoid hazards.
6. It is strictly prohibited to place the dryer on the packaging foam parts, otherwise it will cause fire due to heat not easy to release or other external factors.
7. Use soft wet towel to wipe the dirty inner drum or outside of the dryer, do not rinse it directly with water or wipe it with volatile oil (such as alcohol, gasoline, etc.).
8. If use chemicals to clean clothes, the tumble dryer cannot be used.
9. Cotton dash can’t under around the drum dryer.
10. The machine must be well ventilated to prevent the flowing backwards air to enter the space to ignite other substances, including open fires.
11. It is not allowed to exhaust to the flue that used for burning gas or with flammable materials.

Use Requirements

1. Only fully dehydrated clothes can be put into the dryer. (In order to avoid water leakage and increase drying time, do not put the clothes wrung out by hand into the dryer.)
2. Please check and take out the cigarette lighter, matches and other inflammables and coins, hairclips, paper clip keys and other sharp metal objects from the pocket before drying.
3. Fasten the zipper, button and turn the clothes inside out to dry. This will reduce the sound of collision with the drum.
4. Clothes with the label “clothes that cannot be washed with water” or “dry-cleaned” shall not be used for clothes dryer.
5. Wool fabric, wool clothes and leather materials should not be used for clothes dryer. Wool and leather will be damaged and wool fabric will shrink and deform.
6. After each use, it is must to clean the thread crumbs on the air inlet filter screen and air outlet filter cotton.
7. It’s better to dry the same or similar fabric at a time.
8. Do not dry clothes that have the following requirements: do not tumble dry, hang dry, drip dry and spread dry.

Installation

Clothes dryer should be installed on the horizontal and solid ground, table or specialized bracket. It should be installed 4″-6″ (10-15cm) away from the back wall. Please install air fans or install exhaust pipe in the outlet to discharge heat and humidity when it is in a narrow space. The length of the exhaust pipe should not exceed 6.5 feet (2 meters).
Installation of exhaust pipe joint
Adjust the direction of outlet joint according to actual needs, fix the exhaust outlet with 2pcs self-bolt.

Optional installation

Install clothes dryer with bracket
Must ensure the bracket is firm and reliable when installing dryer on the bracket. Bracket must installed stable and reliable, in order to ensure the bracket is stable, there should be a strong connection and at least 5″ (13cm) distance between bracket and wall. (The bracket is a non-standard part).

Hanging dryer on wall
Find the right place to hang the dryer, please make sure minimum distance between the top of the dryer and the ceiling should be 2″ (50mm), if the installation position is located above the washing machine, reserve enough space to open the cover of washing machine.

• A. Fasten the hook to the wall with an expansion screw(M6).
• B. Install the air outlet tube with 3pcs of self-bolt 4×12. Hang the dryer safely on the hook.

Daily maintenance

In order to ensure the normal use of the dryer, please clean the outlet inlet filter screen timely, and clean the body regularly. Please pull out the power plug before cleaning!

Air outlet filter screen cleaning
Please clean the air outlet filter screen after each use

• *  **A.** **Remove the filter:** put your hand into the inner drum of the machine and insert it into the four holes near the center of the outlet air hood. Pull the filter outward.![COSTWAY-FP10092US-Clothes-Dryer-FIG-1 \(4\)](https://manuals.plus/wp-content/uploads/2023/07/COSTWAY-FP10092US-Clothes-Dryer-FIG-1-4.jpg)

  • B. Line crumbs cleaning: remove the air outlet cover, filter cotton and filter screen respectively, and use a soft brush or vacuum cleaner to clean the line crumbs on the filter screen and the filter cotton. Be careful not to damage the filter cotton.
  • C. Filter screen installation: Assemble the filter in the order of filter screen, filter screen cotton and air outlet hood after the cleaning, then put the concave center part of the filter screen into the convex center part of the drum.

The air inlet filter screen is cleaned once a month

1. Push the outside middle end of the air inlet filter screen cover slightly upward, hold it and take it off outwards.
2. Use a soft brush or vacuum cleaner to clean the dust on it.
3. Replace filter into the machine after cleaning.

Body cleaning
Use a wet soft cloth to wipe the inner drum or outside of the dryer, use a bit of kitchen detergent to wipe the stubborn stains, and then clean with a clean cloth.

Note: Do not use diluent, gasoline, alcohol to wipe the body.

Model: A

Operation Instruction

Dry program selection
There are five drying procedures: Cool air care, Cooling, Anti-wrinkle, Normal cloth and Heavy cloth

Cool Air Care: this function runs for cool air, the main removal of clothing odor, such as clothing storage too long to produce odor.
Off: when the knob is pointed to “off”, the dryer will disconnect the power. Once the pointer to the desired drying process, the dryer starts working.
Cooling: This function happens in the last 20 minutes of the drying process. Use cool air instead of hot air to cool the clothes that have just been dried, making it easy to take clothes out.
Anti-wrinkle: used for clothing that is difficult to iron, such as fabric shirts and linen. Select “heating choice”, then select the “weak” button. Set the drying time according to the number of clothes, usually 30 to 60 minutes. When the time runs out and the clothes dryer stops running, the clothes will contain moisture to facilitate ironing.
Normal Cloth: this function is used to dry and cool clothes, most of the time for clothing that is not prone to wrinkles (depending on the material of the clothes). Select the “heating choice”, then select the “strong” button, and the drying time is generally set at 60-120 minutes.
Heavy Cloth: This function is used for big size or exceed clothes (Clothes exceed half of the rated capacity of the dryer) select”heating choice”, then select “strong” button, setting the drying time to exceed 120 minutes.

Common Problem Deal

If the dryer breaks down, please disconnect the power and check. Sometimes it is not a fault in the following cases. Please confirm again before repair. If it is a fault, please contact our after-sales service department. Please do not repair by yourself.

The dryer| •   Whether power is| •   Use after power supply.
doesn’t start| off or trip.| •  Check the power
 | •   Whether the| connection to make sure
 | power connection is| the fastening is in place.
 | firm and reliable.| •  The loading clothes must
 | •   Whether the| be dehydrated and the
 | drying clothes are| drying weight (the weight
 | overloaded.| of wet clothes) should not
 | •   Whether the| exceed lllbs (5kg).
 | temperature| •   Please ask the
 | controller is| maintenance staff to
 | disconnected.| replace the temperature
 |  | controller.
The outside of| •  The line crumbs| •   Line crumbs filter screen
the dryer is hot| filter screen is| should be cleaned before
or can smell hot| blocked by the fur| and after each use.
 | crumbs.| •  Clear the clog.
 | •  Air outlet vent or|
 | drains are blocked.|
Clothes can’t| •  Too full of clothes| •   Dry the clothes several
be dried| in the dryer.| times.
 | •  The filter is| •  Clean air filters in and
 | blocked, affecting| out regularly.
 | the incoming and| •   Shake the clothes out
 | outgoing wind.| and dry them again.
 | •  The clothes are| •   Rearrange the machine.
 | too full to wrap|
 | around.|
 | •  The machine is|
 | installed in a narrow|
 | unventilated|
 | position.|
Clothes too much fold| •  The dryer is too full.

•   Did not take out the clothes in time after finishing.

•   Clothing is not property classified.

•  The temperature is set too high.

| •   Don’t overfill your clothes.

•  Take out the clothes immediately after finishing.

•   Dry the clothes after sorting.

•   Follow the maintenance instructions on the clothing label.

---|---|---
Clothes shrink| •  Too dry.| •   Follow the maintenance label instructions on the clothes. If the clothes shrink easily, always check your clothes when you dry them. Take it out when it’s still damp to avoid over-drying and hang or lay it flat to dry completely.
Clothes have wool pellet| •    It is normal to produce wool pellets from synthetic and

non-ironing fibers. This is due to normal friction.

| •   Soften the fiber with fabric softener. When ironing clothes, spray the finalized glue on the collar and cuff, or turn the inside out to reduce friction.

Specification

With your inspiring rating, COSTWAY will be more consistent to offer you EASY SHOPPING EXPERIENCE, GOOD PRODUCTS, and EFFICIENT SERVICE!
office: Fontana
THIS INSTRUCTION BOOKLET CONTAINS IMPORTANT SAFETY INFORMATION. PLEASE READ AND KEEP FOR FUTURE REFERENCE.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>