ERIDANUS ERI-WB-101L-A Turner Bathroom Sink Installation Guide
- June 12, 2024
- ERIDANUS
Table of Contents
ERIDANUS ERI-WB-101L-A Turner Bathroom Sink
Tools and Materials
Included Hardware
- Hanger Bolts (10mm) x2
- Washer x2
- Nuts x2
- Anchor x2
- Insulation Sleeve x2
Before You Begin
Read the following instructions carefully before you begin this installation.
- Observe all local plumbing and building codes.
- Shut off the hot and cold water supplies. Inspect the drain and supply tubing. Replace if necessary.
- Unpack the new sink and inspect it for damage. Afterward, put the sink back to its protective carton until the installation begins.
- In consideration of various installations possible with this sink, procedures other than those described in these instructions may be used.
- It’s recommended to provide the actual sink to all contractors involved in the project. It’s critical that all contractors maintain communication and coordinate the requirements of the project.
- It is recommended that the sink installation be performed by professional and experienced installers. For the sake of safety and a damage-free installation, the sink should be installed by at least two people.
- All information in these instructions is based on the latest product information available at the time of publication. Eridanus reserves the right to make revisions to the design of products without notice.
- Due to differing demands and purposes for usage possible, a template will not be provided for this model.
Installation Steps
Wall Mount Installation
NOTE These fixings are suitable for solid walls only. Plasterboard or stud walls may require specialist fixings.
Step I. Measure the distance between the center of each mounting hole on the back of the sink. Draw 2 marks on the wall in the desired mounting location. Ensure that the two marks are level with the floor.
Step II. Drill two holes accordingly using a 14 mm masonry drill bit to a depth of 75 mm. Push the anchor into each hole and screw in the hanger bolts.
Step III. Attach the drain assembly and faucet to the sink according to
the manufacturer’s instructions.
Step IV. Carefully place the sink in position against the wall. Locate
the hanger bolts through the holes in the rear of the basin. Secure the sink
with insulation sleeves, washers, and nuts respectively.
NOTE DO NOT over-tighten, as this may cause damage to the ceramic sink.
Step V. Apply silicone caulk around the edges of the sink where it meets
the wall to prevent water from seeping behind the sink. Wait for 24 hours for
it to dry.
Step VI. Attach the P-trap assembly to the drain on the sink and connect
it to the plumbing below. Install the water supply. Use a wrench to tighten
the nuts and ensure there are no leaks.
Congratulations! You have successfully installed a wall-mount bathroom sink.
© COPYRIGHT 2023 ERIDANUS.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>