MAGNAVOX MMA3967 Portable Speaker with Color Changing RGB Lights Owner’s Manual

**MAGNAVOX MMA3967 Portable Speaker with Color Changing RGB Lights Owner’s Manual

**

FCC NOTICE

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

FCC STATEMENT

1.  This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
2. This device may not cause harmful interference, and
3. This device must accept any interference received, including interference that may cause undesired operation.
4. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

FCC WARNING:

To assure continued operation, follow the attached installation instructions and use only shield cables when connecting to other devices. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

LOCATION OF CONTROLS

1.   Button
2. Button
3. MN Button
4. Button
5. Button
6. IN ( Aux/ Line in) Jack
7. TF (Micro SD) card slot
8. Indicators
9. USB Port
10. TYPE-C Port (For charging only)

POWER SOURCE

The unit has a built-in Li-ion rechargeable battery, charge it before first time use or when it is drained as follows:

1. Open the Rubber Cover on the back of unit.
2. Connect the small plug from the supplied USB Connection Cable to the TYPE-C on the back of unit.
3. Connect the full size USB Plug from the supplied USB Connection Cable to the USB Port on the Personal Computer or USB Charger (Computer and USB Charger not included).
4. When charging, the Red Charging Indicator on the back of unit will illuminate.
5. When charging is complete, the Red Charging Indicator will turn off.

Notes:

1. When charging, you can also play and listen to music at the same time
2. Your battery will last longer if you’re following these simple guidelines for caring and storing:

A. Before first time use, recharge the unit approximately 3 hours until the unit is fully charged.
B. Charge and store the unit within the temperature range of 5°C – 35°C (40°F – 95°F).
C. Do not overcharge (longer than 24 hours). Excessive charging or running the unit until battery completely flat will damage battery. Battery life will be extended if you keep the battery fully charged.
D. Battery life naturally shortens slowly over time.
E. The rechargeable battery incorporated in this product is not user replaceable.

OPERATION:

General Operation

1. Recharge the built-in Li-ion battery as previously instructed.
2. Press and hold the Button on the bottom of unit approximately 3 second to power on the unit. The Blue Indicator on the black of unit will illuminate.
3. Press the Button repeatedly to switch to desired playback mode. The unit will sound a prompt with your selection (see list below):
   Playback Modes:| Voice Prompt:
   ---|---
   BT (Bluetooth)| Bluetooth ready for connection
   FM Radio| Radio
   IN (Aux/Line In)| Line in
   USB| USB
   Micro SD Card| Memory Card

Note: if the Audio Connection Cable; TF (Mirco SD) Card and/ or USB Device had NOT inserted into the unit, the correspon-ding selection will not available.

4. During playback:
   • Press the 3 Button to pause; press again to resume to normal playback. IN(Aux/Line in) mode, press it to mute the sound, press again to turn the sound back on.
   • Press and release the + or = buttons repeatedly to adjust volume level as desired.
   • Press and hold the + or o buttons repeatedly to skip tracks. Notes: It will not function in IN(Aux/ Line in) mode.
5. When finished listening, press and hold the 0 Button approximately 3 second to shut off the unit.

BT Mode:
BT (Bluetooth) pairing:
First time use or re-pairing the unit to a new BT Device, pair as follows:

1. Power on the unit and enter to BT mode as previously instructed. You will hear an audible prompt say “Bluetooth ready for connection” and the Blue Indicator on the back of unit will illuminate and blink.
2. Power on the external BT Device and enter to BT search mode. Start pairing following the on screen instructions from the external BT Device. When paired, the unit will sound a prompt “Bluetooth connected” and the Blue Indicator will stop blinking.
3. If pairing is complete you may now play music with your external BT Device.
4. During playback:
   • Press the 4 Button to pause; press again to resume to normal playback.
   • Press and release the + or — buttons repeatedly to adjust volume level as desired.
   • Press and hold the + or — buttons repeatedly to skip tracks.
5. When finished listening, press and hold the 0 Button Approximately 3 second to shut off the unit.

TWS Connection

1. Power on two units at the same time.
2. Press and release the 4 Button one of the units and wait for a few seconds, these two unit will enter into TWS pairing mode, you will hear a prompt sound.The Blue indicator on the back of unit of one of the unit will blink. the another one will stop blink. After then, the units will enter into BT pairing mode as previously instructed.
3. If pairing is complete, you may now play music with your external BT Device.
4. During playback (one of the units) :
   • Press the 4 Button to pause, press again to resume to normal playback.
   • Press and release the + or — buttons repeatedly to adjust volume level as desired.
   • Press and hold the + or c= buttons repeatedly to skip tracks.
5. When finished listening, press and hold the 0 Button approximately 3 second to shut off the unit

Notes:

• When the external BT Device searched the unit, our model number “MMA3967” will appear on the display of external BT Device.
• If while pairing you are asked for a code please try “0000” or “1234”.

Normal operation after pairing:

1. Power on the external BT Device and enter to BT playback mode.
2. Power on the unit and enter to BT mode as previously instructed. You will hear an audible prompt say “Bluetooth ready for connection” and the Blue Indicator on the back of unit will illuminate and blink.
3. Wait a few seconds until the unit is automatically paired tc the external BT Device. The unit will sound a prompt “Bluetooth connected” and the Blue Indicator will stop blinking.
4. After pairing is completed, you may now play music with your external BT Device. 

FM Radio:

1. Power on the unit and enter to Radio mode as previously instructed. You will hear an audible prompt say “Radio”.
2. For first time use(or relocated the unit to a new location), search and store the available FM radio stations by press the “ wy’ Button. The unit will automatically to search and store all available FM radio stations then play the 1st stored FM station.
3. During Playback:
   • Press and hold the -F or = Buttons repeatedly to select and plays the desired stored radio station.
   • Press and release the “ or = Buttons to adjust volume level as desired.
4. When finished listening, press and hold the © Button approximately 3 second to shut off the unit.

IN (Aux/Line in):

To listen from an external Audio Player such as MP3 Player, Discman…etc.

1. In power off mode, connect one end of supplied Audio Connection Cable to the AUX Out/Line Out/Phone Jack on the external Audio Player.

2. Open the Rubber Cover on the back of unit.

3. Connect the other end to the IN (Aux/Line In) Jack on the back of unit as illustrated below:

4. Power on the unit and enter to AUX mode as previously instructed. You will hear an audible prompt say “Line In’.

5. Play the music on the connected Player as usual. (Make sure the volume level of the connected Audio Player is turned to high level.)

6. During playback:

   • Press the # Button to mute the sound, press again to turn the sound back.
   • Press and release the -+ or — buttons repeatedly to adjust volume level as desired,

7. When finished listening, press and hold the ©) Button approximately 3 second to shut off the unit.

LIMITED WARRANTY

Craig warrants this product to be free from manufacturing defects in material and workmanship under normal use for a period of 180 days from date of purchase. If service is required, please return the product to the store where it was purchased for exchange; or, pack the unit in the original packing material with all accessories if applicable, a copy of your sales receipt and a Cashier’s check or Money Order for $7 (to cover shipping and handling costs) payable to Craig Electronics Inc, For consumers in Canada, please make sure that the cashier check or money order is redeemable through a U.S. bank. Ship your product freight pre-paid. Your unit will be repaired, replaced or if the unit can not be repaired or replaced, a refund will be forwarded to you within four weeks of receipt of your unit, Please ship your unit to:

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>