RIHO IW00171.1 Desire LED User Manual
- June 12, 2024
- RIHO
Table of Contents
RIHO IW00171.1 Desire LED
Product Information
Product Name: Desire LED
User Manual: IW00171.1
Art.no: 208027
Product Usage Instructions
WARNING: If you decide to repair the bath yourself, you do so at your own risk! For more serious damages, always consult with the service department of RIHO.
ATTENTION: The manufacturer does not hold any responsibility if the instructions provided in this manual are not followed.
WAARSCHUWING: Indien u besluit om het bad zelf te herstellen, doet u dat op eigen risico! De herstelling van ernstigere beschadigingen dient altijd met de serviceafdeling van RIHO besproken te worden.
PRODUCENT NIE PONOSI ADNEJ ODPOWIEDZIALNOCI: W PRZYPADKU, GDY NIE BYLY PRZESTRZEGANE ZALECENIA NINIEJSZEJ INSTRUKCJI.
Please follow these instructions for the proper usage of the Desire LED:
- Ensure that the bath is not damaged before usage. If any repairs are required, consult with the RIHO service center for more serious damages.
- Always observe and follow the instructions provided in this user manual.
PRECAUTION
CLEANING
Note: Not suitable for matt acryl products.
ATTENTION
If you will decide to repair the bath by yourself, you will do it on your own
responsibility! Always consult the possibility of repairs of more serious
damage with the RIHO service center.
THE MANUFACTURER DOES NOT HOLD ANY RESPONSIBILITY ON CONDITION WHEN THERE HAVE
NOT BEEN OBSERVED THE INSTRUCTIONS GIVEN IN THESE INSTRUCTIONS.
WIRING
- 1 First, take off the power from the system before connecting the device.
- 2+3. Make sure that the system is connected directly to the AC power. It is important that the sensor circuit is not interrupted by a (light) switch, this creates an unstable operation.
- 4. Make sure that the bath is in its final position before the power is put back on the system, only then it can start with the calibration. Put the power on and hold 2 meters away for at least 20 seconds. When the lights start blinking after installation and calibration or spontaneously go on or off, it means that the calibration was not successful and need to be carried out again. Take off the power for minimum 5 seconds before switching in on to re-calibrate. The product is intended for installation indoors. The light source in this lamp should only be replaced by the manufacturer or a qualified service technician.The electrical connection for the installation must be made using the appropriate H05VV-F (3×1.5mm² 230V / 50HZ) cable and the connection must be made with waterproof connections. Circuit breaker 6A char. B with minimum contact distance 3mm, residual-current circuit breaker max. 30mA.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>