contacta IR-DC5-2KIT 5 Bay IR Receiver Hearing Loop Listener Charger Daisy Chaining Kit User Guide
- June 12, 2024
- contacta
Table of Contents
contacta IR-DC5-2KIT 5 Bay IR Receiver Hearing Loop Listener Charger
Daisy Chaining Kit
Product Information
- Product Name: 5 Bay IR Receiver/ Hearing Loop Listener Charger Daisy Chaining Kit
- Model Numbers: IR-DC5-2KIT, IR-DC5-3KIT, IR-DC5-4KIT
Included Components
- 10 Bay Charging Kit (IR-DC5-2KIT): Power Lead (PS-12V3AMP-UK), Daisy Chainging Lead (PS-LINK-2.1), 2 x 5 Bay Chargers (IR-RX2-DC5)
- 15 Bay Charging Kit (IR-DC5-3KIT): Power Lead (PS-12V3AMP-UK), 2 x Daisy Chainging Lead (PS-LINK-2.1), 3 x 5 Bay Chargers (IR-RX2-DC5)
- 20 Bay Charging Kit (IR-DC5-4KIT): Power Lead (PS-12V3AMP-UK), 3 x Daisy Chainging Lead (PS-LINK-2.1), 4 x 5 Bay Chargers (IR-RX2-DC5)
- Power Supply: 100-240 Volt AC 50/60 Hz
- Number of Charging Bays: Up to 20 bays (depending on the model)
- Control Lamps: Dual colour LED (red / green)
- Dimensions: L 85 mm x W 135 mm x H 32 mm approx.
- Weight: 190 g
- Compliance: CE seal on the device confirms compliance with the following EU directives:
- Low Voltage Directive 2014/35/EC
- EMC Directive 2014/30/EC
- RoHS Directive 2011/65/EC
- WEEE Directive 2012/19/EC
Product Usage Instructions
- Place the charging kit in a dry and ventilated position.
- Connect the power supply unit to the first bay of the charger.
- Using the daisy chaining leads, link the bays together as shown in the manual.
- Plug the setup into an electrical mains outlet.
- To charge a receiver, place it into one of the charging bays.
- The control lamp will light up in red to indicate that the receiver is being charged.
- Wait for the control lamp to turn green, indicating that the receiver is fully charged. This may take several hours.
- The control lamp will switch off when the receiver is removed from the bay.
General information
Thank you for your purchase of the 5 bay charger daisy chaining kit. Please read through the operating instructions carefully to be able to set up the unit correctly and to prevent damage to the rechargeable batteries within the receiver.
Included in the standard package:
Please check if all of the following components are included
10 Bay Charging Kit (IR-DC5-2KIT)
- Power Lead (PS-12V3AMP-UK)
- Daisy Chainging Lead (PS-LINK-2.1)
- 2 x 5 Bay Chargers (IR-RX2-DC5)
15 Bay Charging Kit (IR-DC5-3KIT)
- Power Lead (PS-12V3AMP-UK)
- 2 x Daisy Chainging Lead (PS-LINK-2.1)
- 3 x 5 Bay Chargers (IR-RX2-DC5)
20 Bay Charging Kit (IR-DC5-4KIT)
- Power Lead (PS-12V3AMP-UK)
- 3 x Daisy Chainging Lead (PS-LINK-2.1)
- 4 x 5 Bay Chargers (IR-RX2-DC5)
If any parts are missing, please immediately contact your dealer or the manufacturer directly.
Function
This charging kit is able to recharge the batteries of 10, 15 or 20 infrared
receiver/hearing loop listener chargers using a single set up.
Setup
Place the set up in a dry and ventilated position. Connect the power supply
unit with the charger to the first bay, then using the daisy chaining leads,
link the bays together as shown below. Then plug the set up into a electrical
mains outlet.
Charging the receivers:
When a receiver is placed into the charging bay, the control lamp lights up in
red. After the receiver is fully charged, the control lamp will display a
green light. It may take up to several hours until a receiver is fully
charged. The control lamp switches off when the receiver is removed from the
bay.
Warranty
Should a malfunction occur despite the unit having been set up and operated
correct-ly, please contact your dealer or the manufacturer directly.
This warranty covers the repair of the product and returning it to you free of
charge. The warranty does not apply to damage caused by incorrect handling or
attempts to repair the unit by people not authorised to do so (destruction of
the seal on the unit). Repairs will only be carried out under warranty if the
completed warranty card is retur-ned accompanied by a copy of the dealer‘s
invoice/till receipt.
Always specify the product number in any event.
Disposal of used electric and electronic units (applicable in the
countries of the European Union and other European countries with a separate
collection system). The symbol on the product or the packaging indicates that
this product is not to be handled as ordinary household waste but has to be
returned to a collecting point for the recycling of electric and electronic
units. You protect the environment and health of your fellow men by the
correct disposal of this products. Environment and health are endangered by a
faulty disposal. Material recycling helps to reduce the consumption of raw
material.
You will receive further information on the recyc ling of this product from
your local community, your communal disposal company or your local dealer.
Specifications
- Power supply: 100-240 Volt AC 50/60 Hz
- Number of charging bays: DO NOT exceed x4 units (20 bays).
- Control lamps: Dual colour LED (red / green)
- Dimensions: L 85 mm x W 135 mm x H 32 mm
- Weight: approx. 190 g
This device complies with the following EU directives:
- Low Voltage Directive 2014/35/EC
- EMC Directive 2014/30/EC
- RoHS Directive 2011/65/EC
- WEEE Directive 2012/19/EC
Compliance with the directives listed above is confirmed by the CE seal on the
device.
Technical specifications subject to change without prior notification.
Contact
- UK & ROW
- +44 (0) 1732 223900
- sales@contacta.co.uk
- US & Canada
- +1 616 392 3400
- info@contactainc.com
- www.contacta.co.uk
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>