Prime LINE SA-700693 Bluetooth Earbuds User Manual
- June 12, 2024
- Prime-Line
Table of Contents
SA-700693 Bluetooth® Earbuds
User Manual
PRODUCT SPECIFICATIONS
Bluetooth®: 4.2
Support form: A2DP/HFP/HSP
Distance: 10M
Working Current: 30mA
Working Voltage: 4.2V
Charge Current: 30-150mA
Max Headset Output Power: L20mw R20mw
Battery Capacity: 50mAh 3.7V
Charge Time: 2 hours
Working Time: Above 1-2 hours
Battery Life: 10M
Input Voltage: DC 5V 200mA
INDICATOR DIAGRAM
- PreviousNolume down
- Power on/off
- Next/Volume up
- Charger port
- Microphone
CHARGING
Unit should be fully charged prior to first use. Insert the micro USB plug into the earbuds. Insert the standard USB into a port with a power source. The light will be red while charging. The light will turn off when charging is complete. Disconnect the charging cable when not in use.
POWER ON/OFF
Power on: Press and hold the power button until light alternates blue and
red. You will hear an audio prompt.
Power off: Press and hold the Power button until light turns off. You
will hear a prompt.
CONNECT WITH THE DEVICE
- Press and hold the power button until light alternates blue and red. You will hear an audio prompt.
- First time pairing: Open the Bluetooth® function on your device.
- Search for device 11225 on your device. A slow blue LED flash indicates when a connection has been successfully completed. Your device will show the headphones connected. You will hear an audio prompt.
ANSWER / HANG UP THE CALL
Press Power button from your device or from the earbuds.
REJECT THE CALL
Hang up by your device or press and hold the Power button.
PREVIOUS/NEXT/PAUSE
- To play previous track, quickly press the Previous/Volume down button.
- To play next track, quickly press the Next/Volume up button.
- To pause a track, quickly press the Power button. To continue play, quickly press the Power button again.
VOLUME ADJUSTMENT
- Volume down: Press and hold the Previous/Volume down button.
- Volume up: Press and hold the Next/Volume up button.
Federal Communications Commission (FCC) Statement. This device complies with
part 15 of the
FCC Rules. Operation is subject to the following twoconditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide Reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one ormore of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Warning: Changes or modifications made to this device not expressly
approved by Hong Kong Genuine Co., limited may void the FCC authorization to
operate this device.Note: The manufacturer is not responsible for any radio or
TV interference caused by unauthorized modifications to this equipment. Such
modifications could void the user’s authority to operate the equipment.
RF exposure statement:
This device complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. The device is installed and operated without
restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>