SuperSprings INTERNATIONAL SSR-121-40-47-54 SumoSprings Rear for Ford Transit Instruction Manual
- June 12, 2024
- SuperSprings INTERNATIONAL
Table of Contents
SuperSprings INTERNATIONAL SSR-121-40-47-54 SumoSprings Rear for Ford
Transit
Product Information
- Product Name: SUMOSPRINGS REAR
- Part Number: SSR-121-40/47/54
- Manufacturer: SuperSprings International, Inc.
- Address: 505 Maple Avenue Carpinteria, CA 93013
- Contact Information: +1 800 898 0705, support@supersprings.com
- Website:superspringsint.com
- Safety Notice: Installation is recommended to be done by a professional or persons with sound mechanical knowledge. Never exceed the manufacturer’s Gross Vehicle Rating (GVWR) located on your vehicle’s identification tag.
- Date of Revision: April 2022 (REV. 2.01)
Product Usage Instructions
- Park the vehicle on a hard, level surface and engage the emergency brake. Place chocks in front and behind wheels to prevent rolling. Observe all safety precautions and wear safety glasses.
- With the vehicle on the ground, measure the distance from the bottom of the frame to the contact pad on the axle.
- Raise the rear of the vehicle, allowing the axle to hang freely. Support the frame using safety jack stands.
- Starting on the driver’s side, remove the existing factory bump stop by gripping firmly and twisting.
- Remove the bump stop cup.
- Install the SumoSprings by inserting them into the same hole in the frame where the factory bump stop was removed from.
- Apply a drop of Blue Thread Locker to the threads of the bolt and thread it into the hole in the frame. Tighten the bolt and torque to 20 lbs.
- Repeat steps 4 through 7 on the passenger side of the vehicle.
- Jack up the vehicle and remove the safety jack stands.
- Carefully lower the vehicle to the hard surface.
- Remove the wheel chocks from the front wheels.
- Register the warranty for your SuperSprings International part using the warranty card found in the box your part came in.
BEFORE YOU BEGIN
PRIMARY APPLICATIONS
- Ford Transit-150 4 X 2 (2015 – present)
- Ford Transit-250 4 X 2 (2015 – present)
- Ford Transit-350 4 X 2 (2015 – present)
- Ford Transit-350 HD 4 X 2 (2015 – present)
- Ford Transit-150 4 X 4 (2020 – present)
- Ford Transit-250 4 X 4 (2020 – present)
- Ford Transit-350 4 X 4 (2020 – present)
- Ford Transit-350 HD 4 X 4 (2020 – present)
PARTS LIST
| Item | Part # | Discription | QTY |
|---|
A
| 511456| SumoSprings Blue -40|
2
511457| SumoSprings Black -47
511458| SumoSprings Yellow -54
B| 512313| 4″ SumoSpring Plate| 2
C| 512227| 3/8 Flat Washer| 2
D| 512328| M10-1.5 x 55mm Hex Bolt| 2
512319| M10-1.5 x 80mm Hex Bolt| 2
E| 512116| ½” Spacer| 2
F| 512117| 1″ Spacer| 2
DRIVER SIDE (PASSENGER SIDE SIMILAR)
TOOLS REQUIRED
- Floor Jack
- Jack Stands
- Wheel Chocks
- Metric Socket Set
IMPORTANT NOTICE: Your part may have been loosely preassembled to show the new product as it will be once installed on your vehicle. Please disassemble the product before proceeding to the installation.
INSTALLATION
- Park the vehicle on a hard, level surface and engage the emergency brake. Place chocks in front and behind wheels to prevent rolling. Observe all safety precautions and wear safety glasses.
- With the vehicle on the ground, measure the distance from the bottom of the frame to the contact pad on the axle.
- The SSR-121-40/47/54 kits come with several spacers and dierent length bolts to t a variety of vehicle configurations. Aner taking the measurement, determine which combination of spacers will combine for a total height that is ½” to 1″ less than the measurement between the frame and axle. (The 4″ SumoSpring Plate [ITEM B] must always be used directly on top of the Sumospring [ITEM A])
- Raise the rear of the vehicle allowing the axle to hang freely. Support the frame using safety jack stands.
- Starting on the driver’s side, remove the existing factory bump stop by gripping firmly and twisting.
- Remove the bump stop cup.
- Insert appropriate length Hex Bolt [ITEM D] through the Flat Washer [ITEM C], the center of the Sumospring [ITEM A], 4″ SumoSpring Plate [ITEM B], and ½” Spacer [ITEM E] and/or 1″ Spacer [ITEM F] as determined in step 3.
- Apply a drop of Blue Thread Locker to the threads of the bolt and thread it into the same hole in the frame that the factory bump stop was removed from. Tighten the bolt and torque to 20 -lbs.
- Repeat steps 3 through 8 on the passenger side of the vehicle.
- Jack up a vehicle, remove the safety jack stands.
- Carelly lower the vehicle to the hard surface.
- Remove wheel chocks from the front wheels.
- Register the warranty for your SuperSprings International part. A warranty card can be found in the box your part came in.
Part Number: SSR-121-40/47/54 Product Line: SUMOSPRINGS REAR
-
SuperSprings
-
International, Inc.
-
505 Maple Avenue
-
Carpnteria, CA 93013
-
Installation Support +1 800 8980705 support@supersprings.com superspringsint.com
-
SAFETY NOTICE: We recommend installation be done by a professional or persons with sound mechanical knowledge.
-
WARNING: These instructions are a general guide for installation. SuperSprings International, Inc. assumes no liability for the actual installation process. Consumers and installers should apply common automotive safety practices when raising and working on any vehicle. Do not put yourself in a position where, if the vehicle were to move unexpectedly, you may be injured. SuperSprings’ products are designed to improve vehicle ride quality. Do not load any vehicle beyond the manufacturer’s specications.
-
Never exceed the manufacturer’s Gross Vehicle Rating (GVWR) located on your vehicle’s identification tag.
BEFORE INSTALLATION: Ensure the vehicle is on a level surface, the parking brake is ON, with the ignition OFF, and place blocks in front of and behind the front tires to prevent the vehicle from moving.
DURING AND/OR AFTER INSTALLATION: Ensure emergency brake cables are not touching the SuperSprings. Secure any cables out of the way with zip ties or by re-routing. Ensure all A/C lines, brake cables, and frames are clear of contact or interference. -
SCAN HERE: To watch a video of this installation
Documents / Resources
|
SuperSprings INTERNATIONAL SSR-121-40-47-54 SumoSprings Rear for Ford
Transit
[pdf] Instruction Manual
SSR-121-40-47-54 SumoSprings Rear for Ford Transit, SSR-121-40-47-54,
SumoSprings Rear for Ford Transit
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>