ARCCHIO 9967114 Nanna LED Track Spotlight Instruction Manual
- June 12, 2024
- ARCCHIO
Table of Contents
9967114
12W LED / 15W Total
incl. LED Board: L9002441
220-240V ~ 50Hz
Intended use
Provided for indoor use as track spotlight
Safety Precautions
Package contents
1 track spotlight
Installation hardware
Mounting instructions
LED TRACK USER GUIDE
LED TRACK LIGHT
Zoom lens adjustable manually: 15°-60°
IMPORTANT SAFETY INSTRUCTION
When installing or using this track system, basic safety precautions should always be followed, including the following:
- Read all instructions
- Do not cut any track sections.
- For Indoor use only. Do not install this track in damp or wet locations.
- Do not install any part of a track system less than 5 feet above the floor.
- Do not install any luminaire assembly closer than 6 inches from any curtain, or similar combustible material.
- Turn off power before installation or before doing any maintenance work.
- Do not exceed the nominal supply voltage or amperage ratings.
- Do not attempt to energize anything other than lighting track luminaires on the track. To reduce the risk of fire and electric shock, do not attempt to connect power tools, extension cords, appliances, and the like to the track.
- Do not connect a track to more than one branch circuit unless the track is constructed so that it can be used with more than one branch circuit. Check with a qualified electrician. Although the track lighting system may seem to operate acceptably, a dangerous overload of the neutral may occur and result in a risk of fire.
- Wear rubber soled shoes and work on a sturdy wooded or non-conductive ladder.
- Product must be mounted in location and at height in a manner consistent with its intended use, and in compliance with National Electrical Code and local building codes.
- Dimmable version could be compatible with a wide range of recommended TRIAC dimmers.
Select Adaptor Before You Buy The Track Light
Wiring Diagram Of Track
Installation Procedure
WARNING, 1. Switch off before installation. 2. Switch on only after complete installation and examination of the circuit. 3.Professional electrician for installation and maintenance only.
Step 1
Turn Off power supply before starting any installation. Read instructions &
check you have all the tools & accessories to complete the installation
correctly.
Step 2
Prior to locating Adaptor into Track Section make sure it is set in the ‘OFF’
position & ‘Locking Lever’ is set in the position shown.
Step 3
Locate Track Adaptor into Track Section (1) & lock into position by turning
‘Locking Lever’ 90°(2)
Track Installation: CLILING MOUNTED
Below connector of track available, please contact with sales.
Note: Do not install in the place near heat source, or in corrosive gas
environment.
L | Live conductor |
---|
|
Earth conductor
N| Neutral conductor
This product contains a light source of energy efficiency class F
4251911753721
Replaceable (LED only) light source by a professional.
Replaceable control gear by a professional.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>