NEFF N24ZA11G1 Accessory Drawer User Manual

NEFF N24ZA11G1 Accessory Drawer

Product Information

• Product Name: Accessory Drawer
• Model Number: N24ZA11G1
• User Manual and Installation Instructions: Included

Safety

• Risk of suffocation! Keep packaging material away from children.
• Do not let children play with packaging material or small parts.
• The silicone mat is not food-safe. Do not store any food in the accessory drawer or allow food to come into contact with the silicone mat.

Preventing Material Damage

• Excessive weight may damage the appliance.
  • Maximum load capacity: 25 kg.
• Do not use the appliance to store food and drinks as moisture may damage it.
• The silicone mat is not heat-resistant. Do not use it in a warming drawer or oven.

Environmental Protection and Saving Energy

• Dispose of packaging materials separately according to their types for recycling purposes.

Basic Operation

• To open the appliance, press on the panel and pull it out.
• To close the appliance, slide it in until it engages.

Cleaning and Servicing

To keep your appliance working efficiently for a long time, clean and maintain it carefully.

Cleaning Products

• Use suitable cleaning products recommended by the aftersales service or the online shop.
• Avoid using harsh or abrasive detergents, high alcohol content cleaning products, hard scouring pads, or cleaning sponges.
• Only use glass cleaners, glass scrapers, or stainless steel care products if recommended in the cleaning instructions for the relevant part.
• Thoroughly wash sponge cloths before use.

Cleaning the Appliance

1. Remove the silicone mat.
2. Clean the appliance and silicone mat with a damp cloth and neutral cleaning agents (e.g., washing-up liquid and water).
3. Dry with a soft cloth.
4. Place the silicone mat into the dried appliance.

Cleaning the Stainless Steel Surfaces

1. Always remove limescale, grease, starch, or albumin stains immediately to prevent corrosion.For further assistance, contact Customer Service.

Restriction on user group
This appliance may be used by children aged 8 or over and by people who have reduced physical, sensory or mental abilities or inadequate experience and/or knowledge, provided that they are supervised or have been instructed on how to use the appliance safely and have understood the resulting dangers. Do not let children play with the appliance. Children must not perform cleaning or user maintenance unless they are at least 15 years old and are being supervised. Keep children under the age of 8 years away from the appliance and power cable.

Safe use

WARNING ‒ Risk of suffocation! Children may put packaging material over their heads or wrap themselves up in it and suffocate.

• Keep packaging material away from children.
• Do not let children play with packaging material.
• Children may breathe in or swallow small parts, causing them to suffocate.
• Keep small parts away from children.
• Do not let children play with small parts.

WARNING ‒ Risk of harm to health!
The silicone mat is not food-safe.

• Do not store any food in the accessory drawer.
• Do not allow food to come into contact with the silicone mat.

Preventing material damage

ATTENTION! Excessive weight may damage the appliance.

• The appliance has a maximum load capacity of 25 kg. Moisture may damage the appliance.
• Do not use the appliance to store food and drinks. The humidity of the food may cause corrosion damage. The silicone mat is not heat-resistant.
• Do not use the silicone mat in a warming drawer or in an oven.

Environmental protection and saving energy

Disposing of packaging
The packaging materials are environmentally compatible and can be recycled.

• Sort the individual components by type and dispose of them separately.

Basic operation

Opening the appliance

• Press on the appliance’s panel.
• The appliance opens and can be pulled out.

Closing the appliance

• Slide the appliance in until it engages.

Cleaning and servicing

Cleaning Products

To keep your appliance working efficiently for a long time, it is important to clean and maintain it carefully.

Cleaning products

You can obtain suitable cleaning products from aftersales service or the online shop.
ATTENTION! Unsuitable cleaning products may damage the surfaces of the appliance.

• Do not use harsh or abrasive detergents.
• Do not use cleaning products with a high alcohol content.
• Do not use hard scouring pads or cleaning sponges.
• Only use glass cleaners, glass scrapers or stainless steel care products if recommended in the cleaning instructions for the relevant part.
• Wash sponge cloths thoroughly before use.

Cleaning the appliance
ATTENTION! Heat may damage the silicone mat. Do not clean the silicone mat in the dishwasher.

1. Remove the silicone mat.
2. Clean the appliance and silicone mat with a damp cloth and neutral cleaning agents, such as washing-up liquid and water.
3. Dry with a soft cloth.
4. Place the silicone mat into the dried appliance.

Cleaning the stainless steel surfaces

1. Always remove limescale, grease, starch or albumin stains immediately. Corrosion may form under such stains.
2. Clean with water and some washing-up liquid.
3. Dry with a soft cloth.

Cleaning the glass front

• Clean the glass front using a glass cleaning product and a soft cloth.
• Do not use any abrasive sponges that may scratch or any glass scrapers.

Customer Service

• Function-relevant genuine spare parts according to the corresponding Ecodesign Order can be obtained from
• Customer Service for a period of at least 10 years from the date on which your appliance was placed on the market within the European Economic Area.
  • Note : Under the terms of the manufacturer’s warranty the use of Customer Service is free of charge.
• Detailed information on the warranty period and terms of warranty in your country is available from our aftersales service, your retailer or on our website.
• If you contact Customer Service, you will require the product number (E-Nr.) and the production number (FD) of your appliance.

The contact details for Customer Service can be found in the enclosed Customer Service directory or on our website.
Product number (E-Nr.) and production number (FD)
You can find the product number (E-Nr.) and the production number (FD) on the appliance’s rating plate. Make a note of your appliance’s details and the Customer Service telephone number to find them again quickly.

Installation instructions

Observe this information when installing the appliance.

Scope of delivery
After unpacking all parts, check for any transport damage and for completeness of delivery

Appliance dimensions
You will find the dimensions of the appliance here

Installation in the cabinet
You will find the dimensions of the appliance here

Safe installation

Follow these safety instructions when installing the appliance.
WARNING ‒ Risk of suffocation! Children may put packaging material over their heads or wrap themselves up in it and suffocate.

• Keep packaging material away from children.
• Do not let children play with packaging material.
  • WARNING ‒ Risk of injury! Sharp-edged parts may be accessible during installation.
• Wear protective gloves.

Installation

Fitted units
This is where you can find information about safe installation.
ATTENTION! When the door is opened, the appliance may tip over.

• Above the appliance, provide a fixed intermediate floor in the fitted unit.
• When combined with an oven, provide a fixed intermediate floor above the oven.
• If no intermediate floor is possible above the appliance or above the oven, install tilt protection for the appliance → Page 5. Suitable tilt protection can be obtained from customer service, on our website or in the online shop.

Combining with other appliances
You can combine the accessory drawer with a maximum of one more appliance from the same appliance series. No intermediate floor is required between the appliances. When installing appliances under an oven, combisteam oven or steam oven, no tilt protection is required. When installing under the fully automatic coffee machine, install the tilt protection for the fully automatic coffee machine. For the following combinations, install tilt protection on the accessory drawer:

• Accessory drawer separately, including when installing below an intermediate floor
• Accessory drawer under microwave
• Accessory drawer under hob
• Accessory drawer with accessory drawer, at least on the upper appliance
• Accessory drawer with warming drawer, at least on the upper appliance
• Accessory drawer with vacuum-sealing drawer, at least on the upper appliance Suitable tilt protection can be obtained from customer service, on our website or in the online shop. → “Fitting tilt protection”, Page 5

Fitting tilt protection
Suitable tilt protection (order number: 12039458) can be obtained from customer service, on our website or in the online shop.

1. Measure a clearance of 518 mm from the front edge of the unit and mark it on both sides in the fitted unit.
2. Screw the two brackets into the elongated hole on the mark.
3. Place the appliance on a flat surface.
4. Unscrew the two lower screws on the back of the appliance.
5. Use the two screws to tighten the two metal retainers on the back of the appliance.
   • Ensure that the metal retainers are aligned exactly with the edge of the appliance.
6. Slide the appliance into the fitted unit and check whether the tilt protection engages.
7. If required, correct the position of the bracket with the elongated hole.
8. Finally, screw the brackets to the fitted unit.
9. Push the appliance into the fitted unit.
10. Remove the adhesive strip from the appliance front.
11. Open the appliance carefully and check whether the tilt protection is working.

Inserting the design profiles

1. Fold together the fastening elements.

2. Hook the fastening elements into the openings at the bottom and push down until they engage.
   Insert the red fastening elements into the upper opening. Insert the green fastening elements into the lower opening.

3. Remove the protective film from the design profiles.

4. Insert the design profiles on both sides of the appliance.

5. Check the clearances of the design profiles.

Adjusting design profiles

WARNING ‒ Risk of injury! Parts that are accessible during installation may have sharp edges and may lead to cutting injuries.

• Wear protective gloves.

ATTENTION! Unsuitable tools may damage the surface of the appliance.
Only use plastic tools. Do not use pointed or sharp tools.

1. Pull the design profiles forwards to remove them. If necessary, carefully loosen and remove the design profiles using a plastic tool.
2. Adjust the fastening elements and re-attach the design profiles.

Installing the appliance

1. Push the appliance all the way into the fitted unit.
2. Centre the appliance.
3. Remove the adhesive strip from the appliance front.
4. Open the appliance.
5. Screw the appliance to the fitted unit.

Adjusting the appliance front
Adjust the appliance front upwards or downwards if necessary.

1. Open the appliance.
2. Undo the screws on the side of the panel.
3. Align the appliance front upwards or downwards.Alignments of maximum -3 to +3 mm are possible.
4. Tighten the screws.

Combining the accessory drawer with another appliance
ATTENTION! Sharp edges on the appliance may damage the panel of the accessory drawer. Do not damage the accessory drawer cover when sliding the appliance in.

1. Only combine suitable appliances of the same brand and series.
2. First fit the accessory drawer.
3. Slide the appliance onto the accessory drawer into the built-in cabinet.
4. Observe the installation instructions for the appliance.

CONTACT

Valid within Great Britain:

• Imported to Great Britain by
• BSH Home Appliances Ltd.
• Grand Union House
• Old Wolverton Road
• Wolverton, Milton Keynes
• MK12 5PT
• United Kingdom

Register your product online Neff-home.com. BSH Hausgeräte GmbH
Carl-Wery-Straße 34 81739 München, GERMANY

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>