aparian A-TSM Time Sync Module User Guide
- June 12, 2024
- aparian
Table of Contents
**aparian A-TSM Time Sync Module User Guide
**
NOTE: Before installing, configuring, operating, or maintaining Aparian products, please review this information and the information located on www.aparian.com for the latest software, documentation, and installation files specific to your Aparian product
INTRODUCTION
This quick start guide provides an basic overview of the installation, operation, and diagnostics of the Aparian Time Sync module. The Time Sync module provides high accuracy time synchronization across traditional Ethernet networks using 1588 Precision Time Protocol (PTP) as well as Network Time Protocol (NTP). The module is also capable of writing time information directly to Allen-Bradley MicroLogix, SLC500 and PLC5 devices, as well as any Modbus-TCP slave device. The Time Sync module can also operate as a Modbus TCP slave where a Modbus TCP Master can read the relevant time data from the Time Sync module. The Time Sync module also provides GPS position and velocity data using the on-board GPS receiver. The Time Sync module is a stand-alone device allowing it to serve a wide variety of platforms.
REQUIRED SOFTWARE
The Time Sync module requires Aparian Slate software to setup and configure. The software installation can be found at www.aparian.com/software/slate
MODULE INSTALLATION
The module has three ports at the bottom of the enclosure as shown in the figure below. The ports are used for Ethernet, GPS antenna and power. The power port uses a three way connector which is used for the DC power supply and the earth connection.
The GPS antenna connector provides connection to the provided GPS antenna.
NOTE: The module is supplied with a GPS antenna. Various other GPS antennas can be used Care must be taken to ensure they comply with the receiver antenna specifications.
LED | Description |
---|---|
Module | The module LED will provide information regarding the system-level |
operation of the module. Thus, if the LED is red then the module is not
operating correctly. For example, if the module application firmware has been
corrupted or there is a hardware fault the module will have a red Module LED.
If the LED is green then the module has booted and is running correctly.
PPS| The PPS LED is the pulse per second provided by the GPS receiver. When
the LED is green the module has obtained an Autonomous or Differential fix
based on a sufficient number of satellites. When red, it indicates the module
is still trying to obtain a GNSS fix.
Ethernet| The Ethernet LED will light up when an Ethernet link has been
detected (by plugging in a connected Ethernet cable). The LED will flash every
time traffic was detected.
ELECTRICAL AND ENVIRONMENTAL
NETWORK SETUP
- Launch the Aparian Slate Configuration Software. Select the DHCP Server under the Tools menu. DHCP is enabled as factory default.
- Click the Assign button and set the IP Address. Row turns green if successful.
- Additional configuration can be set using the Target Browser also under the Tools menu. Right click on the module in the Target Browser a select Port Configuration.
STUDIO 5000 CONFIGURATION
The module must be added to the Logix IO tree using the Generic Module profile.
NORTH AMERICAN HAZARDOUS LOCATION APPROVAL
SUITABLE FOR USE IN CLASS I, DIVISION 2, GROUPS A, B, C AND D HAZARDOUS LOCATIONS, OR NONHAZARDOUS LOCATIONS ONLY.
WARNING – EXPLOSION HAZARD – DO NOT DISCONNECT EQUIPMENT WHILE THE
CIRCUIT IS LIVE OR
UNLESS THE AREA IS KNOW TO BE FREE OF IGNITABLE CONCENTRATIONS.
WARNING – EXPLOSION HAZARD – SUBSTITUTION OF ANY COMPONENT MAY IMPAIR SUITABILITY FOR CLASS I, DIVISION 2.
For professional users in the European Union
If you wish to discard electrical and electronic equipment (EEE), please
contact your dealer or supplier for further information.
WARNING – Cancer and reproductive harm – www.p65warnings.ca.gov
ADDITIONAL INFORMATION
The following resources contain additional information that can assist the user with the module installation and operation.
Resource | Link |
---|---|
Slate Installation | http://www.aparian.com/software/slate |
Time Sync User Manual Time Sync Datasheet Example Code & UDTs |
http://www.aparian.com/products/timesync
Ethernet wiring standard|
www.cisco.com/c/en/us/td/docs/video/cds/cde/cde205_220_420/installation/guide/cde205_220_420_hig/Connectors.html
GPS information| https://www.ublox.com/images/stories/the_gps_dictionary.pdf
1588 Precision Time Protocol (PTP)| http://www.ieee1588.com/
SUPPORT
Technical support will be provided via the Web (in the form of user manuals, FAQ, datasheets etc.) to assist with installation, operation, and diagnostics.
For additional support the user can use either of the following:
Contact Us web link: https://www.prosofttechnology.com/ServicesSupport
/Customer-Support
Support email: support@prosoft-technology.com
References
- technology.com
- Industrial Automation Devices Supplier - Aparian
- 1588 PTP / NTP Time Sync Module with Modbus
- EtherNet/IP Scanner - Ethernet Port Configuration - Aparian
- Ieee1588.com is for sale | HugeDomains
- p65warnings.ca.gov
- p65warnings.ca.gov/
- Regional Technical Support / Services & Support / Homepage - ProSoft Technology, Inc.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>