HERTZ HM CAM C01 Wired Camera User Guide
- June 12, 2024
- HERTZ
Table of Contents
HERTZ HM CAM C01 Wired Camera
Product Information
- Product Name: Camera
- Cable Length: 1.5 meters
- Mounting Bracket: Included
- Extension Cable: 10 meters (393.7 inches)
- Fixing Screws: 2 included
- Cushion Tape: Included
- Model Number: HM CAM C01
- Power Supply: DC 12V ~ 24V
- Max Power Consumption: 2W
- Camera Sensor Type: Wired camera
- Angle of View: 23 degrees
- Night Sight Distance: 4 meters ~ 10 meters
- Minimum Illumination: 0.1 Lux
- IP Rating: IP67
- Operating Temperature: Not specified
- Video Compression: Not specified
- Resolution: 720p (1280×720 pixels)
- Frame Rate: 30 fps
- Effective Pixels: 0.92 megapixel
- Size (mm/in.): 23 x 23 x 33 / 0.03 x 0.03 x 1.29
- Weight (Kg/Lbs): 0.086 / 0.189 (including the cable)
Product Usage Instructions
- Before starting the installation, make sure to read the instructions carefully.
- Ensure that the negative terminal of the battery is disconnected before starting the installation to avoid short circuits.
- To install the camera, use the included mounting bracket and fix it securely using the provided fixing screws.
- If needed, use the included cushion tape for additional support or to reduce vibrations.
- If you prefer vertical mounting, turn on the bracket accordingly before installation.
- Do not install the camera near the engine compartment to avoid interference.
- Ensure proper wire connections before turning on the unit to prevent any damage.
- For detailed installation instructions or if you require additional accessories, consult with your nearest dealer.
Packaging contents
Dimensions
SIZE
| A| B| C|
HM CAM C01| 23| 23| 33| mm
0.3| 0.3| 1.29| in.
Installation
Mounting
OPTION 1 – Horizontal mounting
OPTION 2 – Vertical mounting
Technical Specifications
| Power supply | DC 12V ~ 24V |
|---|---|
| Max power consumption | 2 W |
| Camera sensor type | CMOS |
| Angle of view (Deg.) | 90° Vertical, 120º Horizontal |
| Night sight distance | 4 m ~ 10 m |
| Minimum illumination | 0.1 Lux |
| IP rating | IP67 |
| Operating temp. | -10ºC ~ +75ºC ( 14ºF ~ +167ºF) |
| Video compression | H.264 |
| Resolution | 720p (1280x720pixel) |
| Frame rate | 30 fps |
| Effective pixels | 0,92 megapixel |
| Size (mm/in.) | 23 x 23 x 33 / 0.03 x 0.03 x 1.29 |
| Weight (Kg/Lbs) | 0,086 / 0.189 (including the cable) |
BASIC OPERATION
WARNING: when the unit is turned on, starting and stopping the engine with its volume raised to the maximum level may cause hearing damage. Make sure you adjust the volume in advance.
Power On/Off
Note:
-
Start the engine before using this unit.
-
Be careful about using this unit for a long time without running the engine.
-
If you drain the vessel battery, you may not be able to start the engine and this can reduce the service life of the battery.
-
Start the engine.
Engine ON position -
Press to turn the unit ON.
-
INSTALLATION
BEFORE STARTING
- This device is exclusively for use in vessels with a negative ground 12 V / 24 V power supply.
- Read these instructions carefully.
- Make sure the battery “-” terminal is disconnected before starting.
This is to prevent short circuits during installation. (Figure 1)
INSTALLATION CAUTIONS
- In order to avoid any interference, do not install the unit in the proximity of the engine compartment.
- The use of unauthorized parts can cause permanent damage to the unit.
- Always check your wire connections to ensure proper installation before turning the unit on.
- Consult with your nearest dealer for proper installation or if other accessories are needed to complete the installation.
- Seek assistance if modifications or drilling holes to your vessel is needed.
- Do not install the unit where it will be subjected to excessive moisture, dust, dirt, foreign particles or vibration. Areas of high temperature from the engine, direct sunlight, or heat sources should also be avoided.
- Do not install the unit in a location where it will interfere with the vessel operation, or it will injure the passengers if there is a sudden or emergency stop.
Information on electrical and electronic equipment waste (for those
European countries which organize the separate collection of waste)
Products which are marked with a wheeled bin with an X through it can not be
disposed of together with ordinary domestic waste. These electrical and
electronic products must be recycled in proper facilities, capable of managing
the disposal of these products and components. In order to know where and how
to deliver these products to the nearest recycling/disposal site please
contact your local municipal office. Recycling and disposing of waste in a
proper way contributes to the protection of the environment and to prevent
harmful effects on health.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>