AUDIO SYSTEM R200-FL 20 cm EVO2 FREE AIR User Manual
- June 4, 2024
- AUDIO SYSTEM
Table of Contents
AUDIO SYSTEM R200-FL 20 cm EVO2 FREE AIR
Thank You
Congratulations on purchasing a high-quality
AUDIO SYSTEM product incl. GERMAN SOUND.
Important: Completely read this operating instruction before installation
and use of the device.
Attention: Pay attention to advice and instructions of the car
manufacturer. Check the polarity when connecting the speakers.
Important: You will need your purchase receipt as proof of purchase for
all warranty repairs and for insurance purposes. Keep your receipt, owner´s
manual and packing materials in a safe location for possible future use.
Attention: Use of sound components can impair your ability to hear necessary
traffic sounds and may constitute a hazard while driving your automobile.
AUDIO SYSTEM GERMANY accepts no liability for hearing loss, bodily injury or
property damage as a result of use or misuse of our products. We recommend
installing the equipment by an authorized service center or dealer. A
professional fitting and connection is the requirement for further warranty
and perfect sound.
Crossover FWR EVO2
Important: The speaker system can be adapted to the acoustics of the vehicle, the genre of music and to the personal taste via the crossover. Depending on the position of the speakers, the switch can be adjusted so that the frequency response is optimized with these geometric conditions. Depending on the installation location of the tweeter, it is necessary to adjust the frequency response tonal and volume technology, e.g., when mounting the tweeter in the A-pillar, in the mirror triangle or in the door trim.
USER MANUAL
Attention: The crossover is supplied with a default setting. If some speakers do not work or work too much softly as bad sounding, the crossover must be adjusted again to the basic settings in order to clarify if mistakes on crossover setting is the real defect reason or not. Thus, you can avoid that you or the dealer must check the speaker unnecessarily.
Default Setting Crossover FWR EVO2
IMPORTANT: The crossover is supplied with a default setting. If some speakers do not work or work too much softly as bad sounding, the crossover must be adjusted again to the basic settings in order to clarify if mistakes on crossover setting is the real defect reason or not. Thus, you can avoid that you or the dealer have to check the speaker unnecessarily.
HIGH FREQUENCY LEVEL (SECTION A)
| -3dB | -6dB | Resultant | dB | RESULT |
|---|---|---|---|---|
| – | – | etnas later | 0 dB | slightly higher |
| JUMPER | – | Grande install ng | -3,0 dB | basic setting |
| – | JUMPER | etnas leaser | – 6,0 |
dB
| a little softer
JUMPER| JUMPER| notch leaser| – 9,0
dB
| more soft
- Section B Jumper
- Result 12 dB(Basic) 6 dB
Mechanical Installation Tip
Warning: First disconnect negative pole of your car battery. Check-polarity,
changing polarity may cause serious damage to your car electric. Best speaker
positions are the original build in positions. Easy installation and original
look are the reasons. Please note that the speakers are installed flat and
stable. The quality of the installation decides the sound very much,
therefore, attention should be paid to insulation and care during
installation. Please note that the speakers are protected from heat, sunlight,
mechanical influences, moisture and wetness by accessories from AUDIO SYSTEM.
Attention: Install all cables as straight as possible without squashing or
laying them over sharp edges. Otherwise, this can cause short circuit or
damages to your whole installation. Attention: Be careful removing original
plastic parts of your car. The fitting parts could be damaged and must be
replaced. Important: The right polarity of all speakers is extremely important
for the sound of your car audio system. We recommend changing polarity of the
tweeter finding out the best possible sound. The best is to listen and/or to
measure it.
Optional Mounting Accessories
- ALUBUTYL 1500, 2000 EVO, 3000 EVO und 4000, ALU 200 EVO Self Adhesive Damping Material
- Damping: DOORKIT 1.0 and DOORKIT 2.0
- Z-(T)SC 0.75, 1.5, 2.5, 4.0 Oxygen-Free Speaker Cable
- Recommended amplifiers: CARBON-130.2, CO-100.2, X- 150.2 D or M-100.2 MD
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>